Question about Motorcycles
The idol speed changes constantly and the reverse light is blinking. What does this mean?
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
The pilot jet is plugged up.
Remove the water trap bowl at the bottom of the petcock, (gas valve). Is there any water or trash in the bowl? Drain a cup of gas from the tank. Is there any water or trash in the cup? Dump it, clean it and re-mount it, ( not all bikes have a water trap bowl ).
Drain the carburetor. There should be a screw on the lower side of the carb float bowl. Remove the screw then replace it after the fuel drains. remove the carburetor from the engine.
Remove the float bowl and clean the entire carb with a spray carb cleaner from the auto parts store. Wear protective goggles to avoid getting spray in your eyes. Spray into all the little airways and fittings in the carb. About 3/8" from the main jet you will see a small brass screw. This is the pilot jet adjuster. Turn the adjuster 1/2 turn counter clockwise. Make a scratch on the casing around the adjuster so that the scrach lines up with the slot on the screw. From this point, carefully count the number of turns until the adjuster can be removed. Spray carb cleaner into the jet then replace the adjuster using the same number of turns such that the screw slot lines up with the scratch mark.
< < READ CLOSELY > >
Remove the idle screw and the air screw on the outside throat of the carb and spray into the screw holes as well. Be sure to put these two screws back in the same hole they came out of. IMPORTANT > do not tighten these two adjusters down. Only screw these in until they LIGHTLY seat. Now turn each adjuster one and one half turns outward. Put the rest of the carb back together, clean the air filter and install the carb. Let the float bowl fill then start the engine. This process should get you back on the road.
Please rate this solution. Thanks!
Posted on Apr 29, 2009
you have a switch going bad or a wire grounding out to one of the switches
either the neutral safety switch or the reverse light switch
Posted on Jan 20, 2010
Tips for a great answer:
Sep 27, 2015 | Yamaha 2005 Kodiak 450 Auto 4x4
Sep 26, 2015 | Yamaha 2004 Kodiak 450 Auto 4x4
Oct 23, 2014 | Yamaha 2004 Kodiak 450 Auto 4x4
Sep 06, 2014 | Yamaha 2004 Kodiak 450 Auto 4x4
Apr 02, 2014 | Yamaha 2005 Kodiak 450 Auto 4x4
Jan 18, 2010 | 2003 Yamaha YZ 450 F
33 people viewed this question
Usually answered in minutes!