Question about Honda Motorcycles
Wont start tryed pulling off check spark plug for fire got good blue spark tryed putting gas into to spark plug hole and tryed pullin off still would not start
What did the spark plug look like when you first took it out? Was it black/wet/sooty or was it a light tan/gray color. If it was black/sooty, then I would guess you need a coil. I know you said it had a good blue spark when you checked it, but if you poured a little bit of gas in the cylinder and it still wouldn't fire that would be my first place to check. If it ran briefly after you poured a bit of gas in the cylinder and then died, then it's a fuel supply issue. Remove the line that goes from the gas tank to the carb and make sure you have gas at the carb. If you have gas, then I would remove the carburator and take it apart making sure all the jets and passageways are clear. Use carb cleaner and an air attachment and if you still can't get it out, use a small wire to clear things up.
Reassemble and it should run, otherwise report back and we can go to the next step.
Posted on Jul 11, 2013
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
IF you have a battery get a new one ; put in new gas ; super; dsid you ajest any screws on carb. You tight need to run a prime tank right to your carb to prime it; and then hook your tank backup new gas lines to your carb. Now break out with the WD40 to spray all switches for rust.
Posted on Mar 23, 2009
SOURCE: honda cbr 600 wont start
hi, each lead has the specific number on it. if you do this correctly then they genrally give you an idea to where the sit in the coils( the way they bend :-) ) also i believe the coils are better off been attached to the frame once you are sure leads are in corect order and possitioned correctly in the coils.i just presumed the coils neaded earthing. make sure battery is pleny charged as a bad battery can just hinder. it is also very easy to flood the bike so just check the plugs again. if they are unusually wet then dry them off and try again . otherwise maybe try cleaning all electics.
hope this somehow helped
Posted on Apr 26, 2009
Look around the engine oil drain plug and fill area and see if there is an electric sending unit( small plug with a prong for a wire) that is screwed into the engine if so check to see if its unplugged / could be a low oil cut off switch that kills all power to the ignition if the oil is to low ( or the wire is unplugged)
Posted on Jun 04, 2009
Replace the spark plug caps and try again. On Honda's the cap is often part of the wire (a dealer part) NGK makes some inexpensive plug caps about $5 each. They should OHM out to 5000 anything above or below and you need to replace them. This should fix the problem.
Posted on May 27, 2010
Tips for a great answer:
May 08, 2017 | Honda CR 250 R Motorcycles
Nov 06, 2010 | 2005 Honda CRF 250 R
Jul 11, 2010 | 2002 Honda CR 250 R
May 08, 2010 | 1987 Honda XR 250 R
Mar 30, 2010 | 2002 Honda CR 250 R
Jan 03, 2010 | 2002 Honda CR 125 R
Jun 12, 2009 | 2005 Honda CR 125 R
May 03, 2009 | 2003 Honda CR 250 R
Apr 22, 2009 | RTO Pit Bikes
111 people viewed this question
Usually answered in minutes!