Question about Motorcycles

Open Question

92 seadoo won't start

We have a 1992 Seadoo bombadier xp. It turns over great but won't fire. I put in fresh gas. It has fresh oil and new NGK plugs. Any ideas?

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
vortash
  • 431 Answers

SOURCE: 1992 kawasaki Vulcan 750 stops running

Sounds like what you realy need to do is remove the carb jets and give them a good clean , this if I am right is the twin V 8 valve engine with twin Klhein carbs , make sure also your air filter is not dirty and check tank fuel filter ,, other than that you may be intrested in the manuel obtainable from this site
http://www.haynes.com/products/sfID1/8/sfID2/9/sfID3/81/productID/399
hope this helps good luck .. and Live long and prosper lol .. Regards Vortash

Posted on May 12, 2009

Ad
redbeard00
  • 957 Answers

SOURCE: 1992 kawasaki Vulcan 750 stops running

Check the intake manifold/s, even a small leak will make it run poor. Being stored for five years then putting it into use, you may have a blocked main jet. Sea-foam is a great product and I would have used that product to store the bike but not to get it running. It is slow acting so it doesnt work like carb cleaner.

Posted on Jun 01, 2009

usmc69
  • 16 Answers

SOURCE: 92 honda cb 750, oil light will not go out, bike won't start

Look around the engine oil drain plug and fill area and see if there is an electric sending unit( small plug with a prong for a wire) that is screwed into the engine if so check to see if its unplugged / could be a low oil cut off switch that kills all power to the ignition if the oil is to low ( or the wire is unplugged)

Posted on Jun 04, 2009

DickCanFixIt
  • 948 Answers

SOURCE: 1986 Suzuki GS 450 won't start

Take the carburetors apart and either rebuild them or clean them thoroughly.

Posted on Jun 19, 2009

  • 677 Answers

SOURCE: 1992 yz 250 won't start

A couple of things.1.Check the fuel oil mixture is correct.It seems rich.2.Check that the carby is not running to rich.With new reed valves etc.it may need to be set back to the original manu. specs.With older parts it may have been retuned to make it run with the old parts.(carby jetting etc.)3 make sure the fuel oil mix is using a good quality oil.It does make a world of difference.I hope this is a start to get you going.

Posted on Aug 24, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

P,w,c 96 seadoo bombardier won't start only fires every now and then


Yes, the water coming out of your exhaust is part of the cooling. It cools the exhaust pipe and the rubber hoses so they won't melt.

Nov 30, 2016 | Boating

1 Answer

Built engine from crank up install spark no start 1992 xp seadoo 587 twin carb what is the troubleshooting spark gas still not up after 30 min of cranking


engines need fuel and air mix, compression and a spark at the right time.

Check your compression. New rings can stick

Check the ignition timing.

Check for a spark in the dark. See if the plug is sparking.

Check if the plug is wet? If it is you are getting fuel and air.

Check the air filter passages for blockages. Check the carb for blockages. Did you stuff anything down a hole to stop dirt getting in?

Aug 09, 2016 | Sea-Doo US SeaDoo RS2 Seascooter

2 Answers

Why after I flipped my seadoo and got water in the motor, it wont stay on without pressing the start button, why? how can I fix this? The seadoo is a 1999 xp


I would say that you shorted out the item on the other end of your start switch due to it working backwards. Check the continuity of the wires from switch & check the switch.

Jul 21, 2014 | 1999 Chevrolet Silverado 1500

1 Answer

The impeller on my seadoo turns and there's RPMs, but no power. What could be wrong?


Hi, the drive shaft is most likely stripped which will slip when you put it under load. Regards Phil.

May 30, 2012 | Boating

1 Answer

My 1996 Seadoo xp, one of the carb's flaps is


either run it and spray carb cleaner into it (idled up a little) or start adding good in tank cleaner to fuel.

Jul 09, 2011 | Boating

1 Answer

I require a wiring diagram for a seadoo bombadier gtx 580 it is a1994 model


I looked up a picture of what your talking about and it looks like your talking about a jet ski? This section is for car audio, more specifically car amplifiers

Feb 24, 2010 | Car Audio & Video

1 Answer

Sea doo jet ski won't get full throttle. It idles fine but once you hot gas it regarding up and down


I am not sure of the model that you have,so its a bit hard to help.If you have a seadoo and you want great help,I would go to seadooforum.Its the best site with really good,and also total knowledge of all things Seadoo.I have one also.The help is unsurpassed.I have a seadoo also.Hope this helps you

Feb 03, 2010 | Sport & Outdoor - Others

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

32 people viewed this question

Ask a Question

Usually answered in minutes!

Top Motorcycles Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4521 Answers

yadayada
yadayada

Level 3 Expert

76109 Answers

kakima

Level 3 Expert

102366 Answers

Are you a Motorcycle Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...