I took apart my moped, and as I was putting it back together, I lost the place for a wire. It has two ends, looking like it is for the battery or something. Each end is like this shape. O=-----------=O one side is gold, one side is silver. I need to know what this goes to to have my moped work again.
SOURCE: need wire diagram
A manual can be downloaded from the following link, the wiring diagram is located toward the end of the manual.
http://www.star-mfg.com/documents/Manuals/Star/Fryer/Electric/C_530TD_530TED_-_2M-Z6600.pdf
Hope this helps, please rate me!
SOURCE: need wiring diagram for Kawasaki FC420V engine
Send me your email and I'll send you a copy if this dosn't work...
This can be blown up too.
SOURCE: I TOOK THE FRONT CONTROL PANEL OFF MY YAMAHA
Tom...what can I say - what you did was not very smart. Next time draw a diagram BEFORE you take the wires off!
SOURCE: wiring diagram
Sorry, don't have a diagram; but:-
The +12V supply end goes to an "+12V when Ignition on" source.
Note that the positive side of the coil also connects to "+12V when Start" source, to ensure maximum supply voltage to coil while cranking engine.
SOURCE: Audio Technica PRO-35: need wiring diagram for mic end
If you feel the shield goes to the middle, try red on one terminal and white on the other. If not, reverse it.
If it's labeled on the circuit board...pin 1, pin 2, pin 3, then pin 1 is usually ground, pin 2 is hot (red), and pin 3 is cold.
1,081 views
Usually answered in minutes!
×