Question about 2004 Suzuki GZ 250 Marauder

Open Question

Valve clearence looking for valve clearence on a ryobi generator. RG-2700A

Posted by on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My ryobi 2200 generator rebs hi and low over and over it works but i feel it might turn off


You need to clean carburator. The bowl float opens and closes the pin valve. The float may have a leak, if gas inside float, it needs replacing. Or the valve is sticking. Get a good carb cleaner product at parts store. If its very bad you may need to take carb apart and soak the parts to clean them. Make sure you are turning off gas valve when not in use. You should turn off gas valve and let the motor run out of gas before using kill switch to drain gas from carberator each time its run. Then this won't happen. If no gas valve, buy one and install. Its worth it.

Jan 20, 2014 | Electrical Supplies

1 Answer

What type of oil to use in RYOBI RG-6900K


Good day
Can you tell me what kind the oil using the generator
ryobi rg7900k.
Thanks

Oct 23, 2012 | Electrical Supplies

1 Answer

Valve tappet clearence for Nissan xtrail qr25 engine


you should be able to find these on nissan forums

Jun 29, 2012 | Nissan XTrail Cars & Trucks

2 Answers

I have a Ryobi RG6900 Generator,how do i connect it from the generator to the distribution board.


I use a COBRA. It is a lead with a plug at either end. Plug one end into the generator (output) and the other into any household plug outlet. (Set to the ON position)
Before doing so ensure that no outside power can enter through your DB board (switch the Mains Switch to the "off" position) Also switch off (at the DB board) any circuits that may cause a demand of more than 21 Amps (Stove, Geyser, Swimming Pool Pump etc)
Start the 6900 and wha-la you have power to all circuits not switched off at the DB Board.

I typically leave the light circuits, one of the plug circuits (to run the TV, Decoder etc) Security Circuit,and Garage Door opener switched on.
When mains power returns First stop & disconnect the 6900, remove the COBRA and then switch on the Mains and other circuits.

Dec 29, 2011 | Motorcycles

1 Answer

I just puechased a ryobi rg 6900 generator and it does not hahe a battery or operators manual. I need to know how to operate it and what size battery to buy


The RG-6900 Ryobi generator does not have (or need) a battery. It is a manual type with cord start. Voltages and specifications may differ slightly depending on which country the unit is intended for (110V vs 220V). The same applies to warranty and servicing agents.

Send your email address to eggie-at-scheffler-dot-co-dot-za and I will mail you the manual in pdf format (820kb). Substitute "at" and "dot" with the usual symbols to mail me.

i just puechased a ryobi rg 6900 generator and it does not hahe a battery or operators manual. I need to know how to operate it and what size battery to buy

Feb 27, 2011 | Garden

3 Answers

A friend living in the country bought a Ryobi RG-950 generator. She wants to run 1 of her 2 computers or a TV 1 light at night and asked my advice. I told her that running any electronic equipment off a...


It's best to run all electronics through a UPS and surge protector. Small generators like the RG-950 are really for small power tools and lighting. The Ryobi RG-950 is only rated 650 watts which really means about 450 watts (70%) for continuous use. In general, a basic desktop or a laptop should be OK. A TV up to 25 inches and a 100w lamp, should be OK. If you try doing both at the same time, expect smoke followed by lights out. A UPS and Surge Protector are a must on small generators due to their poor voltage and frequency regulation. The UPS should be a good quality one that deals with Brownout, Overvoltage, and frequency deviation. ALWAYS USE A SURGE PROTECTOR!

Sep 05, 2010 | Winco 5500 Watt TriFuel Power System w/...

Not finding what you are looking for?
2004 Suzuki GZ 250 Marauder Logo

Related Topics:

33 people viewed this question

Ask a Question

Usually answered in minutes!

Top Suzuki Experts

yadayada
yadayada

Level 3 Expert

76682 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4536 Answers

Richard
Richard

Level 2 Expert

83 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...