Blows fuse for brake lights.unpluged connector for trans n cruise control still blows fuse
SOURCE: 2000 pontiac emergency brake stuck. how do i
Are you in a Northern Climate were road salt is used during winter? The emergency brake problems I have encountered tend to be due to rust and corrosion accumulating on the wires and metal pivot points that operate the brake via the emergency handle on the center console.
Get underneath the car (chock the wheels---ALL FOUR! with bricks or large chunks of wood---be sure the car is in PARK!) and find the wire that connects to the handle of the brake---follow it to the rear brakes, and you will see a split where it goes to the L and R sides via a sliding clasp of steel that looks like a C, and has wires running over the top, and to each rear brake.
At this point, grab the wire on one side of it and PULL HARD several times, slack between pulls. Do this for each side---that should release the assembly, and the shoes from holding the drum.
After you have done this, lubricate the pivot points and the wire connection to the brake handle with TRI-FLOW (NOT WD-40)or another teflon based lubricant.
SOURCE: no turn signals or brake lights
you need to replace the turn signal function switch in the column your brake lights also run through this. but your window brake light is on another circuit .i have done at least 75 of these
SOURCE: abs and traction control light faults after a brake job. 2005 Pontiac grand prix
You have a bad sensor at one of the tires that need replacing that operates ABS and traction control. If you take it in to a shop it will run $130 but they can find which sensor is causing the problem. But if you do it you might have to replace all 4 sensors to make sure you got the right one. Every hard to diagnoses. Its better for the shop cause they can get electrical read outs for each sensor.
SOURCE: abs and traction control lights coming on
Its the abs sensor, if you encounter an ice patch or snow you won't even be able to stop because the pedal will will push back and make the rip grind noise. If you pull the ABS fuse out, you won't have ABS but you can stop and you won't have the grind noise and back pressure for now. Its safer to not have ABS when the sensor is faulty.
Simon Atari
[email protected]
SOURCE: abs light and trac off light on
hey, ihad this problem with abx and trac off light on all the time even after having replaced the wheel bearing twiice. how i fixed it was to replace the wiring harness and poof issue resolved. a technical service bulletin is available for this issue
266 views
Usually answered in minutes!
×