Question about Motorcycles

1 Answer

Honda activa 2005 front wheel bearing size pls

Posted by Anonymous on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Bearing number of Honda Activa for any model is 6004 for Rear Wheel and 6201 for front wheel. I get it replaced recently. SKF are good bearing you can use as spare. I did not cost more. 10 Jan 2015. it

Posted on Jan 10, 2015

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

hakimmadina_
  • 155 Answers

SOURCE: speedometer is not functioning properly in honda

Hi...
first check your speedometer cable if it is not destroyed. This is caused by pulling your motorcycle reversed or backwards too often. So, all you have to do is replace it. Here in the Philippines it will just cost you P70.00. That's almost $2 USD. I don't know in your country.
You have a nice Honda activa motorcycle!!!

Posted on Jun 24, 2009

bazzz7071
  • 338 Answers

SOURCE: to fit front wheel bearings honda xr 125

Hello unless there something unusual about the front wheel.
bearing removal is not difficult
once you have the wheel off remove the seals on both sides.
remove any internal snap rings or retaining rings.
now the correct way to remove the bearings is with a bearing remover its a shaft with an expandable tip and a weighted slide. when the end is inserted into the center race of the wheel bearing then the shaft is turned to expand the expandable end locking it in place then you use the weighted slide on the shaft to drive it out.
replacing the bearings easiest way is ti use a press not everyone has one of those a bearing driver or and old socket can be used to drive in the new bearings just make sure it is smaller than the inside diameter of the bearing hole and just enough to make contact with the outer bearing race do not force or make contact with the center race.
Hope this helps you out

Posted on May 11, 2010

Testimonial: "many thanks steve!"

Woods Goat
  • 85 Answers

SOURCE: to fit front wheel bearings honda xr 125

Support the bike. Remove front axle nut and remove the axle, releasing the front wheel. Using a flat screwdriver, remove the rubber seals. Use a blunt object that will fit through the axle hole along with a hammer to drive each of the 2 bearings out from the back side. Work by tapping lightly and working around the bearing a little at a time until it pops out. Replace each of the bearings in a similar fashion, working slowly and carefully until the first bearing is in. Install the center bearing spacer tube and install the other bearing. Next replace the dust seals and reinstall the wheel.

Posted on Jun 12, 2010

  • 8909 Answers

SOURCE: i have honda activa 2005

If you replace the silencer, you will restore the back pressure that is essential for 2 stroke engines to start and run smoothly.
Check out ebay

Posted on Jan 09, 2011

wd4ity
  • 4565 Answers

SOURCE: im looking at a new front wheel 4 my 99 nighttrain

I'm pretty sure your '99 model uses the 3/4" wheel bearing while the later year models use a 1" bearing. I'm not sure what year they changed on your Softail. By looking for a change in the part number for the wheel bearing in a parts book will tell you what year they changed.

Good Luck
Steve

Posted on Jan 31, 2011

Testimonial: "thank you for your help"

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I purchase oe ACTIVA scooter and I want duplicate key of my ACTIVA. For this what can I do for it?


Hi, Suresh for this situation I would call my local dealer or reputable shop's service/parts department and inquire about any possible quick fix, answers, or parts inquiry.
For more information about your issue and valuable "FREE" downloads that you will need please click on the blue links below. Good luck and have a wonderful day.
Flip Keys India first online key store
http://www.minda.co.in/minda/ProductCatalog/Catalog/KeyCatalogue1.pdf
Keys of honda activa lost can get new or duplicate keys from honda activa...
Honda activa 2009 Owner Manual
http://www.partsfish.com/page/oem-parts-for-honda

Apr 04, 2017 | 2005 Honda Activa

1 Answer

Pls help me my Honda activa 125cc air pipe leak petrol heavy petrol leak pls help... I am scared...


Hi, Anonymous and the usual suspects are:
1. Damaged or restricted fuel tank venting system.
2. Loose float bowl screws.
3. Damaged float bowl o-ring.
4. improper fuel level in the float bowl.
5. Worn or dirty inlet valve or seat.
6. Damaged or leaking float assembly.
7. Particle contamination in inlet fitting cavity.
For more information about your issue and valuable "FREE" downloads that you will need please click on the links below. Good luck and have a nice day.
http://www.xbhp.com/talkies/help-me/21532-petrol-drops-leak-over-flow-pipe-activa.html
Honda Activa Fuel Leak
http://www.motorscooterguide.net/Manuals/Honda_CH150_Service_Manual.pdf
http://www.partsfish.com/page/oem-parts-for-honda
Honda Activa Std Dlx Owners Manual

Jan 07, 2017 | 2005 Honda Activa

2 Answers

How can I remove Activas front mudguard?


Hi, Arsalaan for more information about your question and valuable "FREE" downloads that you will need please visit the websites below. Good luck and have a nice day.
http://campaigns.hondampe.com.au/Motorcycles/manuals/SCV100%20LEAD.pdf
Honda Activa Top 10 Service Tips
Milaege Solution For Honda Activa
How to replace wheel bearings Honda Activa part 1


Mar 14, 2016 | Motorcycles

3 Answers

Hai i have a 2005 honda activa.. m planning to drive to mysore..can you suggest some things which i need to get it checked before i leave


Hi, You don't need to get much. Just change the spark plug and oil the chain if so equipped.
Change the oil too and have a nice trip. Good luck.

Sep 22, 2011 | 2005 Honda Activa

1 Answer

I have honda activa 2005 model n i m having problem 1>my activa knocks a lot (ie. a big noise comes out from silencer ) bcoz of whch my activa dosent start


If you replace the silencer, you will restore the back pressure that is essential for 2 stroke engines to start and run smoothly.
Check out ebay

Jan 09, 2011 | 2005 Honda Activa

1 Answer

CAN YOU PLS TELL ME HOW TO CHANGE ENGINE OIL FOR HONDA ACTIVA . REQUEST YOU TO MAIL WITH WITH POSSIBLE DIAGRAM ON snasree@yahoo.com


It will be best that you can do it at the Honda service which is close to your place. Have an appointment and it can be done in an hour so that the right oil and the service book is updated accordingly.

Sep 29, 2010 | 2005 Honda Activa

1 Answer

Can a spoke wheel off a 2006 vtx 1300C go onto a 2005 vtx 1300 R?


yes, the back tire is the same size, with all the same bearings and shaft.. the front is a different size, but the shaft and bearings holding the wheel are the same.

Aug 25, 2010 | Honda VTX 1300 Retro Motorcycles

1 Answer

Wheel size for a honda cbf600na year 2005


BOTH WHEELS ARE 17" HERE ARE THE ARE SIZES

FRONT
120/70-ZR17
REAR
180/55-ZR17

Jul 14, 2010 | 2005 Honda CBF 600

1 Answer

Old Honda activa giving only 28 kilometer of mileage per letter. how to make better mileage?


Please check ur air pressure keep 22 in front & 32 in Rear check the tuning of the carb and status of ur clutch, and exhaust vale opening time

Mar 01, 2010 | 2005 Honda Activa

2 Answers

How to open dome of honda activa for clean spark plug


You need to open the seat of honda activa and open the screw present in the space provided for tool kit and helmet. Next remove the two screws holding the back rest (the ones above the tail light). Now just lift the body by holding the front end (the one which is towards the steering) there will be a rod below pull it up and let it the body rest on it. You will find the spark plug on the side of the engine (you need to pull out the cap housing the spark plug).

Jun 14, 2009 | 2005 Honda Activa

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

200 people viewed this question

Ask a Question

Usually answered in minutes!

Top Motorcycles Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

yadayada
yadayada

Level 3 Expert

75197 Answers

kakima

Level 3 Expert

102366 Answers

Are you a Motorcycle Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...