Question about 2007 Yamaha V Star 1100 Silverado

1 Answer

Washed bike - now no power

Washed the bike and dryed off. Started fine to pull in garage but now
it will not start - headlight on, just no juice...........

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

Does it crank? Or just run badly?

Posted on Apr 20, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I washed my bike. Now, why doesn't it have any power?


Hi Brn make sure IRS dry around the spark plugs remove them if nessasary. It should start when dry. Good luck.

May 09, 2015 | Motorcycles

1 Answer

2013 KTM XCF-W Will not start.


Yes I to have washed a bike to death.You will need to dry the air filter .Is you bike fuel injected?If so take a hair dryer and warm all the connections concearning spark and fuel injection .You should then put dielecric grease on all your connectors.If you bike is carb model then just drain the float bowl.

Apr 28, 2014 | 2013 KTM XC 250 F

1 Answer

Motorcycle will push start but not ignition switch start


Does it turn over when trying to start? If no then it could be the starter, switch, or battery. Sounds like the starter, especially if you tried another switch.

Apr 14, 2014 | 2008 kawasaki Ninja 250R

1 Answer

I washed my bike and after few hours when i am going to start it ,,it sounds differently and doesnt start .


Hello sir!
Check out the spark plug of your bike, It got wet while washing your bike clean it properly and dry it. and then try to start your bike it will work fine.
Note:* Spark plug is located in the head of the bike and you need to untied it using tool in the tool box.

Aug 23, 2012 | 2011 Bajaj Pulsar 220 F

1 Answer

Hi, I have yamaha yzf 125 r(2008) 2 days ago i washed my bike with water. After washing bike started normally as usually. But today when i wanted to start it, starter just trying to start the bike but...


Check your ignition components for condensation. If you wash the bike using water especially around the motor, you should promptly dry it thoroughly before starting it to avoid the possibility of condensation caused shorts in the ignition system. I personally use a leaf blower to dry mine and let it sit in the sun for a while to make sure it's dry. I think you will find condensation is your problem. Good luck and safe riding.

Jun 27, 2011 | Yamaha YZF-R125 Motorcycles

1 Answer

Washed my bike it ran fine stalled at a light could get it to start and it idles rough when u twist the throttle it dies and engine light comes on could it b the relays


Check coil wires pull boots back they are wet pull wires out of coil dry them with air compresor Blow off electrical compenents try that Hope you didnt get water in tank OR put sea foam in tank it will clean carbrator MOPAR KENNY

May 22, 2011 | Harley Davidson FLHRCI Road King Classic...

1 Answer

Washed bike.Engine light on Wont start. push started bike. Bike ran. Directionals, horn dont work. Headlights / breaklights dim. Drove but misfires. Fuel injected. Never had a problem with bike ever. 2003


Sounds like you have water that is pooled in a connector or in the wiring harness water conducts electricity time to take covers of and expose areas and blow dry with air suspected area where water would settle relays multi plugs check each one for water.

May 23, 2010 | 2003 Harley Davidson FXSTB Night Train

1 Answer

I recently washed my 2005 custom chopper and thought that I had dried it off well enough, obviously not! The bike has an S&S 111 engine and when I went to go for a ride I turned the ignition key and...


take a leaf blower and dry the bike with it, after washing any bike you should use a "light" powerd leaf blower to dry your bike. Just let the water dry out and you should be fine. If not pull out all the fuses and hand dry them before you them back in and try it...

Jun 22, 2009 | 2003 Harley Davidson FXSTDI Softail Deuce

1 Answer

I washed the bike and it wont start now. the


have you checked for a spark at the plugs. You may well have got water in the coils.The cure for this is natural drying. if this is the case the coils will need to be sealed. and the leads silicone sprayed

Jun 04, 2009 | 1999 Suzuki GSX 600 F (Katana)

Not finding what you are looking for?
2007 Yamaha V Star 1100 Silverado Logo

Related Topics:

110 people viewed this question

Ask a Question

Usually answered in minutes!

Top Yamaha Experts

dhnguyen

Level 2 Expert

281 Answers

Steve Sweetleaf
Steve Sweetleaf

Level 3 Expert

1144 Answers

Tony

Level 3 Expert

2600 Answers

Are you a Yamaha Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...