Question about Yamaha Motorcycles

1 Answer

Getting shock while starting - Yamaha Motorcycles

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Yamaha Master
  • 4,514 Answers

Thers a bare spot on wire harness touchin frame--buy a clymer manual for repair details

Posted on Oct 12, 2013

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to set the collar of a Petafe in ground fence.


1st you have to hold down the little black button on the collar, when it flashes at you release the button.
-Then press the button again and count the # of flashes.
-Keep pressing the button until you get it set to the desired flashes related to the setting you want to use.
-1 flash- audible correction with no shock.
-2 flashes audible correction with low shock.
-3 flashes audible correction with high shock.
It is always recommended to start with the low shock , if using shock setting, then move to higher setting if needed. Most larger dogs require a high shock setting, I have a yellow lab and use the high setting for him. Hope this helps.

Feb 23, 2015 | PetSafe Pet Safe In-Ground Stubborn Dog...

1 Answer

When should I change the shock on my Toyota Tacoma 2007?


Assuming you have inspected the shocks and there's no obvious leaks, cracks, tears, etc.

The classic "bounce" test is to get on the corner you want to test (in this case, one side of the rear bumper) and jump up and down to get the corner bouncing, then hop off. The shocks should stabilize the car in one-and-a-half gyrations (so, when you hop off, it should go up, down, up and then stop bouncing). If it's more, shocks are starting to wear out.

How it handles when driving is the other big indication. If it sways too much on sharp turns or dives too much when you break hard, those are signs that the shocks are starting to wear out, too.

Sep 06, 2014 | 2007 Toyota Tacoma Double

1 Answer

My 2001 Alero Driver Door Shocks Me Every Time I Exit the Vehicle


This is usually a sign of an alternator getting bad. It can also have problems with bad ground wires . You can buy anti static rubber wire straps that hang from the back of your car. This grounds everything better and decreases static electricity. It also is good for car sickness. If your alternator is overcharging, you may get a shock, so I would have that checked out first, than a short in ground wires. Hope this helps

Jan 02, 2013 | 2001 Oldsmobile Alero

1 Answer

Front end hopping intermittent toyota land cruiser


front shocks are shot. The springs are so compressedwithout shocks to keep them in chk even the smallest bump will start a hop and then iit will get progressively worse cuz the small hop most times starts a chain reaction. I'd say replace the shocks and that'll fix your problem. good luck.

Jul 28, 2012 | Ford Cars & Trucks

1 Answer

Rear end is rocking up and down at start and stoping


Classic signs of a Ford Ranger in need of new rear shocks.
Since your vehicle is a 1998, its just about the right age for
the OEM shocks to fail.
Checking your shocks:
1. take off rear wheel & check for fluid leakage from the upper 1/2 of the shock - presence of fluid
indicates shock failure.
2. get in truck bed over the axle and jump up & down. Excessive play/bounciness indicates shock
failure.

Oct 25, 2010 | 1998 Ford Ranger SuperCab

1 Answer

I have a red g shock and it is starting to get a dirty


I assume you are outside of warranty, check with a local watch repairer and see what she or he says, the lcd display might be going bad, or the battery might be low.

Jan 30, 2010 | Casio G-Shock GW500A-1V Wrist Watch

3 Answers

Air shocks trouble shooting no air to shocks rear end saggs


first off! check the shocks seperately with a seperate line to each shock to insure the boots are not blown!! also check the o-rings or farrow beed's around the lines where to go into the shocks for leakage with some dish soap and a spray bottle if thr shocks seems to hold air when isolated from the system then you either have a broken line or the lines where they connect to the ir pump itself are leaking of one side of the air pump it leaking internally`

Jan 15, 2010 | 1991 Lincoln Town Car

1 Answer

Squeaking sound from shock absorbers


ball joints won't squeak like that; they make a popping noise when they're bad. it is very common for shocks to get water in them and start squeaking, and it's usually a horrible screeching squeak. The only way to get rid of the squeak is to change out the shocks. Hope this helped.

Nov 28, 2009 | 1997 Ford Expedition

1 Answer

My rav4 takes bumps hard,can changing tires help with this?


changing tires will help some but if your tread isnt worn enough to justify the cost wouldnt be worth it. depending on your mileage it may be time for shocks/struts. 50,000 is a good time to start checking into shocks.

you can test shocks by doing the following:

the easiest test i know is to push down on front (or rear) of the car, keep pushing until you get it bouncing then let go. if the car has good shocks it will bounce only once after you let go. look under the car at the shocks, if there is oil leaking from the shocks, they are bad.

Oct 09, 2009 | 2007 Toyota RAV4

1 Answer

My water turns green when we shock it I have drained twice now Please help!!!


start with testing your chlorine and ph add liquid shock and conditioner to water dont use algecide you have to get clorine to open up this is critical ph clorine and conditioner you should get a good clorine reading or you have to add more shock

Jun 16, 2009 | Intex Automatic Salt Water System for ...

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

68 people viewed this question

Ask a Question

Usually answered in minutes!

Top Yamaha Experts

dhnguyen

Level 2 Expert

281 Answers

Steve Sweetleaf
Steve Sweetleaf

Level 3 Expert

1144 Answers

Tony

Level 3 Expert

2600 Answers

Are you a Yamaha Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...