Question about Motorcycles

Open Question

Oil Recommended what oil do I use for a Nissan gl650 generator

Posted by Anonymous on

Ad

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 921 Answers

SOURCE: recommended drain intervals for oil

it usually depends on where you ride and how far you go..if you only use it for short trips, and live in the desert, i would change it every 6000 miles but its more important to worry about non-usage...if you only ride it occasionally, and only go about 30 miles a week then i would change it every couple of months and don't go by mileage, because combustion gases will form in the oil and create acids..so i personally never go by mileage, i go by how many bottles of oil i"ve added to the engine since i serviced it last..i say by the third bottle its time to change the oil and filter, but if im racing my bike proffessionally, its always before and after a race, and dont have anyone tell you that that is still too sone because the same oil that lubes the top half of the engine is the same oil that lubes the gears, and if you ever noticed that when your bike starts to mis shift and you grind the gears...when you put in fresh oil, it'll shift a lot easier. So to answer your question, whenever you have to ask yourself you probably need to have it changed.

Posted on May 14, 2010

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Recommended engine oil for 2004 nissan pulsar 180000 klms


quality brand 20w-40 engine oil
you can use semi synthetic or full synthetic but as the oil should be changed every 10,000miles , it is not the cost of the synthetic oil
remember that the viscosity of the oil will depend on the ambient temp in your operating area so read your owners manual or talk with accredited service centers to help you decide

May 08, 2017 | Nissan Cars & Trucks

2 Answers

What's the best oil for Honda em 400 power generator?


S.A.E grade 10w-30 multi grade oil its recommended from 60F and up.
For temp lower than 60F use the 20W oil

if its a new Gen(first operation). replace oil after 20Hr.

Other than that in normal working environment replace oil evry after 100Hr.

Dusty area shorten the time of replacing oil and cleaning air filter.

remember not replace hot oil or if the Gen runing !!

Mar 18, 2016 | Honda Electrical Supplies

1 Answer

97 nissan pick up 215,000 miles. Should I add Lucas oil treatment every so often? What blend of oil should I use?


No oil treatment is needed or recommended for use in an engine. The present day engine oils are formulated with various modifiers to provide proper lubrication, viscosity and cleaning to your engines internal parts. Using ANY additive could upset the formulations by adding chemicals which aren't compatible with the oil you are using. It's much better to just select a good oil and stick with it.

Also here is a site , which will tell you , depending on where you live , what oil is recommended for a Nissan Pickup .
http://www.synthetic-motor-oil-change-and-filters.com/recommended-oil/NISSAN/1997/PICKUP/2.4L/KA24E/
I myself have been using Pennzoil in my truck for 7 years and I change the oil every 3750 miles . If you do not want to follow my advice , bring your Nissan truck to a dealer and ask them . The oil most dealers use is oil that comes in a 55 gallon barrel and is used in all vehicles .
Good luck

Jul 14, 2014 | 1997 Nissan Pickup

1 Answer

What type of oil and how much do I use with the honeywell 1000w generator?


Engine Oil Recommendations

Use 4-stroke oil, or equivalent high detergent, premium

quality motor oil certified to meet or exceed U.S. automobile

manufacturer's requirements for API Performance

Class SF or better. SAE 15W-40 is recommended for general,
all-temperature use.

NOTICE

Engine oil is a major factor affecting engine performance

and service life. Non-detergent and 2-stroke engine oils will

damage engine and are not recommended.

• Be sure to use engine oils specified under "Engine Oil

Recommendations."

It is very important to maintain proper level of engine oil to

keep engine in good running condition.

• Check engine oil level prior to each use. Refill engine

oil if oil level is low.

FIGURE 17: Recommended Oil Viscosity

Crankcase pressure can cause hot engine oil to

spray out of engine fill hole. Hot engine oil can

cause severe burns.

• ALWAYS stop engine before removing the oil fill cap.

15W-40

WARNING

FIGURE 18: Oil Fill Cap Removal

FIGURE 19: Oil Fill Measurement

Oil Capacity [qt / ml]

HW1000i 0.26 / 250

HW2000i 0.48 / 450
TABLE 4. Engine Oil Capacity

Mar 08, 2011 | Garden

1 Answer

What is the best synthetic oil for the engine of my 2008 nissan altima 2.5 SL? what will be the oil capacity and the good oil filter?


wix filters are one of the best made and believe me there is a huge difference inside of how well they filter dirt. as far as oil 5w-30 mobile 1 synthetic is recommended but not required. unless ur drag racing it u can use any 5w-30 conventional oil

Dec 28, 2010 | 2008 Nissan Altima

1 Answer

Whats th best oil to use in my gas welder


use a multi-viscosity sae sj grade or better oil. recommended motor oil is 10w-30. if you work in cold environments use a 5w-30 oil . it's thinner and will flow easier during cold starts. synthetic oil is better, just more expensive. do regular oil changes at least every one hundred hours. good luck!

Oct 28, 2010 | Lincoln Electric Ranger Gxt 250 Amp...

2 Answers

What type of motor oil should i use?


A stock 2000 Maxima engine is non-turbo and 5W30 oil is recommended by nissan. As the mileage on the engine increases, you should switch to a heavier weight oil, like 10W40.

Jan 10, 2010 | 2000 Nissan Maxima

1 Answer

I changed the oil on my 2008 nissan sentra 2.0


You should use the viscosity oil recommended in your owner's manual. Using a heavier weight oil can affect your fuel economy. If you overfilled the engine with oil, drain out a quart. Overfilling with oil will cause the oil to 'foam', and if this happens, you are not getting proper lubrication of components, which can result in damage to your engine.

Oct 16, 2009 | 2008 Nissan Sentra

1 Answer

Lincoln Welder Generator Oil Question


Better late then never! im-308 total lube oil is 4 pints for a briggs and stratton engine
.
and 3.5 for an onan engine with filter change.

Note: an internal kill switch will shut down the engine if the oil level drops below a minumum

operating level on the onan engine only.

on your welder use a multi-viscosity sae sj grade or better oil. recommended is 10w-30.

if you work in cold environments use 5w-30 oil , it's thinner and will flow easier

during cold starts. Synthetic oil is better. just more expensive. change oil at least

every 100 hours for better performance. good luck!

Aug 19, 2009 | Lincoln Electric Ranger Gxt 250 Amp...

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

49 people viewed this question

Ask a Question

Usually answered in minutes!

Top Motorcycles Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4898 Answers

yadayada
yadayada

Level 3 Expert

79865 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17130 Answers

Are you a Motorcycle Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...