Question about 1991 Yamaha FZR 600

1 Answer

I have a 1100 Virago 1988 and the engine starts but it wont rev. I have replaced coils, plugs, checked boost censor?..

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Renaissance:

    An user who is expert in 3 categories / brands.

  • Yamaha Master
  • 1,190 Answers

Check carb , ignition set up and fuel feed !

Posted on Jan 18, 2014

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
cape cod bob
  • 292 Answers

SOURCE: 1989 virago wont get rpms up after start

is it just out of winter storeage? could be gum in the carbs, get some fuel system cleaner additive and put it in the gas. run it on idle and get it hot, leave to stand overnight and try again. you are not getting enough gas and when you open it up you are giving more air but not getting enough gas. try changing fuel filter too.

Posted on Apr 01, 2009

finish line
  • 207 Answers

SOURCE: 97 Virago 1100 will start and idle. No highway speed.

sounds like you have trash in your carbs u need to take bottoms off and run a piece of a wire wheel through the jets

Posted on Jun 23, 2009

  • 79 Answers

SOURCE: 02 yamaha vstar 1100, ran fine. started it the

Sounds like it may be drawing air around the intake somewhere. Let it idle and spray around carefully with wd-40 until it speeds up. This will reveal the leak.

Posted on Oct 11, 2009

pugwash814
  • 377 Answers

SOURCE: Virago Red Glowing Pipes

you can add fuel stabalizer to prevent carbs from gumming, get the fuel down low in the tank add stabilzer and add fuel so it mixes now run the bike for a few mins to get the carbs lubricated and you good. the noise could be the valve train from cold oil etc hard to say. as for your red pipes
Most likely cause is that you are running lean (not enough fuel/too much air). This could be caused by the wrong size jets, but if you have not changed them, I would look elsewhere. A clogged fuel filter could be to blame. That would be the first place to look. Next I would look for a leak around the joint from the carb to the engine the rubber joint there get brittle over the years and are not air tight anymore . Spray starting fluid...or WD-40 around the joints and listen for a change in engine RPM. This would indicate a leak, You might just have to rebuild the carbs.. good luck

Posted on Jan 23, 2010

emissionwiz
  • 76164 Answers

SOURCE: where are the spark plugs located on a 1994 yahama

under the gas tank

Posted on Apr 07, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Problem with my fzr after first ride in the morning iit wants to die wen taking off an most of the time it will then start it an it wont rev if let throttle go it will die


I'll tell you why. It is cold natured. I have a 89' Virago, and it doesn't like going anywhere till' it is warmed up. I usually just set the choke up a bit for about 5 minutes, and then hop on and go.

Apr 15, 2013 | 1988 Yamaha FZR 250

1 Answer

1994 virago 1100. Starter spins but wont turnover motor.


Hi, Manuelverdin the starter drive/Bendix/clutch is a mechanical gear driven component that engages the clutch pack ring gear to turn over the engine. It has an internal mechanism that allows the gear to turn in one direction and once the engine starts allows the drive gear to free spin. If gear free spins in both directions then the drive gear has failed, it is not serviceable and needs to be replaced.
For more information about your issue and valuable "FREE" downloads that you will need please click on the blue links below. Good luck and have a wonderful day.
https://www.viragohelp.com/virago-owners-clubvoc-archives/virago-starter-repair
Yamaha Virago Motorcycle Starter Bendix Explanation Fix Pt 1
Yamaha Virago XV1100L Owner Manual
OEM parts for Yamaha
Yamaha Virago XV535 1100 1981 1994 Service Manual

Apr 25, 2012 | Yamaha Motorcycles

1 Answer

I have a 1988 honda shadow 1100,Ijust bought a new battery and it is charged up,go to start it it wont start until i hook cables from my car and then it starts right up..It does crank over without car...


Hmm, this can be starter brushes. Engine needs lot of electric power for starter and plugs. If starter is bad, it takes all power and nothing left for plugs and you can"t start the bike.

Feb 16, 2012 | 1988 Honda VT 1100 C Shadow

1 Answer

I just bought a 1988 yamaha virago 750 and it was stored outside covered for over 4 yrs.Cleaned carbs and gas tank,put new plugs in,new fuel lines and checked fuel filter is ok. I have spark,compression...


good start on cleaning things BUT, you should replace pump. the pump will have the same gum **** the tank did. you can unhook lines and turn over to see how much fuel you get

Jun 14, 2011 | 1988 Yamaha FZX 750

2 Answers

95 virago 1100 i have power to the coils but nothing at spark plugs.? have stand up what am i doing wrong?


If you are certrain there is power going into the coils and there is NO spark (remove a plug, ground it, with the ignition on, press the start button - observe there is NO spark at the plug) replace the coils.

Jul 05, 2010 | 1995 Yamaha XV 535 Virago DX

2 Answers

Hi I have a 1989 Yamaha Virago the rear cylinder


better look at carb-there r 5 diff jets but its probly the mid range one-be careful here because rong ajust can hurt engine-u hav a clymer manual? library has many books on mc maintenance-sayonara

Aug 31, 2009 | 1988 Yamaha XV 535 Virago DX

1 Answer

Have no power on acceleration, backfires 4.0L Jeep


could it be your throttle sensor? If it is a carbureted engine, check the accelerator pump inside the carb.

Jul 09, 2009 | 1988 Jeep Cherokee

1 Answer

I have a 1985 xv700 virago. one of my plugs are misfiring. I had issues with my original one. yamaha dealer told me i needed a new cdi box. He sold me a used cdi igniter box from a non running 1985 Yamaha...


follow the plug wire back to the coil and see if there are any breaks, if not might switch coil with the other one and see if the other plug now misfires, if so replace the coil, most cdi problems are not intermittent, typically they either work, or they dont.

Jul 05, 2009 | 1988 Yamaha XV 535 Virago DX

1 Answer

97 Virago 1100 will start and idle. No highway speed.


sounds like you have trash in your carbs u need to take bottoms off and run a piece of a wire wheel through the jets

Jun 22, 2009 | 1988 Yamaha XV 535 Virago DX

Not finding what you are looking for?
1991 Yamaha FZR 600 Logo

89 people viewed this question

Ask a Question

Usually answered in minutes!

Top Yamaha Experts

dhnguyen

Level 2 Expert

281 Answers

Steve Sweetleaf
Steve Sweetleaf

Level 3 Expert

1144 Answers

Tony

Level 3 Expert

2600 Answers

Are you a Yamaha Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...