Question about 2001 Suzuki Epicuro

Open Question

No electric when you start - 2001 Suzuki Epicuro

Posted by on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Electric start on a 700 series briggs & stratton engine power-propelled, electric start doesn't work


All electric start newer mowers have an in line fuse 20 or 30 amp installed in the wiring harness just before the battery. Some have 2 fuses, check for blown fuse.

May 27, 2014 | Garden

Tip

How to Reverse the Rotation of Single Phase Capacitor-Start Electric Motors


Reversing the rotation of electric motors can be done easily with 3-phase motors. This can be easily achieved by swapping the connection of any two motor leads. But 3-phase motors are usually found and used for industrial purposes. The ones found and used in our homes, from water pumps to electric fans, are single phase capacitor-start type motors. Unlike 3-phase motors, reversing the rotation of single phase electric motors is no easy task. Swapping any two motor leads will not result in the reversal of the motor rotation. Analysis of the motor windings and connections are necessary before any modification can be done to achieve the desired result. Let's take a 3-speed single phase capacitor-start electric motor with electrical diagram shown below as an example. Make sure the motor is disconnected from the power supply before attempting to follow this tip. This tip is intended only for individuals with electrical knowledge, necessary tools, and understand the risks associated with handling electrical equipments and devices.

jahn27.jpg

The first step in the process is determining the start winding which is connected to the line (AC white) and to one side of the start capacitor. To accurately determine the start winding, disconnect all motor leads from the start capacitor and the speed switch for multi-speed motors and then setting your ohmmeter to the lowest scale (R x 1), measure the resistances between the AC white line and each of the motor leads connecting to the start capacitor. The one with the least resistance is the starting winding lead.

Once the start winding lead going to the capacitor is determined, reconnect the capacitor then connect the black AC line to the found start winding lead (marked X). Connect the white AC line to L of speed switch, the motor lead formerly connected to AC white to 3, red to 2, and white to 1 as shown below. Leave the green/yellow ground wire connection as is.

jahn27_0.jpg


Below are the wiring modifications for 2-speed and single speed single phase capacitor-start electric motors.

jahn27_1.jpg


jahn27_2.jpg



jahn27_3.jpg


jahn27_4.jpg

on Jan 11, 2011 | Dryers

1 Answer

2011 KLX110L electric start wont work


Have you tried sqeezing in the clutch lever while hiting the start button?

Rob

Mar 26, 2014 | 2011 kawasaki KLX 110

1 Answer

Rca 7" tablet wont start agan


Unplug the battery.
Unplug electricity.
Press and hold down the start-button for 30 seconds +.
Plug in electricity, NOT the battery.
Try to start.
If this works, let it boot totaly then turn it off.
Plug in battery and electricity.
Start.
Hope it works, good luck

Dec 29, 2013 | Computers & Internet

1 Answer

I have a Generac 6500E. The electric start turns over the engine but will not start. Pull start works fine


If the pull start works, but the electric start doesn't try the following. Either give the battery on the generator a full charge, and if after a full charge it doesn't start, get a new battery.

Jan 20, 2013 | Generac GP6500E - 6500 Watt Electric Start...

1 Answer

My DCS range burners with electric start.


Very likely the spark module. All four are supposed to click when one is turned on, however they are supposed to stop when the burner ignites. Replace the module and test. Good Luck, Appliance Specialists

Jan 03, 2010 | DCS 36-6-1 Gas Kitchen Range

1 Answer

Add electric start to dg7000 generator by Dewalt


This is really not an option. The engine would need a starter motor and battery and starting key switch. You will probably have to replace the unit with an electric start option.

Mar 08, 2009 | Dewalt 7,000 Watt 13 Hp Portable Generator...

1 Answer

My Tecumseh Snow King 8HP snowblower won't start. I need to know how to start it with an electrical cord.


In order to start it with an electric cord you must have a feature called an electric starter. If you dont have the electric starter on your machine now, one can be added at a dealership

Jan 13, 2009 | Vacuums

Not finding what you are looking for?
2001 Suzuki Epicuro Logo

Related Topics:

34 people viewed this question

Ask a Question

Usually answered in minutes!

Top Suzuki Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

Ed Nelson
Ed Nelson

Level 2 Expert

149 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...