Question about 2003 Harley Davidson XLH 883 Sportster
Posted by Anonymous on
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: replace rear brake pads
Remove right saddlebag, pull the two caliper mounting bolts and remove the caliper. Do not open bleeder or disconnect line. You will need to push a large screwdriver between the old pads before removing them in order to push the pucks back into the caliper or the new pads will not spread enough to reinstall. Then pull the two smaller bolts from the caliper and the pads will fall out. The pads are different for inside and outside, so pay attention, and remember, after reinstalling, before riding, be sure to pump brake pedal, and it may take a few stops before brakes stop as effectively as before.
Posted on Nov 10, 2008
I worked as a PDI @ riders in b'ham for a while and had to change a few rear wheels, the 1st thing is to deflate the tire then use a coat hanger wire that is strait. Place the wire @ the center of the axel bolt head and then following the swing arm up to the center of the swing arm bolt head, then use a zip tie to mark the coat hanger. Then move to the other side and check to seeif they are the same . They should be. Then move to the disc break and remove the calliper, do not remove the break line. Once you do this you can loosen the axel nut. I assume you have the back tire off the ground, so now you can move the wheel to the front and remove the drive belt. now you can remove the axel and drop the wheel down and out . do this opposit to put it back on remember to use your coat hanger to reset your tension on the drive belt , hope this was helpfull.
Posted on Apr 14, 2009
The only idea that i can come up with is that you dont have a good ground..or the guage was bad when you bought it..i hope this..Keith
Posted on Jul 02, 2009
The starter on a late model Harley is a typical Nippondenso gear reduction type starter. They are all basically the same except for size.
To replace the starter clutch inside the starter assembly requires disassembly of the starter assembly.
I you will contact me directly, I will scan the procedure and drawings out of a service manual for you.
Posted on Sep 24, 2009
Tips for a great answer:
Aug 23, 2017 | 2003 Harley Davidson XL 883 R Sportster
Mar 25, 2015 | 2005 Harley Davidson XL 883L Sportster
Mar 22, 2015 | Harley Davidson Motorcycles
Jul 13, 2014 | 2003 Harley Davidson XL 1200 C Sportster...
Jun 30, 2012 | 2003 Harley Davidson XLH Sportster 883...
May 30, 2011 | 2003 Harley Davidson XLH 883 Sportster
May 19, 2010 | 2003 Harley Davidson XLH 883 Sportster
May 13, 2010 | 2003 Harley Davidson XL 1200 S Sportster...
May 05, 2010 | 2003 Harley Davidson XLH Sportster 883...
Feb 12, 2009 | 2003 Harley Davidson FLSTFI Fat Boy
120 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: