Question about 1993 Suzuki DR 350 S

Open Question

DR 350 that is slow to de-rev and gas overflow out of the carb

Posted by on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2005 Honda 350 trxtm 4 wheeler


hi, sounds like a stuck float in your carb. Try tapping the carb briskly! sounds like gas is slowly dripping in the bowl overnight and you burn it the next day. I would take the bowl off and see how much gas pours out. It should come out like a light stream of pee. Could be cloged fuel filter or a gumed up or broken float, carb rebuild kits are cheap.
Good Luck!

May 19, 2013 | ATVs

1 Answer

Rebuilt carb on yam 350 warrior now gas is running out of carb and overflow


Woopsies, something amok with the float/inlet valve area.

Typically you get a tiny piece of gas line material that drops into the inlet valve, after a rebuild...

But recheck the float system.

Apr 06, 2013 | Motorcycles

1 Answer

Stuck throttle, wont turn...Frozen ? been siting 1992 350 DR


Disconnect your throttle cables from your carb. See if you can manually move the drum on the right hand side of the carb. If it moves freely and springs back, the carb is good. Twist the grip and see what happens. Pull the two screws out of the casing that mounts to your handle bars and disconnect your cables. try twisting the grip. If the grip is good then VIOLA! You have isolated the problem. I recommend bathing the cables in WD-40. I have a 92 DR as well and that definitely made a difference for me. At this point it wouldn't hurt to remove your twist grip and clean it all out. You are at that point anyhow, may as well make it worth the mother of disassembling it all. Good luck!

Jan 18, 2011 | 1991 Suzuki DR 350 S

1 Answer

My '92 drs 350 has a leaky fuel petcock. it is a vacuum assist type. What would happen if I override the vacuum assist by just installing a solid gasket in place of the diaphram assembly? Flooding, leaking...


It may be ok , but many bikes flood when sitting over night and fill the sump with fuel. if the carb float doesnt quite seal.
Not sure about epa , I think it shouldnt be a problem unless carb overflows and drips on the ground, during the inspection.

Jun 01, 2010 | 1992 Suzuki DR 350 S

1 Answer

I bought a basket case 91 suzuki dr350 and i cant figure out how to install the carb, I dont know what lines go where, any information would help. thanks


There should only be one main fuel line, from the tap to the carby, the rest are just overflow, and vent hose. If you have a vacume operated fuel tap, then it will be a smaller hose, from the tap, to a vacume pick up point somewhere, mabey on the inlet manifold.

Apr 16, 2010 | 1991 Suzuki DR 350 S

1 Answer

2003 WR250 F - eng. won't idle down and carb starts to overflow


Hi Jwelden,
Have you checked the float level in the float chamber?
I guess you may have to reset the float pin adjustment, its allowing more gas to pass through thn required and thus the overflow!
Not bad too, when you are working on the float assembly take the opportunity to blow out the fuel line from petcock to the carburator via the seat for the float pin,any foreign particals there would stop the float pin to seal up and thus overflow.
Fit in an inline fuel filter , this will help keep out the dirt or whatever.
Hope this helps.

Knight (Yamaha Seca XJ750A 1981)


Feb 13, 2009 | 2003 Yamaha WR 250 F

Not finding what you are looking for?
1993 Suzuki DR 350 S Logo

Related Topics:

22 people viewed this question

Ask a Question

Usually answered in minutes!

Top Suzuki Experts

yadayada
yadayada

Level 3 Expert

78267 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4736 Answers

Richard
Richard

Level 2 Expert

83 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...