Question about Indian Motorcycles

Open Question

Removing the starter from a 2003 chief - Indian Motorcycles

Posted by Anonymous on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to replace starter windstar 2003 V6 engine?


2003 Ford Truck Windstar 3.8L SFI 6cyl Repair Guide

Ford Windstar 1999-2003 - Starter Removal & Installation

  1. Disconnect the negative battery cable.
  2. Raise and support the vehicle safely.
    NOTE When removing the hard shell connector at terminal -S-, grasp the plastic shell. Do not pull on the wire.
  3. Disconnect the starter electrical harness.
  4. Remove the upper starter bolt.
  5. Support the starter and remove the lower bolt.
  6. Remove the starter from the vehicle.

    e1d1735.jpg

  7. Fig. The starter is located at the lower front of the engine, and is visible through the air duct

To install:
  1. Position the starter in the vehicle.
  2. Install the upper and lower bolts. Tighten to 15-20 ft. lbs. (20-27 Nm).
  3. Connect the starter electrical harness. Tighten the starter cable nut to 80-124 inch lbs. (9-14 Nm).
    NOTE When installing the hard shell connector, be careful to push it straight on and make sure it locks in position with a notable click or detent.
  4. Lower the vehicle.
  5. Connect the negative battery cable.

I really hope helps with this (remember rated this help) Good luck.

Dec 31, 2009 | 2003 Ford Windstar

2 Answers

98 Jeep Grand Cherokee - will not start - starter solenoid clicks once when engaged but starter will not turn engine - plenty of voltage (14V with jumper cables connected) going to solenoid - with screw...


The starter is bad. Solenoid is good, the starter itself is bad. You can remove it and take it to Schuck's/Chief's/Kragen/NAPA, they will test it for FREE. You can't beat free!!!

Jul 16, 2009 | 1998 Jeep Grand Cherokee

3 Answers

Cadillac 2004 cts, wont start


i had a 2003 ctc that did the same thing, it wouldn't start or would make a clicking sound and about 1 mth after the problem started aND mechanics could not find a problem my car caught on fire and burned completely from something under the right side of the hood. i had just parked the car and got out, it happened really fast. the fire chief said the cause was unknown????

now i have a 2004 cts and i'm having the same problem!!!!!!!!!!!!!!! has anyone else had this happen???? please be cautious if your cts is doing this, during the fire my doors locked and had to be pried into by fire chief.

Nov 24, 2008 | 2004 Cadillac CTS

1 Answer

Changing the starter on a 2003 Taurus


you need to remove it from the bottom front of car . disconnect the negative battery cable. remove the front splash shield from under front of car , working from under car take the protective cap off the wires that go to starter and then disconnect all wires from starter marking each one for propper reinstalation, remove the bolts holding starter and remove from under vehicle. replace in reverse order.

Nov 22, 2008 | 2003 Ford Taurus

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

27 people viewed this question

Ask a Question

Usually answered in minutes!

Top Indian Experts

L Pfaff
L Pfaff

Level 3 Expert

11573 Answers

Carter Glass

Level 1 Expert

32 Answers

Gregg Mahin
Gregg Mahin

Level 3 Expert

39959 Answers

Are you an Indian Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...