Question about Harley Davidson FLHTCUI Electra Glide Ultra Classic Motorcycles

1 Answer

1999 harley davidison firing problem

My 1999 Harley ultra classic isn't firing on the rear plug. changed coils still no fire

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 20 Answers

Try new plug and wire.

Posted on Jul 14, 2013

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

tundrajet
  • 80 Answers

SOURCE: removing harley davidson ultra classic gas tank

Drain the fuel either by siphening or removing the cross over tube at the front of the tank and letting it drain that way or just block off those cross over lines and leave the fule in the tank for removal.

0) remove seat
1) drain fuel
2) undo cross over line (bottom front of gas tank.
3) shut off pet **** and remove fuel line from pet ****.
4)there should only be 2 bolts holding the tank on, one at the top front of the tank and one at the back of the tank.

All in all a pretty easy (but possibloy messy) job.

Posted on Jun 06, 2009

  • 69 Answers

SOURCE: How do I change the front and rear brakes on a

Not too hard - Undo the two bolts on the caliper and then seperate the caliper and pull the old ones out. Insert the new ones and put the bolts back in to hold the caliper back together and then install them back on the bike with the two retaining bolts. Use a bit of lock tight (Blue) on the threads. Warning do not let anyone apply pressure on the brakes while you have them off the bike or you will have a mess and/or a problem.

Posted on Jun 21, 2009

  • 69 Answers

SOURCE: 2002 harley davidson ultra classic setting the clock

Turn the Bike on and the Radio off and then follow the buttons on the screen. Most people think you have to do it while it is running and this does not work

Posted on Jun 28, 2009

REDOIL
  • 355 Answers

SOURCE: having trouble changing a kick stand spring on my

well the easy way is to jack up bike remove the nut jiffy stand slide it out hook spring slide it back in and tight nut hope this helps

Posted on Sep 30, 2009

wd4ity
  • 4565 Answers

SOURCE: for a 2001 Harley Ultra Classic where is the oil

The oil tank is on the bottom of the transmission. There are two drain plugs, one for the engine oil and one for transmission lube. The engine oil drain is the one closest to the left front of the oil tank. The drain that is more in the center is the transmission drain.

Posted on Feb 17, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2007 ultra classic back firing


Hi Anonymous, usual suspects are: intake or exhaust leak, bad or wrong plugs or gap or plug wires, ignition coil, ignition module, CKP or MAP sensor, loose battery and wire connections, connector blocks. For additional clues go to website below:
Harley Trouble Codes
Good luck

Apr 03, 2014 | Harley Davidson FLHTCUI Electra Glide...

1 Answer

My 98 ultra classic is not getting any spark/fire from my coil to my motor. I changed my coil, I tried changing my relays and still nothing. My bike is a '98 Harley Electra Glide Ultra Classic with...


Hi Anonymous, the CKP sensor needs compression to send correct signal to the ICM/ECM, make sure both spark plugs are in heads and use a grounded third plug to check for spark or hold spark plug cable close to spark plug in head. If still not getting spark the usual suspects are:
1. Fouled spark plugs.
2. Battery voltage below 8.7 volts, loose or broken battery cables especially ground cable to frame.
3. Loose connection at ignition coil or plug between ignition sensor and module.
4. Spark plug cables in bad condition, shorting / leaking, spark plug cable connections loose.
5. Faulty ignition coil or ignition / electronic module
6. Failed CKP, CMP, MAP or BAS sensor.
7. Faulty ignition switch.
For a prime suspect please visit the website below and good luck.
Harley Check Engine Lamp Diagnostics

Aug 23, 2013 | 2000 Harley Davidson FLHTCUI Electra Glide...

1 Answer

2000 WONT'S START NO FIRE AT PLUGS


No. I dont think the voltage regulator is implicated in a no spark at the plugs situation.

Dec 18, 2012 | 2000 Harley Davidson FLHTCUI Electra Glide...

1 Answer

Rear cylinder is cool to the touch, the front one is hot


The spark plug on the rear cylinder isn't firing. Check the plug for fouling and make sure the spark plug wire is good and connected to the coil and plug properly. Also check the spark plug gap (0.040)

Jun 26, 2012 | 2001 Harley Davidson FXDL Dyna Low Rider

1 Answer

2002 harley davidson electra glide ultra glide classic will not start


test batt--must be at 12.6 v for proper fire--mite hav a bad one or alternator is failin------get a book on maintenance details

Apr 13, 2012 | 2002 Harley Davidson FLHTCUI Electra Glide...

1 Answer

I have a 2000 ultra , It starts right up but after 5 minutes it dies .it doesn't have vapor lock.its not a breaker i checked the carb works fine on another bike.the coil is getting12 volts 2 it when it...


Hi Keithfgee69, and the usual suspects are:
1. Severely discharged or damaged battery.
2. Loose, corroded or broken battery cable.
3. Alternator not charging or below normal rates.
4. Failed ignition coil, ignition/electronic module.
5. Failed CKP, CPS, CMP, MAP, TPS, or BAS sensor.
6. Faulty ignition switch.
7. Water or dirt in fuel system, carburetor or filter.
8. Fuel tank vent system plugged or gas cap not venting.
9. Fuel tank empty.
10. Fuel valve vacuum line broken or carburator vent line closed off.
11. Restricted, blocked or kinked fuel line.
12. Failed fuel pump, pressure regulator and or fuel injectors.
For a prime suspect please visit website below. Good luck and have nice day.
Big Twin Carb EFI DTC Intructions codes Harley Davidson Forums Harley...

Jun 19, 2011 | 2000 Harley Davidson FLHTCUI Electra Glide...

1 Answer

2007 Ultra Classic Sound System Troubleshooting


2007 harley Davidson ultra,it will turn the motor over but will not run full of gas,spark plugs firing just wont start !!!

Jul 15, 2009 | Harley Davidson FLHTCUI Electra Glide...

1 Answer

Bike won`t start.


Your Crank Position Sensor, or Cam Position Sensor is likely to be the problem. If there is no signal from crank position sensor, bike will not fire the coil. ECM has no referance to position of motor. Making timing imposible.

May 30, 2009 | 2002 Harley Davidson FLHTCUI Electra Glide...

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

91 people viewed this question

Ask a Question

Usually answered in minutes!

Top Harley Davidson Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

Gills Lango

Level 2 Expert

195 Answers

Mike

Level 3 Expert

4336 Answers

Are you a Harley Davidson Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...