Question about Motorcycles

1 Answer

Engine shuts down after 2 min - Gsxr 750 1997

My engine shuts down after 2 min or so on Gsxr 750 1997. It starts normally but when it warms up, the motor shuts down. After that, I have to let It cool down a while to start It again.

Here's the things I did to fix it up to now
-Replace spark plugs
-Clean fuel filter in gas line from gas tank to carb
-Clean fuel nozzle + carb mvt good

Posted by on

  • Danny D. Alary May 17, 2013

    Thanks for your proposed solutions. Here's some other clues 1) The idle speed is good, the bike is running great for 2-3 min 2) There's no petcok valve on the gsxr 750 1997, the fuel is pumped by the vaccum. I checked this piece and with succion the fuel flows easily 3) I took the carb off and all the fuel needles and the diaphragms seem in good condition 4) I cleaned my gas tank and there was no debris that could have block the gas to go through the valve.

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 17 Answers

Bad ignition coil. You can try to find the OHM specs and test it but that is what happens when you have a failing coil.

Posted on May 16, 2013

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 7 Answers

SOURCE: cutting out at higher rpm

If the engine is the DOHC 16 valve engine inline 4, and has multiple carbs, then I have 2 suggestions for you, First thing I would take the carbs off, as a whole rail, and have them ultra-sonically cleaned at a shop, and the diaphragms checked in the tops. After that, you need to have the carbs synced while on the bike. I have a GSF600S and it was basically opposite your problem, it had a sputter in the low rpm range, and the carb syncing fixed it, and they honestly weren't that far off. The way those carbs feed fuel, if one is giving too much fuel then it will cause ur plugs to foul, or flood that cylinder, causing the issue. For the carb syncing I suggest building this tool, which I did for my bike.
http://www.powerchutes.com/manometer.asp
It's a liquid column differential manometer, which very accurately and sensitively measures the vaccum on the different cylinders of the engine. The only other thing I can think of is your ECM, which controls the engine, and incorporates your rev limiter. These are pretty pricey, so I would do the steps above first.

Posted on Jun 19, 2009

  • 1 Answer

SOURCE: stalling when starting

if after the two mins ur putting the choke back in and the bike dies, it could be that your needing to adjust the idle speed.
it might just be set on the lower limit so that when ur bike isnt fully warmed up it struggles.

Posted on Mar 16, 2009

tabbycat282
  • 56 Answers

SOURCE: 1989 tw200 yamaha won't start

G'day egdbcs . Ok.now lets see.You say good spark,so i'm presuming you are doing the old sight test.Try bending the arm on a know good sparkplug about 5-6mm,earth the plug and kick'er in the guts(crank it over)Be very carefull , high voltage danger.If there's still a good spark it's safe to say that there will also be a good spark under pressure in the combustion chamber,speaking of which you should also do a compression test,anything over 100psi should be ok. as i'm not to sure of the extent of the re-build,hopefully the valves were lapped and checked for straight and true and valve seals replaced,if you notice oil on the tip of the spark plug you could have a leaking valve seal or oil seal .Try putting a small amount of fuel directly into the combustion chamber ,tighten up the spark plug ,install the plug cap and.......Yeah ..You guessed it ..."kicker in the guts".If all the abouve are correct and true it should fire up.If it runs for 5-10 seconds then stops you've got some sort of fuel starvation problem , could be dirt in the carb,blocked idle jet ,or air passage or even the needle could have come off it's clip,believe me with an old bike like yours anything could be worn and loose inside that carby.The only other thing to consider is the timing.There may be a good spark but is it happening at the right time inside the engine???. I'll leave it all in your capable hands EGDBCS.Hope this helps to solving your worries. Chow for now......Tilleydog..

Posted on Jun 03, 2009

  • 11 Answers

SOURCE: 93 gsxr wont start and occasionally dies

you could possibly have a bad fuel petcock they sometimes work there way out and cause fuel cut off to half the carburetors. The vent tube on tob of the tank can also become blocked. You can check it buy sucking on the tube and making sure you can **** air out of it. You may or may not have inline filters under the tank. If it's a 93 there is no fuel pump.

Posted on Sep 19, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Engine shuts off after driving 45 min when parking in reverse.But 15 min before this engine and slippery road icon comes on.2 hrs later car starts and drives normal then shuts off again 45 min later.


most commonly found problem relates to an electronic component heating up and shutting down. Have you checked to confirm there is fuel pressure when the vehicle shuts off. Is the check engine light on. Have you checked codes ? I suggest hooking up a fuel pressure gauge and letting vehicle run till it shuts off while monitoring the fuel pressure. If you loose fuel pressure, next step is to confirm there power going to the pump, if there is power going to the pump with no fuel pressure replace pump. Another suggestion would be to check for spark when vehicle stops running to eliminate an ignition problem. good luck

Aug 17, 2015 | 2008 Toyota Highlander

1 Answer

02 GSXR Limits to 4800rpm, drops to idle, when warm not cold.


If you have the stock computer replace the power commander with the stock computer then see if the problem still remains. If it goes you can be sure the problem lies within your commander and it will need to be remapped or replaced...Good luck

Nov 02, 2009 | 2005 Suzuki GSX-R 1000

1 Answer

The engine runs for less than 2 mins and shuts off


could be oil low cut off , dirty air filter ,check fuel filter.

Oct 05, 2009 | Craftsman Garden

1 Answer

94 chrysler con.3.3 eng.runs for about 15 min. shuts down,engine


suggest change crank sensor-rear of engine pas side

Oct 05, 2009 | 1994 Chrysler LHS

1 Answer

Suzuki gsxr 600 06 starting problems


200° is quite warm...
If the engine wont turn over, probabily you have a bad battery, a bad starter or a bad starter relay, or bad connections.

A hot engine has more compression. If the full battery power doesn't reach the starter it won't turn over...

Aug 19, 2009 | 2006 Suzuki GSX-R 600

1 Answer

Intermitant temperature


Check to make sure your thermostat works right by monitoring the warming up of your engine. With a completely cold engine, start and run the engine for a few minutes, then put your hand on the top radiator hose to monitor if and when it gets warm as the thermostat opens more and more and note the gauge reading( if it works) the top radiator hose should be unbearably hot within 5-8 minutes. If the therm. opens right it should close right aswell, staying open a little while eventhough the radiator may have cooled may be what you are experiencing causing the rapid cooling and is nothing to worry about. The Hose should not get warm very soon after starting the engine. Regarding you gauge, lets take one step at a time, verify proper op. or the therm.

Jan 20, 2009 | 1986 Toyota 4Runner

1 Answer

1989 BMW 735i Hot start issue


You might want to try replacing your throttle return spring, or at least lift the hood and see if here is a change while it smooths out..

May 23, 2008 | BMW 750 Cars & Trucks

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

184 people viewed this question

Ask a Question

Usually answered in minutes!

Top Motorcycles Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

yadayada
yadayada

Level 3 Expert

75822 Answers

kakima

Level 3 Expert

102366 Answers

Are you a Motorcycle Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...