Question about Suzuki Motorcycles

1 Answer

I have a 05 gxsr-750 that starts but, head lights, turn signal, and center panel won't turn on what could be going on. everything in the rear works fine.

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 5 achievements.


    An expert who has written 20 answers of more than 400 characters.


    An expert who has answered 20 questions.

  • Expert
  • 113 Answers

Check the fuses
also go inside the fairing
un plug the wiring connection blocks
and clean them up
then plug them back together
basically needs a bit of tlc and a clean up

Posted on Oct 19, 2013

6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 261 Answers

SOURCE: Rear right turn signal acts as a running light.

Make sure and replace the lamp with the exact same one as the working side. Sounds like their is a mismatch in the lamps of some sort.
If one of the filliments is burnt out this will happen. Just like in car blinkers. Or it will blink fast. Hope this helps.. Happy Holidays. Jay

Posted on Dec 08, 2008

  • 1 Answer

SOURCE: 05 katana new bat new starter new relay still

check these things: is the engine run/stop switch pressed? is the bike in gear? is your safety switch always depressed?

Posted on Apr 21, 2009

  • 109 Answers

SOURCE: 90 gxsr 750 hard to start cold

POSSIBLE solution: Low voltage DC electricity is a real pip. Could be many things. Try taking out the spark plugs and see if you still have the same problems. With no compression, it should spin over like crazy. No?? Try cleaning ALL contacts that you can find. Battery terminals and ground screws and the starter solenoid all get fine layers of corrosion under them just from oxidation caused be humidity in the air and the mini arcing caused by the DC current transfer. If none of that helps, it could be the starter itself or as you mentioned, the battery could be going bad. Any decent auto supply store will load test your battery for free. So will Batteries Plus but they are expensive to purchase from. Just a voltage measurement is not enough as it is the cranking amps that give a battery it's low end torque or "push" to overcome the compression of the engine and turn it over.

Posted on Jun 08, 2009

  • 867 Answers

SOURCE: 92 FXR bike will not start or even turn over

that clicking sound is the starter solenoid. check all large cables for corrosion and tightness. as for the signal lights, neutral and horn, i think a wire is grounding , thus causing the problem with the bike not starting also. check at ignition switch and at handle controls for a loose wire that may be touching the handlebar. basically inspect all the wiring on the bike

Posted on Aug 08, 2009

  • 89 Answers

SOURCE: I have 1997 Harley Lowrider. Left turn signal

sounds like the bulb in the rear one has blown and needs replacing.

Posted on Aug 17, 2009

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

I have a 1990 Suzuki Gxsr 750 I turn the key on and lights come on when I try to hit the start button it does nothing rode to gas station and back morning n when I got off work later it did not start.

Hi, William and the usual suspects are:
1. Ignition Switch not in the "ON" position.
2. Engine Run Switch in the "OFF" position.
3. Discharged battery, needs to be 12.5 volts or better and be able to pass a load test if necessary, check battery terminals for damage or corrosion, check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter if necessary.
4. Bank angle sensor tripped and ignition/light key switch not cycled to the "OFF" position and then back to the "ON" position.
5. Faulty ignition switch.
6. Faulty starter button.
7. Faulty kickstand or clutch pull in switch/sensor.
8. Security alarm needs a reset.
9. Starter control circuit, relay, or solenoid faulty.
10. Main fuse or circuit breaker may be blown or faulty.
11. Electric starter shaft pinion gear is not engaging or over-running starter clutch slipping.
For more information about your issue and valuable "FREE" downloads that you will need please click on the links below. Good luck and have nice a day.
1990 1100 bike does not turn over
2001 GSXR 750 wont turn over ve tried almost everything
2003 Suzuki Katana 600 won start
Suzuki GSX R750 Service Manual

Jul 13, 2016 | Suzuki Motorcycles

1 Answer

I have a 1993 gsxr 750 and i clean the carburator put everything back and i started the bike suddenly it died i kept cranking it and nothing i don't have any spark at all none of my light turn on now the...


Oct 19, 2013 | 1991 Suzuki GSX-R 750 M

1 Answer

Hyundai Sonata 2004 turn signal does not work properly

did you check the directional switch. sounds like you have a bad one

Nov 07, 2012 | Hyundai Sonata Cars & Trucks

1 Answer

I have a 96 gxsr 750,my problem is 30minutes n2 my ride my bike reaches 245 and then coolent boils out,what could possibly b the problem?

bad thermostat, week or bad water pump, clogged radiator . If you've over heated it , its possible you could have also blown a head gasket . Check to see if you have coolant in the oil. Or do a compression check. If all turns out good, i would replace the thermostat just because you have over heated it, and go from there..

Jun 15, 2012 | 1996 Suzuki GSX-R 750 T

1 Answer

My turn signals do not work. I have power from my flasher relay to my turn signal switch. At the switch there are 3 wires I assume one is direct power from the battery and the other two are for each...

Hi, Jdbutler03 before diagnosing any turn signal/running light/parking light issue make sure the bulb is good and the light fuse has continuity with a test light. If you have replaced you OEM lights with LED lights you are going to need a load equalizer. If no turn signals work the cause could be a faulty turn signal module or the connector going to it, look for corroded, loose, or broken pins/sockets. Contact spray cleaner is great for removing corrosion. If your speedometer does not function properly it will have to be fixed first because your turn signal module gets the data from the speedometer for normal turn signal function. If your front turn signals don't work use a test light to check for power and ground at the bulb socket, then start backtracking the wiring through every wire connector to the turn signal switch/button and check for continuity, go all the way back to the fuse if necessary to find the cause of the malfunction. If your rear turn signals don't work check your rear fender wiring harness connector first for corroded, broken, loose pins/sockets, power, and a good ground, (the harness connector is usually located under the seat on the front of the rear fender) then keep tracing the wiring look for obvious harness damage caused by the rear tire. If you still can't find the malfunction backtrack from the rear fender wiring harness connector. If one side does not work you could have a faulty turn signal switch or module check for continuity.
For more information about your issue and valuable "FREE" downloads that you will need please click on the blue links below. Good luck and have a wonderful day.
Turn signals arent working
turn signal problem
Kawasaki VN 750 Service Manual
OEM Parts for Kawasaki
1994 Kawasaki Vulcan 750 Owner Manual

Apr 22, 2017 | 1992 kawasaki VN 750 Vulcan

1 Answer

Headlight and tail lights don't work

maby you accedentaly pulled the main lamp ground out

Jun 01, 2010 | Harley Davidson FXDWG Dyna Wide Glide...

1 Answer

92 gxsr 750 headlight fuse melts untill it pops and the hi beam indicatoris on when low beam is on

this could just be a bad earth inside the head light when on high beam it earths out through the indecator and this pops the fuse as its pulling to many amps lighting the indecator as well! check all earth joints and use petroleum jelly on all joints when there is only 12 volts it dont take much of a dirty joint to stop it from working

Jan 12, 2010 | 1990 Suzuki GSX-R 750 L

1 Answer

05 katana new bat new starter new relay still won,t start when I push the srart button when i push the starter button head light goes dim.

check these things: is the engine run/stop switch pressed? is the bike in gear? is your safety switch always depressed?

Apr 05, 2009 | 2006 Suzuki GSX 750 F (Katana)

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

63 people viewed this question

Ask a Question

Usually answered in minutes!

Top Suzuki Experts


Level 3 Expert

75822 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

Ed Nelson
Ed Nelson

Level 2 Expert

149 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides