SOURCE: honda cbr 600 rr 2005 fuel tank removal
I had an 07, I had to remove the lower and side fairings and then the bolts are visible, dont just lift it up because wires and the fuel line will be connected and tight. When you lift it, lift easily so you dont just rip everything, you should be able to lift it high enough to disconect the wires without damage.
SOURCE: oil capacity of engine crankcase on 2007 Honda VTX 1800 C
The factory fill is 4.3 litres. Thats new empty lines...etc.
3.75 to 3.9 quarts is a normal drain.
Heres a link for the complete service manual on the VTX 1800C
It's a big download about 50MB in PDF format
Hope this helps...ride safe and ride smart.
SOURCE: removing the rear wheel of a Honda VTX 1300s
ok first you got to find the link that takes the chain apart after you do that loosen the bolts that hold the tire on if you cant do that you can use a breaker bar or put a pipe or on the end of you rachet that will give you more leverage. then sloed the tire forword so you can undo the chain and slide tire off
SOURCE: removing baffles in my1300 vtx c honda ?
it is not hard to do but it would be best to get the drag pipes. there are a host of problems to think of though. you will need to rejet the carbs to accomodate the free up in back pressure. you will need the tourque slipins for the pipes. they will fit right into the pipes where they connect at the heads. the 1300 is going to be super loud without the baffels. like getting stopped by the law loud. it would be best to get a tuned drag setup from a dealer as to get the sound you are looking for as well as keep it below jonnie laws radar.
SOURCE: HOw do I check and replace coolant on a honda vtx
Try this forum. They can help you out.
http://www.vtxcafe.com/showthread.php?p=355760#
427 views
Usually answered in minutes!
×