Question about 2010 Piaggio Zip 50

Open Question

Front and back light not working, other lights and horn working fine

Posted by on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Horn buttons works the radio


Suspect a short circuit in the steering column wiring

Jun 20, 2016 | Cars & Trucks

1 Answer

My wipers...lights..radio and horn went out but I can drive the car..what would cause this?


2008 Chrysler Town & Country Intermittent Electrical Failure ...

www.carcomplaints.com/Chrysler/Town_Country/.../intermittent_electric...
The 2008 Chrysler Town & Country has 25 complaints for intermittent ... The horn,lights, wind shield wipers front and back going crazy could not shut off. .... I was Driving down the road and my van went crazy possessed! ... Electrical checks reveal nothing wrong with the electrical system, and there is power to the radio.

2003 Dodge Caravan ES Electrical Problem - Discussion on Topix

www.topix.com > Dodge Grand Caravan
Aug 7, 2011 - my van was running fine, shut it off, went in for half an hour then it would not ... or the electric doors. windows do and brake lights. heater stays on hot and i can only ... My horn wipers,power windows, radio,blower front and back, headlights, do not work. ... Chrysler Readies Next-Generation Town & Country.Missing: 2004

Thread: I lost almost all of my dash lights, instruments, and ...

forum.chryslerminivan.net/.../7261-I-lost-almost-all-of-my-dash-lights-i...

Jan 17, 2008 - 10 posts - ‎6 authors
I have a 2003 Town and Country mini-van and I lost power to all my ... In addition to this my wipers, headlight controls, blinker controls, power door locks, and A/C/heat controls are out as well. The odd thing is that the power windows work, the power sideview mirrors work, the radio and ceiling lights also work.

Dec 16, 2015 | 2004 Chrysler Town and Country

1 Answer

No turn signals no brake lights no horn no speedo light on a 2000 dyna fxdl


Hi Anonmous, get out your test light and start at the ignition switch and work your way to switch housings and beyound. If you disconnected the battery for any reason you might have a TSM/TSSM issue. For a free wiring diagram please visit the website below: Harley Davidson Wiring Diagrams and Schematics
Good luck

Feb 03, 2014 | Harley Davidson FXDL Dyna Low Rider...

1 Answer

My lights and horn won't work. The first time I rode it, they were working. Now it's the second time and the scooter runs fine but the front lights, turn signals, brake lights, and horn won't work. Any...


the relay switch or fuse (which ever one it uses) should be a fuse but if horn was modified then there would be a relay switch used to bypass every thing(this is how i installed my siren, red & blue lights, new horn) the original lights remain on the original fuse, open fuse box and sinply replace, should say on the panel what fuse it what

Nov 04, 2013 | Cars & Trucks

1 Answer

2001 chevy silverado horn and front turn signal failure


you need a new horn, and find the bulb that is out

Jan 17, 2013 | 2001 Chevrolet Silverado 1500

1 Answer

How to fix a horn on a 2003 cavalier.... The fuse is good, so I know it's not that. Please help!


The horn is located on in the right front fender behind the wheel well.You need to remove the plastic cover around the front part of the wheel well and pull it back enough to see the horn.Remove the wire from the horn and you can use a test light to see if you are getting power to the horn.The ecm(engine control module) is right by the horn so be careful with the wires harness.If you don`t have a test light you can use a piece of wire and hook it to the battery and put power to the horn.It should beep.If not replace the horn.If it does work then you will need to trace the wire back to the relay center under the hood.Hope this helps.Good luck.

Feb 17, 2012 | 2003 Chevrolet Cavalier

1 Answer

I have wr 400 and the back light and horn are not getting enuf power, they are fine when the bike is half throttle, but just ticking over, back light slightly visible and if u put hand on horn u can feel...


this means 2 things:

the devices are not getting enough current ( possible issue with wiring)
the harness for the horn and the rear light is damaged

Both issues pertains to a positive and a negative terminal touching the frame. this will either result to a poor to no headlight or a poor to no horn and brake light.

The reason why the tail light and the horn is affected is that because these devices are in a single circuit. this will make it easier for you to trace the wires since you now have a suspect to concentrate on.

Jun 16, 2010 | 2000 Yamaha WR 400 F

1 Answer

Horn dosent work


Step 1 is to ck the horn fuse in the under hood fuse box. If it is good then disconnect the rt horn (the easiest one to get to under the rt hand side front bumper.) /connect a test light across the 2 wires have some one push the horn pad and watch the test light . If the test light lights then the horns are bad and need to be replaced. If the test light does not light then remove the steering wheel air bag and ck the horn wire under the air bag.

Feb 24, 2010 | 2003 GMC Yukon

3 Answers

My Piaggio Typhoon 50cc has no indicators or horn


Look under the front panel and make shure all the wires are plug in. check www.scootdawg.com for a complete list to trouble shot it.
Best Reguards

Larry

Jan 24, 2010 | Peg Perego Vespa Scooter

1 Answer

1985 Toyota Pickup Horn


Probably the switch in the steering wheel, or fuse, but usually horn fuse works other things too such as cig lighter or radio. If everything else is working fine, then to troubleshoot you'll need a testlight. I would start with the wiring harness where the steering collumn plugs in and decipher which wire is the horn wire. Put the test light clip on +power, then check the wires on the collumn side one by one, pushing the horn button on each one. The horn switch is the wire that makes the light blink when you push the button. If you try all the wires and none make the light blink, then its probably a problem with the horn switch in the s. wheel. Does it have an after market steering wheel? Because aftermarket wheels often have crappy horn switches in them. Also could be a horn relay if it has one. If you listen carfully while pushing the horn, you should hear the relay faint clicking. If you hear this, then the switch is working, but the relay might not be. Follow the sound to find it if you hear it. Test all sides of the relay with your light. Should get power constant on one term, and the other two should light when the horn button is pushed. Hope this helps. Cheers.

Feb 07, 2009 | 1985 Toyota Pickup

Not finding what you are looking for?
2010 Piaggio Zip 50 Logo

Related Topics:

25 people viewed this question

Ask a Question

Usually answered in minutes!

Top Piaggio Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

Joseph Hoffmann

Level 3 Expert

1702 Answers

Andrew Taylor
Andrew Taylor

Level 3 Expert

14804 Answers

Are you a Piaggio Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...