2007 mitsubishi outlander periodic inspection light on after oil change

SOURCE: how do you reset change oil light on mitsubishi outlander

Turn the key off.

Press the "Info" button on the left of the dash cluster until your maintenance miles/months screen is displayed.

Press and hold the "info" button until the maintenance screen begins flashing.

Release the "info" button and then push and hold it it for one second.

Your Maintenance intervals should reset to +6 months and +7500 miles since the last interval amount.

Note that if you have not reset it for more than one interval, you may need to do it more than once. If you have not done it for many intervals, you may need to have it reset with the scantool at a dealer, as I have run into a handful of vehicles that the oil change reminder locked up after 3-4 "intervals" were skipped/not reset.

SOURCE: How do I change the oil and fuel filters on My

Is this a diesel? I just changed my oil and oil filter. You have to remove the plastic engine top cover first and you will see the oil filter in the front right. Black with hex nut on top (my 1 1/4 AF socket fitted). You have to disconnect the bracket holding some wiring. Pull the wiring forward to access the nut on top of the filter. Undo and remove/replace filter.
Under the car you will find a small hatch in the underside plastic cover held in place by three 10 mm bolts. Remove this to access the 19 mm drain plug. Drain old oil and refill with 4 ltrs 5/30 fully synthetic. Top up if necessary after running engine but DO NOT overfill.
The fuel filter is on the bulkhead at the back of the engine on the right side. I wont be changing that for a while!

SOURCE: Just did the oil change in outlander 6 cilinder

yes,but its cheaper to buy your own filter at autozone and take it with you

Testimonial: "Thank's for your help!!!!"