Question about Motorcycles
How do I remove the rear wheel off my Suzuki fj50qt moped
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
unhook all the brake linkages and rods,axle nut,pull the axle out,and shift the entire wheel to the right and it should pull out,its really easy,although i know it sounds a little overwelming
Posted on May 28, 2010
remove brake tension nut, remove bolt on frame bar, loosen bolts on shaft clamp after removing nut on shaft then knock shaft out . must have bike on jack to clear ground when working tire loose .
Posted on Jun 11, 2010
Jack the rear of the bike as high as you can safely get away with. The rear fender makes you require a lot of clearance to get the wheel clear of the bike.
Make note of the protrusion of the rear brake actuator rod and remove it from the actuator arm. Remove the bolt from the rear brake plate anchor arm.
Remove the plastic cover from the left side of the axle.
Remove the cotter pin from the axle end, then remove the nut by holding it with a wrench while turning the left end of the axle with a socket. You may need to tap the right end of the axle to start it moving out, and this is a tight area because of the pipes, but it should not take too much coercion. Once it begins to budge, you should be able to work it out from the left side. Remove the axle spacer.
While supporting the wheel ( I use my auto jack for this), wiggle the wheel until the drive unit splines disengage. You are now ready to work the wheel out from under the fender. There is a sleeve inside the drive end of the wheel, try not to let it pop out and get dirty. Don't forget to grease those drive splines when reinstalling, and to restore the brake rod to its former setting, unless you are adjusting it at the same time.
Posted on Nov 02, 2010
Tips for a great answer:
Mar 23, 2016 | Suzuki Motorcycles
Nov 05, 2014 | Suzuki VS 800 Intruder Motorcycles
Jan 03, 2011 | Suzuki VL 800 Volusia Motorcycles
Jan 03, 2011 | 2001 Suzuki VL 800 Volusia
Sep 03, 2010 | Suzuki VS 800 Intruder Motorcycles
Aug 10, 2010 | 2003 Suzuki VL 800 Volusia
Jul 09, 2009 | 2001 Suzuki VL 1500 Intruder LC
18 people viewed this question
Usually answered in minutes!