Question about 1997 Honda CB 500

1 Answer

The engine revs increase when the engine gets warm.

After riding the engine revs increase to 4000. If the engine is switched off and restarted, theengine idle's at about 1000 revs.

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    New Friend:

    An expert that has 1 follower.

  • Expert
  • 132 Answers

Sounds like the carb lifting body is sticking. take it out and clean it, give it a light coating of wd40 and check the body for any sharp edges as this will cause it to stick. if it has rubber diaphrams then check these for holes even a oin ***** will cause many a problem and must be replaced.

Posted on May 28, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Engine cuts out when given gas


if theres nothing wrong with it you should close the choke between half and quarter (depends on the engine) and gently rev the engine bit by bit till it warms up, you will find the revs increase with gas to a point but if you give it any more gas it will start to stall and cut out, you have to wait for it to warm up - by keeping the gas at the sweet spot where you get best revs without it cutting out - then slowly increase gas pressure as the engine warms up - you can press it a little bit more bit by bit as the engine warms up and the combustion gets better - eventually you will be able to press the gas fully kin and the engine will just run but sound bogged down or gasping for air - this is when to open the choke to the RUN position (or fully open) --- it's now ready to use.
To restart a hot engine when it's been stopped : 1 Prime the engine - 3 squirts - (you wont flood it - plus it lubricates the top of the cylinder with fresh 2 stroke and is good for the engine) 2 Hold gas a quarter way open 3 Pull cord! as soon as it fires give it an extra squeeze of gas to give the best chance of a clean start.

Jan 15, 2010 | Poulan Garden

1 Answer

My cbr 900 rrx is spluttering below 4000 revs?


Seaform will fix this trust me...go to autozone oickup a can put in 1/3 of can into approx two gallons off gas and ride at least fifteen miles hard and it will run alittle rough at first but it should kick in while you ride.

Aug 29, 2009 | 1999 Honda CBR 900 RR Fireblade

1 Answer

While driving i loose the engine thrust in 3000 - 4000 RPM rev up to 5000+ RPM for normal speed of 40-50km.could this be clutch or acceleration problem ??


If you are riding and the revs go up but not the speed then this will be your clutch.If this is the case you can get back to me and i can tell you how to fix it.

Aug 09, 2009 | 2003 Yamaha YZ 125

1 Answer

The engine rpm's increase when the engine gets warm.


spray a samll amount of either near each vacum line connection if the rpms go up theres your leak!!

May 30, 2009 | 2005 Mitsubishi Lancer

1 Answer

The engine revs increase when the engine gets warm.


Sounds like you are running lean. you may need to find an air leak in the intake tracked of the carb and motor. or the carb is dirty or miss adjusted pilot screw.

May 27, 2009 | 1997 Honda CB 500

1 Answer

Engine will not switch off with key and will start with key switched off ;when started revs to 4000rpm RSV 1000 MILLE 2004


Sounds like time for a new ignition switch. The 4000 rev is probably fuel going into the engine when engine runs down rpm while stopping.

Apr 05, 2009 | 2002 Aprilia RSV Mille

Not finding what you are looking for?
1997 Honda CB 500 Logo

Related Topics:

143 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

yadayada
yadayada

Level 3 Expert

75797 Answers

Mike

Level 3 Expert

4336 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...