Question about Motorcycles

Open Question

Remove starter on 1986 suzuki 700 intruder

Solenoid just clicks..when try'ing to start

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 101 Answers

SOURCE: battery location for a 2004 suzuki intruder 800

Hi ...... Find where the battery is, under the seat or behind a side panel. Disconnect the black (negative lead usually with a 10mm spanner then disconect the red (positive) lead. The battery will be held in place with a 'rubber' strap or a bracket and depending on type of battery there may be a vent hose from the battery to the lower half of the bike, this just pulls off and remains in place until you replace the battery. Installation is reverse except you connect red (positive) first.
Let us know how you get on.

Posted on Jan 20, 2009

Ad
robotek
  • 1512 Answers

SOURCE: Exhaust Pipes on 1995 Suzuki Intruder VS

Hi Lcyr. 
Any changes you make to the exhaust system will alter the sound the bike produces. The more you cut baffles,and open up the exhaust, the louder it will get.  What you do alter to a greater extent,is the state of tune of the motorcycle. Any changes to exhaust or inlet plumbing will require a retune of the engine to suit the modifications. This can be subtle to dramatic. Opening up exhausts can often rob low end power where exhaust port scavaging is relient on some back pressure for maximum effect.
 Best to work directly with an engine tuner to do the mods that are known you can get away with, or buy aftermarket prebuilt pipes that have a known previously tested state of tune. Nothing worse than doing something, that then costs money to put back the way it was on finding out it didnt work as well as was hoped.. Hope this has helped you steer your custom mods a little.  I can say with certainty, that I have ventured to do what you are doing many times in the past, and it has always cost me more money in tuning and... and well more parts :)  Cheers
regards robotek

Posted on Jan 20, 2009

  • 321 Answers

SOURCE: battery removel for a 2004 suzuki 800 intruder

I know for the models till 2002 where the battery is located in front of the rear wheel.

Place the bike on her side stand
remove the negative battery lead at the left side, just below the transmission tube ( cone ) 10mm socket wrench
On the right side remove the security cap on the positive lead ( cross screwdriver ), then remove the positive lead.
The battery is hold in place with a 'floor plate'. remove both bolts of the floorplate ( on each side ) while holding the palte into place.
gently lower the plate and the battery.

I hope the 2004 model has the same assembly!

Posted on Apr 02, 2009

sodeep
  • 3267 Answers

SOURCE: starter will not turn over

Just uncap the wire going to the plugs. Kick the starter and hold the naked end of the wire close to the body. If you don't get a sharp sparking from the ends of the wire to the body then you'll know there is insufficient current being supplied to it by start solenoid...............sodeep

Posted on May 04, 2009

natuned
  • 22 Answers

SOURCE: suzuki gsxf 600 wont start

bridge the solenoid if the motor turns get a new 1 and fit.

Posted on Aug 12, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1986 Suzuki VS 700 Intruder will not start


Hi, Jacob and the usual suspects are:
1. Fuel tank empty.
2. The fuel tank has old dead gas.
3. Fuel tank bottom contaminated with ethanol sludge, dirt, water, rust, etc.
4. Fuel supply valve/petcock turned off.
5. Fouled spark plugs.
6. Engine flooded as a result of overuse of the choke.
7. Vacuum hose to the fuel supply valve/petcock disconnected, broken, cracked, or pinched.
8. Fuel valve/petcock or filter clogged.
9. Fuel line to carburetor or throttle body pinched, kinked or blocked.
10. Carburetor float stuck.
11. Fuel injectors clogged.
12. Fuel injectors stuck open.
13. Severely discharged or a damaged battery should have 12.5 volts or more and be able to pass a proper "LOAD" test if necessary, you may have a cursory reading of 12.5 volts or more but little or zero amperage the battery is faulty and must be replaced, AGM batteries fail in this scenario more so than lead-acid batteries.
14. Check battery terminals for damage or corrosion, check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter if necessary.
15. Loose or corroded wire connection at the coil or plug between ignition sensor and ECM module.
16. Spark plug cables in bad condition and shorting check for spark leakage in the dark, cable connections loose, or connected to the wrong cylinders.
17. Ignition timing incorrect due to a faulty ignition coil, ignition module or MAP, CMP, CKP, O2, TPS, ETP, IAC sensors.
18. Faulty neutral, clutch, kickstand safety switch.
19. Faulty fuel pump or fuse or relay.
20. A stuck bent or burnt valve.
21. Tilt sensor needs a reset.
22. Security system not disarming alarm needs a reset.
23. Check for engine trouble codes.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
1986 Suzuki Intruder VS700 Wont start
http://www.motorcycleforum.com/96-suzuki/137554-86-intruder-vs700-wont-start.html
Suzuki VS700 1985 Service Repair Manual
OEM parts for Suzuki
http://mybikemanuals.com/suzuki

Oct 13, 2017 | Suzuki VS 800 Intruder Motorcycles

1 Answer

How do i find starter solenoid on 04 intruder 800?


Hi, Paul the answer to this question is way above my pay grade for this situation, I would call or visit my local dealer or reputable shop's service/parts department and inquire about any possible quick fix, answers, or parts inquiry.
For more information about your issue and valuable "FREE" downloads that you will need please click on the blue links below. Good luck and have a wonderful day.
Amazon com Starter Solenoid Relay Suzuki VS 800 GL VS800GL Intruder 1993...
Motorcycle Starter Motors Relays for Suzuki Intruder 800 eBay
Suzuki VS700 Service Manual and 800
OEM parts for Suzuki
Suzuki VL800 Owner Manual

May 15, 2017 | 2004 Suzuki Intruder 800

1 Answer

1997 Suzuki Intruder 1400 won't start


Hi, Mo and the usual suspects are:
1. Ignition Switch not in the "ON" position.
2. Engine Run Switch in the "OFF" position.
3. Discharged battery, needs to be 12.5 volts or better and be able to pass a "LOAD" test, your battery may show 12.5 volts but has little or zero amps and must be replaced.
4. Check the battery terminals for damage or corrosion check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter.
5. Bank angle sensor needs a reset or is faulty.
6. FOB battery low or dead.
7. Faulty ignition switch.
8. Faulty starter button.
9. Faulty kickstand or clutch pull in switch/sensor.
10. Security alarm needs a reset.
11. Starter relay, solenoid or starter circuit wiring faulty.
12. Starter armature or field coils have failed.
13. Main fuse or circuit breaker may be blown or faulty.
14. The electric starter is working but starter clutch has failed.
15. Check for engine trouble codes.
For more information about your issue and valuable "FREE" downloads that you will need please click on the blue links below. Good luck and have a wonderful day.
Motorcycle Mechanics Institute
Suzuki Intruder 1400cc Starting Problems
What to do When Your Motorcycle Won Start
Suzuki Intruder VS1400 Service Manual
OEM parts for Suzuki
Suzuki VS1400 Owner Manual

Mar 29, 2017 | 1997 Suzuki VS 1400 Intruder

1 Answer

Wiring diagram starter solenoid 2004 suzuki intruder vs800


Hi, Wayne for this scenario you will need your service/owners manual if you can't find the first and best tool you ever bought for your Suzuki, despair not, for a mere zero $ you can download another one. For more information about your issue and valuable "FREE" downloads that you will need please click on the blue links below. Good luck and have a wonderful day.
2004 suzuki intruder vs800 wiring diagram Google Search
Suzuki Motorcycle Wiring Diagrams
Suzuki VS700 Service Manual
OEM parts for Suzuki
http://mybikemanuals.com/suzuki

Mar 05, 2017 | 2003 Suzuki VS 800 Intruder

1 Answer

2003 Intruder 1400. Can solenoid relay switch be bypassed?


Suzuki Intruder 1400cc Starting Problems - YouTube

? 3:50
https://www.youtube.com/watch?v=MZ65ch6j3Yc
Mar 13, 2013 - Uploaded by Lord Baccus
Starting issues with Suzuki Intruder 1400. ... You can mash the start button all you want but I won't do it. ... defective and ONLY sending 7volt to the Starter ~ by Bypassing it I get 12v to the Starter Solenoid / causing the starter to .... My problem was because I got low on gas and needed to switch it to reserve.

how to bypass a MMM on a suzuki marauder - YouTube

? 1:52
https://www.youtube.com/watch?v=gIoCBcOb7ZU
Mar 20, 2010 - Uploaded by josh p
bypassing the MMM on my 99 suzuki. To permanatly bypass, connect the y/g and y/b together and tape up ..

Nov 28, 2015 | Suzuki Motorcycles

1 Answer

Will not start...no sound or clicking noise from the starter button...the light come on


Hi Anonymous and the usual suspects are:
1. Ignition switch not in the "ON" position.
2. Engine run switch in the "OFF" position.
3. Discharged battery, loose, corroded or broken battery cables, especially the "NEGATIVE" cable at both ends (solenoid chatters).
4. Bank angle sensor tripped and ignition/light key switch not cycled to the "OFF" position and then back to the "ON" position.
5. Security alarm needs a reset.
6. Starter control circuit, relay, or solenoid faulty.
7. Electric starter shaft pinion gear is not engaging or over-running starter clutch slipping.
For more information about your issue, please visit the websites below. Good luck and have nice a day.
https://www.tradebit.com/filesharing.php/search/0/2003+suzuki+vs+800+intruder

Oct 19, 2015 | 2003 Suzuki VS 800 Intruder

1 Answer

My 1995 Suzuki VS800 Intruder wont start!!!


it could be the switch itself, also check the starter solenoid under the seat. if those are both fine check the wires under the tank and make sure you're getting a good connection.

Jul 25, 2012 | 1995 Suzuki VS 800 Intruder

1 Answer

1400 suzuki intruder electrical failure


The clutch safety switch on the handle bars might be bad. I changed mine when I had this problem and had no problems after this. Hope this helps.

May 03, 2012 | 1995 Suzuki VS 1400 Intruder

3 Answers

Suzuki 1400 intruder wont start.. just clicking noise.


It's most likely the connection to the battery. The screws dont tighten in well and you get the famous clicking....I replaced the stock philips screws with a hex bolt and after two years of trying to solve the problen have been starting everytime for the past year no problems. Another gie away is the intermitant starting problem gets worse when wet.

Aug 11, 2009 | 1991 Suzuki VS 1400 Intruder

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

171 people viewed this question

Ask a Question

Usually answered in minutes!

Top Motorcycles Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4536 Answers

yadayada
yadayada

Level 3 Expert

76846 Answers

kakima

Level 3 Expert

102366 Answers

Are you a Motorcycle Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...