Question about Motorcycles

Open Question

I have no spark on my Jinlun Jl 50 QT-5 2005? Iv replaced the CDI, coil and HT lead, but still no spark! I have a suspicion that it may be the stater but wanted a 2nd opinion on the matter before I take the engine apart? Thanks

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
Benimur
  • 6966 Answers

SOURCE: No spark on Hyusu

Hi and welcome to FixYa,

For a "no spark" problem with a Hyosung RX125, check:

  • temporarily disconnect the battery. With the engine on at both the ignition switch and engine kill switch, verify that the green wire to the CDI does not measure 0 ohms to ground;
  • if it does, check the ignition switch and the engine kill switch;
  • it it measures anywhere between 50 ~ 500 ohms, then reconnect the battery and check that there is +12 on the orange wire going to the CDI with ignition switch on;
  • for a pulsating voltage (high ACV) at the white / blue wire coming from the CDI going to the ignition coil;
  • for a pulsating voltage (low ACV, 0.5VAC) at the green wire coming from the pulser coil going to the CDI; and
  • of course, check if the CDI (black / white) is connected to the ground.
Postback results of tests.

Good luck and thank you for using FixYa.

Posted on May 27, 2009

Ad
  • 3567 Answers

SOURCE: no spark 110cc engine wont start

Check the fuses. Next, check for spark but with a new spark plug. How good is the battery? If needed, add water to the battery cells enough to cover the top of the cell plates.Try a jump start from your car battery. Is the kill switch on? Check the operation of the ignition switch with a volt ohmmeter. You should be getting power into and out of the ignition switch.

If the bike doesn't start and run properly check the side stand kill switch. It kills the engine so that you don’t start out with the side stand down. Broken or out of adjustment, it would kill the spark. Check for a broken wire at the switch or coupler. Get a service manual and check out the electrical section. Some bikes have a diode integrated into the turn signal relay. Try moving the kill switch by hand. If that doesn’t work then wire a jumper around the switch to bypass it. If that doesn’t work, check out the relay.

Check the wiring harness. Did a wire come unplugged? Are all wires clean and with solid connections? Any abraded or pinched wires? Is the bike in neutral and the neutral light is lit up? If no neutral light, check the neutral switch and neutral switch wire on center casing.

Please rate this answer. Thanks

Posted on May 28, 2009

Benimur
  • 6966 Answers

SOURCE: suzuki gsxr 400 gk76 which ht leads go where from coils

Hi and welcome to FixYa,

Almost always on Suzuki 4 cylinders, the left (when seated) igntion coil supplies cylinders 1 & 4 while the right ignition coil supples 2 & 3.

Good luck and thank you for asking FixYa.

Posted on Aug 15, 2009

  • 311 Answers

SOURCE: no spark put on a new cdi box coil good and a new

hi,sounds to me like your cdi pickup unit has failed,i am not 100% certain but this will be located on the end of the crankshaft behind one of the enginecovers,there could be two other possibilities,motox bikes are notorious for breaking wires so check the wiring from the cdi sender unit to the cdi box and the coil,also check your "off"button it may be stuck in the "kill" position..hope this helps..cheers ian

Posted on Dec 30, 2009

  • 1 Answer

SOURCE: 1985 honda VT 500c shadow one cylinder when engine hot

how do i check the cooling fan to see if it is any good

Posted on Aug 03, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do i test the stater and coil on 1979 honda mr50 dirt bike


Have you replaced the condensor? Do the points actually spark?
Have you checked HT lead and plug cap? Remove cap and place bare end of ht lead on cylinder head so that spark can jump from core to cylinder fin, DON'T hold it there... Kick engine over and look for spark at end of HT lead

Jun 06, 2015 | Honda Motorcycles

1 Answer

No spark on ignition coil on my bajaj wind 125 my cdi , rectifier and stator are new.


Put a test lamp and connect with an earth then crank the engine the bulb should flash for a moment if the coil is ok ...
OR, there is a another simple method just take out the spark plug connector and place is at a very near to the spark plug end and then crank the engine if every thing is fine ( OK condition) then one can see the spark in between the the spark plug lead and the HT cable.
25342083-54n04i3hdvkkhgpfobbhpvj2-5-0.jpg

Dec 28, 2014 | Bajaj Wind 125 Motorcycles

1 Answer

WHY IS THERE NO SPARK AT SPARKPLUG?


Have you replaced the HT lead, plug cap and spark plug?

Jul 10, 2014 | 1995 Honda XR 250 R

1 Answer

Suzuki street magic spark issue


First change spark plug. If not plug, check plug cap, unscrew it off lead and hold lead end to cyl head and crank. If it sparks, change cap. If not, check H.T coil, C.D.I. and stator coils.

Apr 24, 2014 | 2005 Suzuki Street Magic II

1 Answer

I do not have any spark at my spark plugs this after I replaced my voltage regulator


check ht cap ..check ht lead, check condition of cut out switch, check power coming from coils, check power coming from cdi unit,

Feb 16, 2013 | 1983 BMW R 100 RT

1 Answer

I have no spark i think it might be my cdi starter turns over but it wont start it sounds like its dragging


Hi,
Check if any spark comes out from the spark plug.
Try to remove the airfilter and choke the carburetor when your starting the engine.
Hope that helps you!

Aug 07, 2011 | 2007 Jinlun JL 50QT5 Commuter

2 Answers

50 cc chinese scooter moped won't stay running NEW OFF the truck


Look for crimped fuel line, loose spark plug or cap, after that tighten cylinder head probably (4) 10 mm nuts, these are the comon assembly issues I have seen.

Aug 11, 2008 | Transport Schwinn Rechargeable Portable ...

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

182 people viewed this question

Ask a Question

Usually answered in minutes!

Top Motorcycles Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4536 Answers

yadayada
yadayada

Level 3 Expert

76846 Answers

kakima

Level 3 Expert

102366 Answers

Are you a Motorcycle Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...