Question about 2004 Honda Honda Fusion

1 Answer

Will not start. Changed plug, cleaned carb,getting spark but will not start. I was told that the battery had to be charged up befor it would start.

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I fixed the problem by taking the carb back apart found out that the float needle was sticking. I cleaned up float needle put it back together and it fired up.

Posted on Apr 14, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1979 honda cx 500 will not start


check valve clearances

Mar 03, 2013 | Motorcycles

1 Answer

Aprilia rs 125 won't start!!


right you done quite a bit, so whats left, fuel seems ok .. so ht lead ht cap, spark plugs dont always come with right gap, any leaks with airflow either side of carb, remember the filter often acts as a restrictor too. try the putting a small amount of fuel in cyclinder after cleaning plug, should atleast get a backfire, is choke setup ok, carb mix if not factory sealed is generally 1 and 3/4 turns out from tight,

Feb 13, 2013 | 2005 Aprilia RS 125

1 Answer

Polaris 325 magnum spark plug change


The spark plug is on the left side (shifter) of the head,,..?/ this is August.. if the atv has been sitting the carb may need a qualified professional to clean it again.. Replace the spark plug before you squirt anything in the engine...

Jul 27, 2017 | Polaris ATV

1 Answer

I bought my brother's 1987 Kawasaki Ninja 750R. He told me that he used to have to use booster cables to a car battery to start the bike for the first time in the spring. I've changed the spark plugs,...


Yes, drain the carbs. Also clean the air filter. Get a can of spray starting fluid to assist in getting the engine to start. Chances are the carbs are gummed up from sitting so long. You will probably end up removing the carbs for a thorough cleaning.

Apr 13, 2011 | kawasaki GPX 750 R Motorcycles

4 Answers

My 1974 Yamaha 250 Enduro wont start I have cleaned and redone the carb. I have changed the coil pack and spark plug. Any suggestions will help Im not a mechanic by any means so not sure where to start...


you need good compression ( at least 90 psi , kicking it with the throttle open) , good crankshaft seals for sucking the fuel/air into the botton end, proper point gap and timing set for spark ( spark should be big and fat,if not the source coil is weak,, this is a flywheel magnito ignition and it needs no battery to fire the plug) if you clean the carb, make sure you also clean the choke pickup tube or it wont choke. also make sure you have the slide installed in the right direction ( not backwards and the idle is not set too high at first...compression/****-good spark at the right time-proper fuel/air ratio and it will run

Jul 04, 2010 | 1974 Yamaha DT 360

2 Answers

Scooter wont start


The ignition timing may have been disturbed,or if it is equipped with a carburettor,the mixture setting may have been disturbed,or the carb.jet may be blocked by dirt in the fuel or the spark plug may be faulty .get all these checked first .

Aug 14, 2009 | Qianjiang QJ150-C Motorcycles

2 Answers

Briggs and Stratton 6.5 hp won't start- not sure gas is getting to the spark plug, just overhauled the carb, changed oil and new spark plug


First you could make sure you have spark. Take the plug out and then plug it into the black wire. Set the end of the spark plug near the frame of the lawn mower. Pull the cord one time to see if there is an arc from the plug to the mower. If you have spark, I would put the plug back in. Before putting the plug back in I would spray a little bit of starting fluid. See if it will fire up with the starting fluid in there. If you have a true good spark, it should fire up. This may be enough to get some gas going in there as long as you have the lines hooked up correctly.

Aug 03, 2009 | Craftsman Garden

4 Answers

Mower will not start


Hi
Take the spark plug out and pour a little bit of oil in the cylinder and crank it over without the spark plug in. Make sure ground wire is clean on both ends.

Apr 13, 2009 | Garden

2 Answers

Scooter won't start


I think you need to take it to your local scooter shop and have the carburetor cleaned and the spark plug changed ask to have the routine service done

Feb 03, 2009 | 2006 Daelim History

Not finding what you are looking for?
2004 Honda Honda Fusion Logo

Related Topics:

149 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4536 Answers

yadayada
yadayada

Level 3 Expert

76649 Answers

bazzz7071
bazzz7071

Level 2 Expert

342 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...