Question about Motorcycles

1 Answer

I have a 07 gs500f with just under 26,000 miles, cleaned carbs and synced but it's hesitating between 2500 rpm and 6000 bad. Took carbs off and confirmed jets were clean and still the same problem

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 109 Answers

Did you check the screen T the fuel tank take out the fuel shut off from tank see if screen gumed up

Posted on Jul 11, 2013

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

tellme2
  • 137 Answers

SOURCE: 94 yamaha xj 600 want rev over 6000 rpm

hi m8,,1st,, would u no if the bike has been resricted ,,to 33bhp,,if it hasent2nd,, have a look at the spark plugs,, start her up rev until it coffs or wont rev then hit the kill switch,,see wot colour the plugs are ,,they should a biscuit brown,,if not clean them up or change them,, 3rd test,start her up again throttle it a few times ,,untill shez warm,, then ,this sounds not nice, but either spit on your hand or dip hand in sum water, then quickly touch each exhaust down pipe, and make sure there isnt a pipe cooler than the other 3,, if u do find there is that would narrow the test down to that cylinder thats playin up,,try that 1st m8,, then come back if any probs still, and il take u threw next steps,,

Posted on Apr 19, 2009

  • 190 Answers

SOURCE: Cleaning Carb Jets

not to a trained ear also go by rpm and spark plug color

NOTE: use copper wire to clean jets, sync is just thottles are same position as all carb's just leave them adjustments alone will be fine if are out use a 1/8 drill an place in between piston/butterfly to carb bore to sync/calibrate

better use a manometer for adjusting screws

depends on condition of org parts

worn = richer running

new = lean an clean

also if changed the exhaust system need to
re-calibrate carbs for max performance

Posted on May 09, 2009

  • 3567 Answers

SOURCE: 1981 gl1100 has 4 keihin carbs bike sat 7 years

39dcb9a.gif5ab3c33.gif
648d54b.gifWhen removing the pilot jet screw, count the number of turns to remove. Put the screw back the same number of turns then unscrew 1/4 turn.
A “very helpful” rating on this answer? Thanks!

Posted on Jul 02, 2009

ollie reece
  • 1167 Answers

SOURCE: 2007 klx 250 runs only when choke is on.

hi buddy on carb is a mixture air screw fiddle with this till it runs if it doesnt i have another plan buddy get back to me with results 8ce62f2.jpg

Posted on Oct 12, 2009

  • 311 Answers

SOURCE: ltz 250 wont idle needs full choke to run.cleaned

hi,sounds to me like the air fuel ratio is all up the ***,locate the air/fuel screw on the carb(normally on the side)screw the screw right in untill it stops,then back the screw out 1.5 turns,this should get the bike to run without the choke,once you have the bike running simply turn the screw in or out untill the bike settles into a nice steady idle,should be good to go,hope this helps...cheers

Posted on Mar 27, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Kawasaki Vulcan 500-26,000, miles.new rotor and stator. Batty It is not quite chargeing enough.it has to be changed every wk to 10 days itis1991kawa.Vulcan 500


The battery charge voltage should be about 13.5-15.5 volts dc when speed is about 2000-2500 rpm. The rectifier and/or voltage regulator could be bad or the motorcycle could have a wiring issue such as an intermittent connection/short etc.

Nov 21, 2014 | Motorcycles

1 Answer

Carburetor tune up


cylinder is letting something up to plug. sounds like a one in a million factory flaw.

Jun 12, 2013 | Motorcycles

1 Answer

I have a 2008 mercury Milan with nearly 60k miles on it. When I come to a stop the rpm drops by 1000 then recovers quickly. What should I do to fix the problem? Any suggestions will be greatly appreciated.


Check out related help links to troubleshoot these problem:----Click the link below:---Idles Fine but RPM jumps in drive mode? http://technoanswers.blogspot.in/2012/07/idles-fine-but-rpm-jumps-in-drive-mode.html
---------Mitsubishi Lancer rpm needle bounces? http://technoanswers.blogspot.in/2012/02/mitsubishi-lancer-rpm-needle-bounces.html
--------How to adjust rpm on 2009 dodge charger SRT8?


http://schematicsdiagram.blogspot.com/2011/12/how-to-adjust-rpm-on-2009-dodge-charger.html
---------
Engine cuts out at 3000 RPM? http://schematicsdiagram.blogspot.com/2011/12/engine-cuts-out-at-3000-rpm.html

---------

Cold start problem and vehicle shudder around 2500 to 3500 rpms
http://repairhelpcenter.blogspot.com/2012/10/cold-start-problem-and-vehicle-shudder.html

---------
High rpm in neutral? Inconsistant high RPM in neutral? http://technoanswers.blogspot.in/2012/02/high-rpm-in-neutral-inconsistant-high.html

-----------
Jetski Sputters and Low RPM? http://whatisbyme.blogspot.in/2012/07/jetski-sputters-and-low-rpm.html

--------
Fuel Injection Problem And RPM suddenly increases http://whatisbyme.blogspot.in/2012/07/fuel-injection-problem-and-rpm-suddenly.html

----------
2005 Toyota Highlander: Engine runs hard RPM below 3000? http://whatisbyme.blogspot.in/2012/05/2005-toyota-highlander-engine-runs-hard.html

---------
1987 Toyota Camry: RPM Drops going Up hills? http://whatisbyme.blogspot.in/2012/05/1987-toyota-camry-rpm-drops-going-up.html

-----------
Cruise Control stops working, Excessive cranks to start the engine and RPM goes max 2500 http://whoisbyme.blogspot.in/2012/07/cruise-control-stops-workingexcessive.html

----------
1990 Toyota 4Runner: Engine cuts off when reaches 2000 RPM?


http://whatisbyme.blogspot.in/2012/05/1990-toyota-4runner-engine-cuts-off.html

------------
1999 Toyota Camry: Erratic stalling and high engine RPM at idle?


http://whatisbyme.blogspot.in/2012/05/1999-toyota-camry-erratic-stalling-and.html

---------
1995 Toyota LS: Misfire at idle or low RPM http://whatisbyme.blogspot.in/2012/04/1995-toyota-ls-misfire-at-idle-or-low.html

-----------
Lexus RX: Tapping noise under Valve Cover At Low RPM? http://technoanswers.blogspot.in/2012/04/lexus-rx-tapping-noise-under-valve.html

----------
These will help.
Thanks.

Nov 22, 2012 | Cars & Trucks

1 Answer

Driving on the road the RPM goes higher wituout speedind


Check out related help links to troubleshoot these problem:----Click the link below:---Idles Fine but RPM jumps in drive mode?http://technoanswers.blogspot.in/2012/07/idles-fine-but-rpm-jumps-in-drive-mode.html
---------Mitsubishi Lancer rpm needle bounces?http://technoanswers.blogspot.in/2012/02/mitsubishi-lancer-rpm-needle-bounces.html
--------How to adjust rpm on 2009 dodge charger SRT8?


http://schematicsdiagram.blogspot.com/2011/12/how-to-adjust-rpm-on-2009-dodge-charger.html
---------
Engine cuts out at 3000 RPM?http://schematicsdiagram.blogspot.com/2011/12/engine-cuts-out-at-3000-rpm.html

---------

Cold start problem and vehicle shudder around 2500 to 3500 rpms
http://repairhelpcenter.blogspot.com/2012/10/cold-start-problem-and-vehicle-shudder.html

---------
High rpm in neutral? Inconsistant high RPM in neutral?http://technoanswers.blogspot.in/2012/02/high-rpm-in-neutral-inconsistant-high.html

-----------
Jetski Sputters and Low RPM? http://whatisbyme.blogspot.in/2012/07/jetski-sputters-and-low-rpm.html

--------
Fuel Injection Problem And RPM suddenly increaseshttp://whatisbyme.blogspot.in/2012/07/fuel-injection-problem-and-rpm-suddenly.html

----------
2005 Toyota Highlander: Engine runs hard RPM below 3000?http://whatisbyme.blogspot.in/2012/05/2005-toyota-highlander-engine-runs-hard.html

---------
1987 Toyota Camry: RPM Drops going Up hills?http://whatisbyme.blogspot.in/2012/05/1987-toyota-camry-rpm-drops-going-up.html

-----------
Cruise Control stops working, Excessive cranks to start the engine and RPM goes max 2500 http://whoisbyme.blogspot.in/2012/07/cruise-control-stops-workingexcessive.html

----------
1990 Toyota 4Runner: Engine cuts off when reaches 2000 RPM?


http://whatisbyme.blogspot.in/2012/05/1990-toyota-4runner-engine-cuts-off.html

------------
1999 Toyota Camry: Erratic stalling and high engine RPM at idle?


http://whatisbyme.blogspot.in/2012/05/1999-toyota-camry-erratic-stalling-and.html

---------
1995 Toyota LS: Misfire at idle or low RPMhttp://whatisbyme.blogspot.in/2012/04/1995-toyota-ls-misfire-at-idle-or-low.html

-----------
Lexus RX: Tapping noise under Valve Cover At Low RPM?http://technoanswers.blogspot.in/2012/04/lexus-rx-tapping-noise-under-valve.html

----------
These will help.
Thanks.

Nov 22, 2012 | 2008 Toyota Avalon

1 Answer

Just bought a 1993 suzuki gsxr 750. has been sitting in a garage for 2 years. we took the carbs off and cleaned them really well, changed the oil, and air filter and we added new gas. bike starts up and...


If is runs better with full choke, then the bike is lean, check for air leaks at the carb manifold, vacumn cracked hoses, non standard exhausts, perhaps the mufflers have rusted out while sitting

Apr 24, 2011 | 1993 Suzuki GSX-R 750 WP

1 Answer

How do i get a manual on how to sync the carbs on my 1987 YFZR1000? It doesn't hold idle when its cold, but once it warms up it idles at about 2500 rpm. it also pops a little bit when close the throttle...


Sounds like the idle is set too high. Around 900 rpm is good.
These folk may have a manual for you:

http://www.repairmanualclub.com/motomanuals/index.php

Feb 08, 2011 | 1987 Yamaha FZR 1000

2 Answers

RPM stall at 5000/6000


Definitely carb problems. Dieaphrams need to be checked and the carbs need to be synced.

Sep 30, 2009 | 1997 Suzuki GSF 600 S Bandit

1 Answer

I have a 2006 Suzuki GS500F. At stops it


possibly needs a carb clean, but sounds more like it needs a valve adjustment.

Sep 24, 2009 | 2006 Suzuki GS 500 F

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

92 people viewed this question

Ask a Question

Usually answered in minutes!

Top Motorcycles Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

yadayada
yadayada

Level 3 Expert

75197 Answers

kakima

Level 3 Expert

102366 Answers

Are you a Motorcycle Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...