Question about 2006 Harley Davidson FLHRCI Road King Classic

1 Answer

Lowering bike rear kit

Can anyone tell me if there is a rear lowering kit for a 2006 Road King (FLHRCI) with hard leather bags? Can't seem to get a good answer on the net.

Posted by on


1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert who has answered 20 questions.


    An expert that hasĀ over 10 points.


    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 23 Answers

There is a kit ...try V-twin...or type lowering kits...I saw it..its a bracket you bolt on,,and than bolt the bottom of the shock to it..drops ya about 2..3 inches...or let the air out ..take a measurement and buy shorter shocks....I had 10 inch shocks on but they don't compress because you changed the shock angle...rode like a was cool when I was 30..

Posted on May 10, 2013


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 25 Answers

SOURCE: install a baron bullet tachometer on 2003 FLHRCI

remove big 1/2" nut below speedo, and + screw lower on tank dash, then lift intire dash and youre their. dose this help?

Posted on Nov 26, 2008

  • 83 Answers

SOURCE: 2006 Road King

Harleys are known for their shaking but when they get really bad I usually start looking for broken motor mounts. I suspect you either have a lose one or broken. The rubber wears out and then they get obnoxious.

Posted on Dec 08, 2008

  • 33 Answers

SOURCE: 21" front wheel for 2002 road king classic

Goes right in. Except be sure to check front fender light bolt. Had to cut many before.

Posted on Feb 10, 2009

  • 20 Answers

SOURCE: 2006 flhri road king alarm problem

Hi Cammy, I hope you are following the instructions in the Owners Manual?  The steps are as follows: 1. Turn IGN on. 2. Press and hold keyfob until the turn signals flash 3 times 3. Turn IGN off 4. Press and hold keyfob until turn signals flash 3 times again.  Red seurity light will be flashing on and off.  Alarm will be set but motion detection will be deactivated.

Posted on Feb 24, 2009

  • 190 Answers

SOURCE: lighted floor board inserts inop

was the Y connector used with resistor

if not need a resistor in the circuit to cut down current possible led's are dead an need to replace

here's a how to make your own led tree

Posted on Apr 06, 2009

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

2006 road king fork lock assembly

Hi Anonymous, please tell me what is your question is and can you be specific and include details? Thank you and have nice day.

Apr 04, 2013 | 2006 Harley Davidson FLHRCI Road King...

1 Answer

I want to lower my 2002 h.d. road king

H-D have lowering kits for your specific model

Oct 14, 2012 | 2002 Harley Davidson FLHRCI Road King...

1 Answer

How can I lower my harley davidson FLHTK

Hi Anonymous, and the usual procedures are:
1. Thinner less padded seat.
2. Rear shock absorber lowering kit.
3. Shorter rear shock absorbers.
4. Front fork lowering kit.
5. Lower profile tires.
Good luck

Jun 11, 2012 | 2004 Harley Davidson FLHRCI Road King...

1 Answer

How do you lower a 2002 harley road king

You can get lowering rear shocks and front fork lowering kit from H-D parts.

Dec 03, 2011 | 2002 Harley Davidson FLHRCI Road King...

1 Answer

2005 road king, how do you adjust the rear air shocks .

shrader valve should be on left close by top of up bag cause lid in way...good luck..

Sep 18, 2011 | 2005 Harley Davidson FLHRCI Road King...

1 Answer

I just switched from a Softail Standard to a 2001 Road King Classic (FLHRCI). I need to service the bike but noticed the drain plug for the oil is not located in the same place on the frame as the...

The RK oil tank is on the bottom of the transmission. the drain plug is near the center of the oil tank. There is also a transmission drain on the side of the oil pan. Loosen the plug just enough to allow a little oil out to make sure you have the correct plug before you take it completely out. It take three quarts of oil with a filter change.


Jul 12, 2011 | 2001 Harley Davidson FLHRCI Road King...

1 Answer

Can the engine oil pan on a 2001 road king be removed without removing the emgine?

Although I don't work on 2000 and later model bikes, I'm pretty sure that the oil pan can be removed from the bottom of the transmission just as the older model bikes were.

Good Luck

May 25, 2011 | 2001 Harley Davidson FLHRCI Road King...

1 Answer

02 road king fuel problems have a half tank of fuel starts misfires and back fires though exhaust and starts hard

If you have a carb equipped bike and the bike has been lowered in the rear, you could be running out of gas on your main fuel switch position. You may have to go to reserve at that point. If the petcock is located at the front of the tank, the fuel is more to the back end of the tanks if the rear end of the bike has been lower. If it's fuel injected, I have no idea.

Good Luck

Mar 14, 2011 | 2002 Harley Davidson FLHR - FLHRCI Road...

Not finding what you are looking for?
2006 Harley Davidson FLHRCI Road King Classic Logo

147 people viewed this question

Ask a Question

Usually answered in minutes!

Top Harley Davidson Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4536 Answers


Level 3 Expert

4340 Answers


Level 3 Expert

76846 Answers

Are you a Harley Davidson Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides