SOURCE: Wire loose
The blue wire is the wire to supply voltage to your "running" lamp filament in the buld. Take your bulb out and look at the back side of it. It should have two round connectors on it. One is for the turn signal and one is for the running light. The "running light" should be on when you start the bike. When you turn the turn signal on on that side, the turn signsl filament should light up along with the running light filament.
With the bike running and headlight on, all four turn signals should lit as "running lights". Earlier models did not have the "running lights' on them. Now, when you turn the turn signals on either side the bulbs should blink much brighter. If you press and hold both the right and left turn signal switches, you're four way flasher signal should come on. If you still can't figure it out, Drop me a line at [email protected] and I will scan a wiring diagram in for you and send it to you. Good Luck Steve
Testimonial: "Great advice,Really knows what hes talking about!!!"
Not necessarily a bare wire. Could just be a slight broken spot in the insulation. Check the wiring inside the rear fender. Sometimes the tire gets into the wiring harness and chews things up a bit. This usually happens on lowered bikes.
TAIL LIGHT NOT WORKING
It
can be faulty tail light bulb or its issue with tail light control
switch or its wiring's are short.
Check the voltage at fuse slot of tail light.Do you receive 12 volt
there.If not,then it says tail light switch is not receiving power supply.
---------
There
are few help links related to your problem.I suggest you refer the list and
check the help links.Click the link below:-----
----------
http://schematicsdiagram.blogspot.com/2011/12/right-turn-signal-not-working-on.html
--------
http://schematicsdiagram.blogspot.com/2011/12/only-one-side-indicator-light-working.html
-----------
http://schematicsdiagram.blogspot.com/2011/12/turn-signals-not-working-on-1987-jeep.html
-----------
SOLVE YOUR 4 WAY FLASHER RELATED PROBLEMS HERE
http://repairhelpcenter.blogspot.com/2012/11/4-way-flasherturn-signal-flashersignal.html
----------
http://whatisbyme.blogspot.in/2012/04/1994-toyota-camry-bypass-tail-light.html
-----------
--------
---------
----------
http://schematicsdiagram.blogspot.com/2011/12/car-tail-lights-not-working.html
----------
These details will help.
Thanks.
http://technoanswers.blogspot.in/2012/04/2008-toyota-rav4-replace-tail-light.html
--------
2003 Chevrolet S10 Tail light Fuse
http://schematicsdiagram.blogspot.com/2012/11/2003-chevrolet-s10-tail-light-fuse.html
---------
Chevrolet Parking light and Tail lamp light
Wiring diagram
http://schematicsdiagram.blogspot.com/2012/11/chevrolet-parking-light-and-tail-lamp.html
----------
Car Tail Lights Not Working?
http://schematicsdiagram.blogspot.com/2011/12/car-tail-lights-not-working.html
----------
Turn Signal Not working
http://technoanswers.blogspot.com/2012/11/turn-signal-not-working.html
----------
Right turn signal not working on Pontiac Car?
http://schematicsdiagram.blogspot.com/2011/12/right-turn-signal-not-working-on.html
--------
Only one side indicator light working on car?
http://schematicsdiagram.blogspot.com/2011/12/only-one-side-indicator-light-working.html
-----------
Turn signals not working on 1987 Jeep
Wagoneer?
http://schematicsdiagram.blogspot.com/2011/12/turn-signals-not-working-on-1987-jeep.html
-----------
SOLVE YOUR
4 WAY FLASHER RELATED PROBLEMS HERE
http://repairhelpcenter.blogspot.com/2012/11/4-way-flasherturn-signal-flashersignal.html
----------
Thesedetails will help.
Thanks.
1,001 views
Usually answered in minutes!
×