Wont turn over doesn't even click has new battery and starter do they have a low oil safety feature that wont let you start it cause oil is 1 quart and a half low
Add oil. Check your Brake lights. If they do not work, the problem with starting is the brake safety switch. You are required to put your foot on the brake pedal to start your car.
If the brake safety switch is broken or knocked loose of the holder on the brake pedal lever, you will not get the release signal to engage the starter.
SOURCE: 2002 Cadillac DeVille wont start (even w/new battery!)
well first off, check the glove box light blub, make sure it shuts off when you close the door, check it by pressing the switch with your finger to make sure it shuts off, also check under the hood for the light there if there is one, pull the bulb, and the same thing for any bulb in the trunk, then check again after a day to see if the battery dies, if it is dying while the vehicle is not running then it is the battery, if it is dying after it is running then it is the alt. you can check that also tho with a multimeter set to the DC volts setting, place the black end <the ground to any grounded area> and the red end <the hot lead to the back of the alt. > it should be reading higher then 12 volts, normally should be a higher reading then 12 volts... if you are getting a lower reading or just 12 volts then the alt. is bad and needs to be replaced...hope this helps you out...
SOURCE: new starter good batt. only clicks wont turn over 1995 montero
The Batt does not have a full charge or it is the wrong cranking AMP's for the car... find out if it is the right Batt and also that it is put on a "slow charge" over night or at least 6 hr's
SOURCE: 2001 Ford Explorer Sport wont start
Even though I bought the vehicle new, there was an aftermarket security system installed. The system had a bad diode, so i removed the system and reconnected the factory wires.
SOURCE: 94 z wont start
check the ignition fuse, fuseable link and starter relay
Testimonial: "thank you - i'll check"
SOURCE: chrysler 2004 starter doesn,t turn
My 2004 Sebring did just that. it was a fusible link. a tiny square box in there with the fuses. they are a cube that plugs in about 3/8" of an inch square. Find the bad one replace it and the starter starts working again.
294 views
Usually answered in minutes!
×