Question about Harley Davidson FXDL Dyna Low Rider Motorcycles
Posted by Anonymous on
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: replace rear brake pads
Remove right saddlebag, pull the two caliper mounting bolts and remove the caliper. Do not open bleeder or disconnect line. You will need to push a large screwdriver between the old pads before removing them in order to push the pucks back into the caliper or the new pads will not spread enough to reinstall. Then pull the two smaller bolts from the caliper and the pads will fall out. The pads are different for inside and outside, so pay attention, and remember, after reinstalling, before riding, be sure to pump brake pedal, and it may take a few stops before brakes stop as effectively as before.
Posted on Nov 10, 2008
your oil drain is on the right side pipe side of your bike look under near the rear back part of your frame you will see a plug with a one quarter allen key threaded plug style bolt kinda hidden in bridge plate of frame it is flat in conjuction with line on bike it is in area right behind where your back pipe expands to baffle of pipe where its skinny and then gets bigger its the one closest to you
Posted on Jun 09, 2009
To change the switch, first unplug the wires at the switch. Screw the old switch out and install the new switch into the tee connector. Do not depress either brake lever while the switch is out. Tighten the switch and reconnect the wires.
Usually you don't have to bleed any air out of the brake system but check the rear brakes for proper operaion. If the rear brake pedal goes too far down, bleed the brakes at the rear caliper. Make sure you don't run the rear brake master cylinder dry while bleeding the rear brake. Use only the approved type of brake fluid, do not mix the different types of fluid. Make sure the rear brakes are working properly before riding the bike.
Posted on Oct 05, 2009
Do Not remove wheel.............push the pads back and remove the two pins.
Note there is a inner and outer pad on assembly, have a look at the new pads they are different
Posted on May 23, 2010
Tips for a great answer:
Jun 27, 2017 | 2004 Harley Davidson FXDL - FXDLI Dyna Low...
Aug 31, 2013 | 2004 Harley Davidson FXDWG - FXDWGI Dyna...
Apr 16, 2013 | 2006 Harley Davidson FXDWGI Dyna Wide...
Apr 01, 2013 | 2005 Harley Davidson FXDL - FXDLI Dyna Low...
May 18, 2012 | 2004 Harley Davidson FXDL - FXDLI Dyna Low...
May 05, 2012 | 2008 Harley Davidson FXDL Dyna Low Rider
Feb 24, 2012 | 2004 Harley Davidson FLHT - FLHTI Electra...
Jul 30, 2011 | 2002 Harley Davidson FXDWG Dyna Wide Glide
Aug 18, 2010 | 2004 Harley Davidson FXDL - FXDLI Dyna Low...
May 22, 2010 | 2004 Harley Davidson FXDWG - FXDWGI Dyna...
21 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: