Question about Motorcycles

1 Answer

Ts410runs with choke turn choke off cuts out - Motorcycles

Posted by on


1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert who has answered 20 questions.


    An expert that hasĀ over 10 points.


    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 21 Answers

A common problem is clogged jets in your carburetor. Choke bypasses the jets. Clogging due to old fuel happens much faster when there is ethanol in the fuel. Solution: Disassemble and clean out the carbs. If you're lucky you can try putting some sea foam (available at Walmart or auto store) and run it through the engine to unclog the carburetor without disassembley.

Posted on Oct 21, 2013


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Will only run on full choke

This is a fuel supply issue. Don't use the saw until you find the problem.
Things to check are:
fuel filter, fuel line crack, impulse line, carb needs work, air leak to engine. Etc.

May 20, 2017 | Stihl Garden

2 Answers

Wont stay running

You should only use choke until you get a turn over. After that, turn off choke and it should start right up.

Apr 30, 2016 | Garden

1 Answer

Have a beach buggy that needs the choke to run. When motor is hot after start up and the choke is set to be in normal the motor cuts out and if you ridding and set the choke to normal the motor cuts out

Have you changed the intake filter or pipes in any way, too much air could be drawn into engine, check ports, jets and float valve, adjust mixture screw to 4 turns out then adjust by ear half turns either way, check fuel pump return.

Jan 11, 2015 | Water Filters & Coolers

1 Answer

Sthil ts410runs with choke turn choke off cuts out

carb is clogged up (use carb cleaner or dissasemble and clean) or fuel filter inside tank is dirty

Oct 20, 2013 | Motorcycles

1 Answer

Wheres the choke on a 49cc pocket rocket

The choke is on the carb. Check if the carb set screw is set right, turn it all the way in and then back out 1 1/4 turns. then fine tune by 1/4 turn increments.

Feb 02, 2012 | Quad 47 cc / 49 cc Pocket Mini Bike...

1 Answer

Cant get it ilde other than when choke is onwhen i cut the choke off bike goes dead and it idles high when choke on

If you have a choke and not an enricher then you have an air intake problem meaning a choke shuts air can pull the carb. and clean making sure all passages are open and clean if that does not do the trick slowly turn your air/fuel miwture screw in alittle at a time until she idles

Jun 23, 2010 | Motorcycles

1 Answer

Kawasaki Ninja 250 running problem

This could be due to timing screw being incorrectly set
Locate gold timing screw on the carbrettta turn it clockwise only slightly till bike idles without choke on, Then when choke it on it should idle a touch higher.

Jun 21, 2010 | 2008 kawasaki Ninja 250R

1 Answer

Grass trimmer cuts out unless choke is open


Mar 14, 2009 | Garden

1 Answer

97 cbr f3 choke and starting out problems

Hi, The mixture is too rich. Was the bike sitting for awhile? The carbs should be cleaned and adjusted. Good Luck!

Feb 19, 2009 | 1998 Honda CBR 600 F(3)W

2 Answers

Engine cutting out with the choke off

Adjust your idle screw on your carb so that it gets more gas just sitting there at idle. Tighten the screw one and a quarter turn and then start the bike. Adjust the idle to where you think it sounds normal. If that doesnt work check your float in your float bowl, it might be stuck in the down position. Clean with some carb cleaner spray and make sure it moves freely before putting the float bowl back on, youll have to choke it or prime the carb again to get it started. All the choke does is let in more gas and oxegen so you might want to check how far the carbs close when you push the choke back in. Is it impeading any normal carb setting. Check that too. Good luck.

Dec 01, 2008 | 2004 Yamaha YZ 450 F

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

144 people viewed this question

Ask a Question

Usually answered in minutes!

Top Motorcycles Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4521 Answers


Level 3 Expert

76070 Answers


Level 3 Expert

102366 Answers

Are you a Motorcycle Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides