Question about 2001 Suzuki DR-Z 400 SE

Open Question

Wiring diagram no spark,i have changed magneto flywheel stator,rectafirf,and cdi unit...still no spark

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 78 Answers

SOURCE: CDI Unit is missing

does this work for you?
http://zorch.maow.myip.org/bikes/wiring/ts-185.jpg
good luck!!

Posted on Dec 22, 2008

Ad
tellme2
  • 137 Answers

SOURCE: need cdi wiring diagram for suzuki 900

hi m8,,give these guys a try,, www.repairmanual.com

Posted on May 03, 2009

  • 4 Answers

SOURCE: please help I have a 1980's model susuki dr 250

I have a 83 DR 250 and i'm not getting enough voltage to create a spark, all I can suggest is that you check your battery and make sure its at full flavour. Check and see if you are getting any voltage prior to the ignition coil (should be 18-35v). If you suspect battery then try clutching it as the alternator moving faster might give you enough to get her going. Also check all your connections and earths. Earth wires are often overlooked and can cause you just as many problems as the actives. So give that a go and get back to me mate. Cheers

Posted on Jul 25, 2009

badassdevil
  • 6 Answers

SOURCE: is it possible to get a magneto flywheel for a

Yes try Babbittsonline.com they have everything and anything for all makes and models the cool thing about it is that you can look at the break down of your whole crank case till the last bolt and nut. and it will give you the part number and price as well.

Posted on Sep 21, 2009

Benimur
  • 6966 Answers

SOURCE: NO SPARK ON A 98 RM 125

Hi and welcome to FixYa,

Initially, test for the presence / absence of below described voltages using an analog / needle type voltmeter when starting the bike:

  • pulsating low AC voltage coming from the pickup coil;
  • pulsating voltage feeding the ignition coil.

Good luck and thank you for asking FixYa.

Posted on Dec 19, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Johnway 125 magneto location


Hi, Nettie for more information about your question and valuable "FREE" downloads that you will need for viewing and printing please click on the blue links below. Good luck and have a wonderful day.
Jonway 125 magneto location Google Search
How To Fix Replace GY6 Flywheel Cdi Stator and Magneto
http://www.family-motorsports.net/GY6-50cc-150cc.pdf
Jonway Scooter Parts
http://absolutelyscooterparts.net/pdf/CGEN_dawg_scooter_manual.pdf

Jul 20, 2017 | Jonway Motorcycles

1 Answer

How do you remove a stator off a cfmoto e jewel


Hi, Anonymous sorry you can't find the first and best tool you ever bought for your Derbi despair, not for a mere $10 you can download another one. For more information about your issue and valuable "FREE" downloads that you will need please visit the websites below. Good luck and have a nice day.
How to remove stator gy6
How To Fix Replace GY6 Flywheel Cdi Stator and Magneto
how to remove the flywheel with out any special tools
https://www.tradebit.com/filedetail.php/211210862-cfmoto-cf150t-cf125t-e-jewel-urban-150

Mar 03, 2016 | Motorcycles

1 Answer

How change starter on bajaj 200


Hi, Anonymous I am sorry you can't find the first and best tool you ever bought for your Bajaj but despair not for a mere $0 you can download another one. For more information about your issue, please visit the websites below. Good luck and have a nice day.
How To Fix Replace GY6 Flywheel Cdi Stator and Magneto
Installing GY6 Stator
Bajaj Avenger 2006 service manual DOWNLOAD FREE FULLMANUALS COM
http://www.marutibajaj.com/pdf/Avg-200.pdf
Bajaj Auto Avenger 200 User Manual

Feb 02, 2014 | Bajaj Motorcycles

1 Answer

I have a 2010 Oliver City CPI, motor scooter. The engine wont start. The starter seems to work and theres gas in it. Tried the kickstarter and wont start. bad spark plug maybe?


My problem started like this,I found No spark so changed coil,cdi,voltage reg,eventualy found stator at fault,check pick up strip on flywheel and pick up pin on black pick up coil,this is fixed to stator and sends spark signal to cdi,mine were both rusty/dirty,I fitted a new stator,but now have light problems..stator seems to be to strong.

Jul 14, 2011 | 2011 Cpi Oliver City

2 Answers

Xt 500 has weak spark(flywheel magneto with ignition points).poor when cold and now won't even start.fuel fine.isolated ignition(magneto,coil and points).changed coil.points fine,resistance...


It sounds to me that you have done most all of what is needed. Just take some fine sandpaper to the magnets in the flywheel. After sanding, wipe it clean, then spray it with carb cleaner to remove any possible residue. Now give the magnets a spray coating of clear polyurethane coating. The flywheel will never rust again. Replace the source coil and install a new spark plug. A plug that is carboned up can lessen spark voltage. The last item is the battery. A weak one can rob power. Please rate my answer. Thanks.

Jun 03, 2011 | Yamaha Freedom Topper Motorcycles

3 Answers

My Rm 250 wont spark need to know the volts from stator to cdi plug. Got brand new cdi, stator , rotor and pick up coil but it still wont spark.


The Voltage From The Stator To The CDI Should Be Around 40 Volts(AC) At Cranking Speed. Be Sure Your Meter Is Set For (AC) Not (DC). The CDI Changes The (AC) Input Voltage To (DC) Output Voltage To The Primary Terminal At The Coil. An Electrical Shock Hazard Exist If Stator Voltage Is Checked With Engine Running. Always Perform This Test At Cranking Speed (R.P.M.) For SAFETY. 120 Volts (AC) Can Be Present With Engine Running.

May 22, 2011 | 2003 Suzuki RM 250

1 Answer

Changed the CDI, Magneto, and pick up coil, on Kazuma Falcon 90 ATV. Still no spark.please help.


I'm having the same problem with my Kazuma falcon 250. No spark, the stator shows good ohms and I just replaced the CDI box and still nothing. I'll check the kill switch and reverse override.

Apr 29, 2011 | Sport & Outdoor - Others

1 Answer

No spark from CDI Unit. bike is Bug Jive 50. Motor cut out while riding, checked all obvious things, lights OK, Battery Ok


Replace the magneto/stator, CDI and voltage regulator/rectifier. Usually if one messes up they all go bad.

Jan 01, 2010 | Kymco Stryker 125 Motorcycles

1 Answer

I need a cdi magneto or fly wheel rotor and can't find the right one


buddy is that the cdi unit the stator plate and the magneto ???

Oct 12, 2009 | 2004 Yamaha YZ 125

2 Answers

Please help I have a 1980's model susuki dr 250 the ignition spark got steadily worse until it now has none.I have checked the ht coil,pulse pick up coil,earthing wires,cut off switchand had the stator...


I have a 83 DR 250 and i'm not getting enough voltage to create a spark, all I can suggest is that you check your battery and make sure its at full flavour. Check and see if you are getting any voltage prior to the ignition coil (should be 18-35v). If you suspect battery then try clutching it as the alternator moving faster might give you enough to get her going. Also check all your connections and earths. Earth wires are often overlooked and can cause you just as many problems as the actives. So give that a go and get back to me mate. Cheers

Jun 04, 2009 | 2001 Suzuki DR-Z 250

Not finding what you are looking for?
2001 Suzuki DR-Z 400 SE Logo

Related Topics:

23 people viewed this question

Ask a Question

Usually answered in minutes!

Top Suzuki Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4521 Answers

Richard
Richard

Level 2 Expert

83 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...