Question about 2007 Yamaha FZ6 Fazer
My fz6 is the 2007 model. The battery is charged and everything. Every time I attempt to start it, it will not start, make a sound, or do anything. Also, the motorcycle will only go into neutral or first gear when off, I don't know if that's normal or not. Is it possible to fix this on my own or should I take it to an expert?
Hi, Brevante and the usual suspects are:
1. Ignition Switch not in the "ON" position.
2. Engine Run Switch in the "OFF" position.
3. Discharged battery, needs to be 12.5 volts or better and be able to pass a load test if necessary.
4. Check the battery terminals for damage or corrosion check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter if necessary.
5. Tip over sensor needs a reset.
6. Faulty ignition switch.
7. Faulty starter button.
8. Faulty kickstand or clutch pull in switch/sensor.
9. Starter control circuit, relay, or solenoid faulty.
10. Main fuse or circuit breaker may be blown or faulty.
11. Check for engine trouble codes.
For more information about your issue and valuable "FREE" downloads that you will need please click on the links below. Good luck and have nice a day.
07 FZ6 won start help
Bike will not start
OEM parts for Yamaha
Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e
Posted on Dec 31, 2016
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
one thing, check your gear selector, sometimes if that sharp edge is rounded out, worn out from usage, your gears may either slip, or wont wove at all.
Posted on Sep 10, 2009
SOURCE: 91 yamaha breeze,wont turn over
Check fuses. Check voltage. Could be a burned, or just broken fuse. Could be a dead battery. Could be as simple as poor battery connections. If not, perhaps the following will help:
A starter can be tested in a very simple way, by applying 12vdc to the power input, and grounding the case. If it spins, then it's on to step 2, checking connections.
Starters are much too simple to be more complicated than that, but the electrical system can be. Check the circuit between the relay and the starter. Is is a direct wire with no breaks? If so, check the voltage at the power output and input of the relay. If it is good, check the power input and grounding of the starter.
Most new bikes have a clutch switch, and it may interrupt the 12vdc to the starter, without affecting the relay. Same thing goes for the nuetral switch.
Try starting in nuetral, with the clutch pulled. Check the relay for conections that you may have taken off, and not replaced. Same thing for the starter.
Posted on Oct 02, 2009
Testimonial: "accurate and outstanding advice, new starter bad, many thanks"
Hi and welcome to FixYa,
Initially, check, clean, bypass or replace the sidestand switch (blue/yellow wire & ground).
Good luck and thank you for asking FixYa.
Posted on Feb 09, 2010
could be solenoid.
--- Please dont forget to vote if you liked my answer thanks
side stand switch.
bike in gear switch
ignition kill switch
faulty starter switch
you are going to have to get a test meter and and see what power is going to solenoid both sides and if it is getting the signal to start.
Please dont forget to vote if you liked my answer
Posted on Feb 09, 2011
Tips for a great answer:
Jul 29, 2013 | Tracrac 2000 Ford F-150 - 8 long bed -...
Oct 09, 2012 | 2012 Volkswagen Jetta TDI Sedan 2.0L...
Check the fuel. Don't rely on your gauge, and if in doubt add some fuel just to make sure there is enough to start the car. Try to start the car and if it still doesn't start you know that fuel isn't the problem.
Make sure your car is in Park and the emergency brake is set.
Look closely at your dash board when you attempt to start the car. If your lighted panels don't come on or are very dim then it is likely that you are dealing with a dead battery. Either use a battery tester or simply hook the battery up to a charger or use jumper cables to hook up to another car battery in order to charge the battery enough to start the car. After you charge the battery if your car still won't start you may be dealing with a bad starter.
Call a mechanic to find out if there are any other possibilities before you purchase and replace the starter.
Mercedes Custom parts
Jun 06, 2012 | 2001 Oldsmobile Alero
Apr 22, 2012 | 1999 Yamaha FZS 600 Fazer
Apr 02, 2012 | Jeep Cherokee Cars & Trucks
Sep 09, 2011 | 2002 Dodge Intrepid
May 27, 2011 | 2004 Pontiac Grand Prix
Apr 21, 2011 | 2004 Chevrolet Cavalier
Mar 01, 2011 | 1998 Yamaha FZS 600 Fazer
Jul 24, 2009 | 1999 Kia Sephia
Jul 09, 2018 | Motorcycles
23 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: