Question about 2001 Yamaha YZF-R6

1 Answer

Oil light stays on after i put new oil in

It turns on at 150 temp and shuts of at 170

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 209 Answers

Check your thermostat and you cdi unit coz your thermostat reflect back to your cdi unit so if your thermostat is defective it will reflect to the cdi unit and forced it to shut off.

Posted on Apr 17, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2004 Impala ls temperature dash gauge


fans came late on those car,like 212 and second fan comes on at 224,you reprogram it to come a lot sooner,,other thing is there might be gunk inside the block,and coolant has hard time to pass through,and staying longer than enough in block temp goes high,even tough the radiator is doing it's job,it is just coming out block lot hotter than it suppose to be,and gauge read the block not the radiator

Apr 18, 2017 | 2004 Chevrolet Impala

1 Answer

I dropped the fuel tank to drain old gas.I put new gas in and turned engine to start it didnt start. Should I be able to hear fuel pump if it is working?This is for a 1990 ford e-150 van.Also where the is...


Turn the key to the ON position without starting the engine. You should hear the fuel pump running for 5 seconds if working. This primes the gas to the injectors when doing this. If not heard running check the oil pressure switch for the 12 volts needed to run the fuel pump starts there on that harness. When the engine starts and the oil pressure reaches the normal pressure the computer shuts off that circuit and turns on the fuel pump relay to run the pump. The relay stays on till you shut the engine off

May 08, 2010 | 1990 Ford Econoline

1 Answer

My oven stays at 150 degrees at all times...even


clean pilot assembly. then oven thermostat

Jan 01, 2010 | GE JGBS20 Gas Kitchen Range

2 Answers

What are the high and low pressure specs for my a/c


this really depends on the ambient temp,but as a rule low side 35-45 psi high side 150-170 but this depends on the ambient temp or the temp at the condenser, hope this helps if not get back to me and we'll go from there. please rate my fix as i strive to be the best

May 07, 2009 | 2001 Toyota Celica

1 Answer

I have a ef3 vulcan, when reaches temp, the pilot goes out.


Set the thermostat to 350 degrees,get a thermometer and put it in the oil,when the unit shuts off look at the temp of the oil.If the temp of the oil is higher then the thermostat is bad if not the hi-limit may be.Let me know.

Apr 04, 2009 | Vulcan EF3 Deep Fryer

1 Answer

Oven will not stay on


I used what Charlie recommended ...” post-it” as insulation
And works PERFECTLY….
I have a Kenmore oven Clock…( built in the wall)
Thanks Charlie…you are a Genius!!!!

Jul 29, 2008 | Kenmore 40494 / 40495 / 40499 Electric...

1 Answer

Olympus FE-170 support


Well Your camera must have been dropped likke mine i hope it gets fixeed but take it to get it checked out and hurry!

Dec 10, 2007 | Olympus FE-210 Digital Camera

2 Answers

Garland deep fryer


gas valve not fully turned on
cattering hose not fully pushed into connector
thermostat tube inside oven broken (new valve)

Nov 13, 2007 | Garland AF-5025 Deep Fryer

Not finding what you are looking for?
2001 Yamaha YZF-R6 Logo

Related Topics:

157 people viewed this question

Ask a Question

Usually answered in minutes!

Top Yamaha Experts

dhnguyen

Level 2 Expert

281 Answers

Steve Sweetleaf
Steve Sweetleaf

Level 3 Expert

1147 Answers

Tony

Level 3 Expert

2600 Answers

Are you a Yamaha Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...