Question about 2006 Daelim Daystar

1 Answer

Starting Problem will not start with electric starter. can start if i kick start it but quits as soon as i let off of gas. also quits when give it too much gas. the choke doesn't help.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 3,567 Answers

I am not familiar with your bike but if it has a standard carburetor then remove the water trap bowl at the bottom of the petcock, (gas valve). Is there any water or trash in the bowl? Drain a cup of gas from the tank. Is there any water or trash in the cup? Dump it, clean it and re-mount it, ( not all bikes have a water trap bowl ).
Drain the carburetor. There may be a screw on the lower side of the carb float bowl. Remove the screw then replace it after the fuel drains. Install a new stock NGK spark plug.

Remove the carburetor from the engine. Remove the float bowl and clean the entire carb with a spray carb cleaner from the auto parts store. Wear protective goggles to avoid getting spray in your eyes. Spray into all the little airways and fittings in the carb. Remove the idle screw and the air screw on the outside throat of the carb and spray into the screw holes as well.
< < READ CLOSELY > >
Be sure to put these two screws back in the same hole they came out of. IMPORTANT > do not tighten these two screws down. Only screw these in until they LIGHTLY seat. Now turn each screw one and one half turns outward. Put the rest of the
carb back together, clean the air filter and install the carb. Let the float bowl fill then start the engine.

Please rate this solution. Thanks!

Posted on Apr 23, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Not starting


You need to give us more information. Are you Kick Starting or using an Electric Starter? Is the Electric Starter engaging and turning over? Is there smoke burping out of the tail pipe when trying to start it?

From your info you might want to check all your fuses. There might be a critical fuse burned out.

Jul 26, 2016 | 2011 Piaggio Fly 50

1 Answer

I went threw a big mud puddle in my Mazda tribute4x4 2004 and soon as I exit the puddle it quits.won't start even with boost.it only makes a click click noise.


Hi, it sounds like you have a problem with your starter not kicking in just check the starter first you may have shorted it with the water.

Feb 07, 2016 | Mazda Cars & Trucks

1 Answer

Electric starter quit working on c3 yamaha


Hi, Anonymous for this scenario you will need your service/owners manual if you can't find the first and best tool you ever bought for your Yamaha, despair not, for a mere zero $0 you can download another one. For more information about your issue and valuable "FREE" downloads that you will need please click on the links below. Good luck and have a nice day.
Electric starter only works intermittently sometimes
ZUMAFORUMS NET View topic electric start no dice but starter turns over...
Yamaha XF50W Service Manual
OEM parts for Yamaha
http://www.yamaha-motor.com/assets/service/manuals/2008/lit-11626-21-55_c3_1662.pdf

Oct 02, 2012 | 2009 Yamaha C3

1 Answer

Runs while key is being held on. as soon as you release key to driving derections. jeep stop runing. can any one help me.


I don't quite understand what you mean by be held on. Normally you "hold on" to the key to start it and let it go back to the on position. If you have to hold the key on (start position) then you can might not be starting. The starter is turning the engine, but the engine not running? What happens when you give it gas?

Oct 02, 2011 | 1999 Jeep Grand Cherokee

1 Answer

I have a 97 bmw 38is and the starter went out. i have been push starting it and wont to know if it will damage the car in any way by push starting to many times


Hi.

Push starting in the long run can damage several parts.

The manufacturers state that it can damage the catalytic converter because of the blow of engine gas getting to the exhaust system when the car is starting.

It can also damage the electronics and the injection system, because of the slight over voltage given when the engine kicks in, and because the car will first run lean, and then suddenly rich when the pump kicks in. In some case you can also risk overheating the pump, which is cooled by fuel running inside the part.

Damage from push start is not really frequent, but can occur. Better not taking too many chances, and fixing the starter motor as soon as possible.

Regards.

Ginko.

Mar 12, 2011 | BMW 328 Cars & Trucks

1 Answer

Just bought my first Husky - 610 SM year 2000. Great bike to ride and bags of fun..... Once I get the damn thing fired up that is !!!. Starting the bike from cold is an absolute nightmare - the electric...


I would say that the starter needs an overhaul and a clean out and relube. Be careful when lubricating the shaft, If the oil is the least bit thick or too heavily applied the pinion will hang up. For the rest, starting the bile is just a case of getting the sequence of the start right for that machine. When I got my Velocette (500 cc single) very long ago, it took me over half an hour to start the first morning, and no electric starters. Soon I was starting it first kick every time.

Mar 05, 2011 | 2001 Husqvarna SM 610 S

1 Answer

Poor starter, plug gets wet, starts when bumstarted


First, get a fresh sparkplug. Next, charge the battery. Batteries usually only last two years or less. A battery that will not hold a charge will rob electricity needed for spark. On a bump start, the flywheel generates more electricity than a kick start. Give the throttle only one twist on your morning start if your bike has a power valve. The valve gives a shot of gas when the throttle is turned. Twist too much and the engine will flood. Please rate my answer. Thanks.

Aug 23, 2010 | 2000 Sym Husky 125

2 Answers

Piaggio Zip 50cc not starting... :(


test the batt -it must be 12v at all times -slightly lower and ignition wont function

Jan 05, 2010 | 1977 Moto Guzzi V 50 I

Not finding what you are looking for?
2006 Daelim Daystar Logo

479 people viewed this question

Ask a Question

Usually answered in minutes!

Top Daelim Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Joseph Hoffmann

Level 3 Expert

1702 Answers

RAYMONDO1953

Level 2 Expert

545 Answers

Are you a Daelim Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...