Honda pal 2 stroke scooter
hard to start hot seems to die out when ideling stats-: coil good-both pressure and vacuum held in c/cases- compression 150psi , timming good , fuel flow good - carb clean, spark still operational while fault developed
muffler clean, clear no carbon
[email protected]
Are you adding oil to the gas? (32/1 = 4 ounces per gallon)
Do you still have spark? Install a new stock spark plug.
Clean the carb, but follow these steps >
Remove the carburetor from the engine.
Remove the float bowl and clean the entire carb with a spray carb cleaner from the auto parts store. Wear protective goggles to avoid getting spray in your eyes. Spray into all the little airways and fittings in the carb. Remove the two screws on the outside throat of the carb and spray into the screw holes as well.
< < READ CLOSELY > >
Be sure to put these two screws back in the same hole they came out of. IMPORTANT > do not tighten these two screws down. Only screw these in until they LIGHTLY seat. Now turn each screw one and one half turns outward. Put the rest of the carb back together, clean the air filter and install the carb. Let the float bowl fill then start the engine. Let the bike warm up then set the idle speed. This process should get you back on the road.
No spark
Need to replace the piston and piston rings if the size of the piston is still standard you need to replace size .25 and bored it out
1,417 views
Usually answered in minutes!
×