Question about Motorcycles

1 Answer

Quad not starting - please help.

Need help starting my Chinese quad 125 cc. Please help.

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Motorcycles Master
  • 3,799 Answers

Turn key to on. Pull in clutch and ensure gearbox in neutral. and press the start button.

Posted on May 10, 2013

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 3567 Answers

SOURCE: quad starts but won't stay on?

ALWAYS have a fire extinguisher at hand when working on carburetors.
Remove the water trap bowl at the bottom of the petcock, (gas valve). Is there any water or trash in the bowl? Drain a cup of gas from the tank. Is there any water or trash in the cup? Dump it, clean it and re-mount it, ( not all bikes have a water trap bowl ).

Drain the carburetor. There should be a screw on the lower side of the carb float bowl. Remove the screw then replace it after the fuel drains. Turn the gas back on and wait a minute for the carb to fill with gas. Install a new stock NGK spark plug and try to start the engine. If the bike doesn't start and run properly then shut off the gas and remove the carburetor from the engine.

Remove the float bowl and clean the entire carb with a spray carb cleaner from the auto parts store. Wear protective goggles to avoid getting spray in your eyes. Spray into all the little airways and fittings in the carb. Remove the idle screw and the air screw on the outside throat of the
carb and spray into the screw holes as well.
< < READ CLOSELY > >
Be sure to put these two screws back in the same hole they came out of. IMPORTANT > do not tighten these two adjusters down. Only screw these in until they LIGHTLY seat. Now turn each adjuster one and one half turns outward. Put the rest of the
carb back together, clean the air filter and install the carb. Let the float bowl fill then start the engine. This process should get you back on the road.

Please rate this solution. Thanks!

Posted on May 06, 2009

  • 3567 Answers

SOURCE: quad bike keeps cutting out


ALWAYS have a fire extinguisher on hand when working on carburetors.
Remove the water trap bowl at the bottom of the petcock, (gas valve). Is there any water or trash in the bowl? Drain a cup of gas from the tank. Is there any water or trash in the cup? Dump it, clean it and re-mount it, ( not all bikes have a water trap bowl ).

Drain the carburetor. There may be a screw on the lower side of the carb float bowl. Remove the screw then replace it after the fuel drains. Turn the gas back on and wait a minute for the carb to fill with gas. If the bike doesn't start and run properly then shut off the gas and remove the carburetor from the engine.

Remove the float bowl and clean the entire carb with a spray carb cleaner from the auto parts store. Wear protective goggles to avoid getting spray in your eyes. Spray into all the little airways and fittings in the carb. Remove the idle screw and the air screw on the outside throat of the
carb and spray into the screw holes as well.
< < READ CLOSELY > >
Be sure to put these two screws back in the same hole they came out of. IMPORTANT > do not tighten these two adjusters down. Only screw these in until they LIGHTLY seat. Now turn each adjuster one and one half turns outward. Before putting the slide back in the throat of the carb, move the clip on the jet needle one notch lower. Put the rest of the
carb back together, clean the air filter and install the carb. Let the float bowl fill then start the engine. This process should get you back on the road.

Please rate this solution. Thanks!

Posted on May 17, 2009

  • 2 Answers

SOURCE: quad won't start

I Have Started lots of Motorcycles that peopel have even thrown A way.
The most problem is with the carb or electric.
This what I have been starting bikes that A pigs to start for my last 28 years of Motorcycles.
Even with kick start bikes can build compreshion and kick back.
This can realy tire you out too.

1st wiggel all of the wires check for burn marks.

2nd Fuse box check for correct ones have been put in.

3rd Spark Plugs just put in new ones low cost cost for brand new .Check to see if You have Spark
if you don't Get A tester And read the service papers .

4th most of the fuel is years old trust me you need to mix 25/50 of Avation with super TT olny with yamaha RD 350 .You have penzoil for two strokes stick to olny one .

5th Fuel line pull the whole lot out put a air hose down blow it out .Clean fuel filter down the line
Clean the Air Box

Warning some bikes dont like Engine start Some with YPVS..
Playing with the enging iddl switch is not realy recemeded if the Bikes Not Runing !.
The Center stand could be down some bikes don't go with the center stand Down ( Its a safty Thing )


Turn the fuel on wile clutch out this will un block a air lock in the fuel line
6th Look for the Steepest hill you can find ! Stick it in top gear And wile you Speed up Like Really Fast STAND UP ! And push your weight on the foot pegs .And Repet this you should be clocer in starting to 3rd Gear if not 2nd .Pull the clutch in If you Its just Getting The fuel in .
If theres fuel in your Glass filter your on the way.
The twist grip Throttle A boult Half OPEN And when its Splutting coffing Give it the berrys.Chears From Rd 350 (R) with 77 owner

Posted on May 24, 2009

  • 3567 Answers

SOURCE: kids quad will not start

Install a new spark plug. Remove and clean the air filter. Spray some starting fluid into the carb and try to start the motor. If it doesn't start then remove the carb and clean it;
Drain the carburetor. There should be a screw on the lower side or bottom of the carb float bowl. Remove the screw then replace it after the fuel drains. Remove the float bowl and clean the entire carb with a spray carb cleaner from the auto parts store. Wear protective goggles to avoid getting spray in your eyes. Spray into all the little airways and fittings in the carb. Remove the idle screw and the air screw on the outside throat of the carb and spray into the screw holes as well.
< < READ CLOSELY > >
Be sure to put these two screws back in the same hole they came out of. IMPORTANT > do not tighten these two adjusters down. Only screw these in until they LIGHTLY seat. Now turn each adjuster one and one half turns outward. Put the rest of the
carb back together and install the carb. Let the float bowl fill then start the engine.

Posted on Aug 17, 2009

Testimonial: "thank you very much,"

  • 115 Answers

SOURCE: i am trying to fix a kymco 90 cc quad

check your safety switches

Posted on Sep 13, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Trying to start mini quadard 49 cc model atv-2


Try turning the carb set screw all the way in and back out 1 1/4 turns. If you need more... do it in 1/4 turn increments.

Dec 24, 2013 | Quad 47 cc / 49 cc Pocket Mini Bike...

1 Answer

Chinese yun ba quad


Check condition of the battery. Is it fully charged?

May 05, 2013 | Cars & Trucks

1 Answer

Help my sons mini pocket quad is making a ringing noise and I don't know what it is. Please Help


open the clutch case there will be a bolt came loose. the clutch is behind the chain drive bolts can come loose from vibration buy lock tight for bolts from halfords do not run untill you have fixed this will rip the clutch apart

Mar 31, 2012 | Quad 47 cc / 49 cc Pocket Mini Bike...

1 Answer

I have a chinese scooter starts and idles for a few seconds and then dies do you know what the problem is?


check the hoses that put gas on the carburator, and also the pump. Check the spark plug, better take it off and clean it and check the gap.

May 19, 2010 | Quad 47 cc / 49 cc Pocket Mini Bike...

1 Answer

Midi 49cc bike will not start. owners haven't started it for 2 years. please help!!


If it is still turning over all you probably need to do is service the carb and drain and replace tank with new gas.

Aug 09, 2009 | Quad 47 cc / 49 cc Pocket Mini Bike...

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

129 people viewed this question

Ask a Question

Usually answered in minutes!

Top Motorcycles Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4536 Answers

yadayada
yadayada

Level 3 Expert

76649 Answers

kakima

Level 3 Expert

102366 Answers

Are you a Motorcycle Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...