Question about Yamaha YZF-R6 Motorcycles
Bike gets no power when key is turned i run jump start it when i did it sounded crazy and the rpms would go from zero to 6 and jump around problem started when i hit my kill switch the wala no power what so ever batterys fully charged and i check the fues's by the battery and they look good so whats the deal ?
Posted by Anonymous on
Hi, Anonymous and the usual suspects are:
1. Ignition Switch not in the "ON" position.
2. Engine Run Switch in the "OFF" position.
3. Discharged battery, needs to be 12.5 volts or better and be able to pass a load test if necessary.
4. Check the battery terminals for damage or corrosion check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter if necessary.
5. Tip over sensor needs a reset.
6. Faulty ignition switch.
7. Faulty starter button.
8. Faulty kickstand or clutch pull in switch/sensor.
9. Starter control circuit, relay, or solenoid faulty.
10. Main fuse or circuit breaker may be blown or faulty.
11. Check for engine trouble codes.
For more information about your issue and valuable "FREE" downloads that you will need please click on the links below. Good luck and have nice a day.
2008 2009 Yamaha YZF R6 Service Manual R6 Moto Data Project
OEM parts for Yamaha
Posted on Sep 19, 2016
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
from your description, i would sugest you make sure fuel is getting to the injector unit, remove the fuel supply hose.if you have spark at the plugs and fuel getting to the injectors you have isolated the problem. i would also drain the old fuel when you take the hose off and fill the tank with high grade fuel. bikes dont like old gas.
Posted on Jul 21, 2009
SOURCE: 2004 honda cbr rr1000 want
The battery and stator.Both needs to be checked and replaced.The stator charges the battery when bike is running.If the battery is old, as per me battery life is approx 2 to 3 years.In your case battery not holding charge. Replace the battery, this should take care of problem.But if problem is same then stator also has to be replaced.-------- This will help.Thanks.Helpmech.
Posted on Jun 07, 2011
Sounds like a possible stuck relay, a bad connector or low battery amperage. Try this to help troubleshoot. Put a volt meter on your battery and check voltage with key off, should be 12.2v at least, turn the key on and check,---then hit the starter switch---you should see a drop in voltage as the battery power goes to the starter---if no voltage drop then power is not going across your start switch. Of course, make sure battery is at full charge, has no dead cells, terminals are clean and tight, and especially the ground. Many times i have found the ground cable going to the frame in bad shape, (you can't see the corrision, u have to remove the cable) this will cause all kinds of problems... no start being one of them. I hope this helps, let me know what you find.
Posted on Jul 12, 2011
Tips for a great answer:
Apr 15, 2015 | Motorcycles
Aug 26, 2013 | 2008 Suzuki Boulevard C50
Sep 24, 2012 | Cars & Trucks
Dec 20, 2011 | 1997 Yamaha YZF Thunder ace 1000 R
Mar 13, 2010 | 1998 Yamaha YZF 600 R thunder cat
Aug 04, 2009 | 2004 Yamaha DT 125 R
Mar 01, 2009 | 1992 Jaguar XJ6
Dec 24, 2008 | 1999 Volkswagen Passat
Mar 29, 2013 | 2008 Yamaha TTR230
17 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: