Question about Yamaha FZS 600 Fazer Motorcycles
Posted by Anonymous on
Hi, Anonymous before diagnosing your blown fuse issue check the bottom of your seat if it's metal and comes in close proximity to the positive battery post you need to take the necessary steps to ensure there is no contact (electrical tape, thick rubber insulation, hammer a dent in the seat bottom etc.) also you are going to need a wiring from your service manual a test light, an ohmmeter and plenty of extra fuses. If you turn on your ignition switch and immediately blow a fuse you have a hard/dead short and is usually easy to find. With a test light connected to the hot side of the blown fuse holder start stabbing the wire/s that leads away from the fuse holder and towards the ignition switch, you test light will illuminate validating the short. When the test light fails to illuminate you have passed the short and need to back up until the test light illuminates, then look in the immediate area for the short.
If you driving down the road for 30 minutes or 15 miles and blow a fuse you have soft/flying short and may take some time and patience to find.
If the main fuse/circuit breaker constantly blows/trips while riding you probably have a faulty battery terminal connection. Check battery terminals for damage or corrosion, check battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter if necessary. Any other fuses that constantly keep blowing while riding are usually caused by a loose or corroded ground wire in the circuit, which means you have to check, inspect, test each and everyone with and ohm meter set on a low ohm scale 100 ohms or less . Simply touch one lead to the ground source and the other lead to the battery negative terminal, a reading of zero indicates a clean solid ground. Any number reading or infinity indicates a poor ground and needs to be repaired. Poor or weak grounds require excessive additional amperage to complete the circuit which in turn blows the small amperage fuse. For more information about your issue and valuable "FREE" downloads that you will need please click on the links below. Good luck and have nice a day.
The so called backup fuse keeps blowing
OEM parts for Yamaha
YAMAHA FZS600 Owner Manual
Posted on Jan 07, 2017
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
I suspect poor fuel delivery or starvation. At those rpms your bike requires a lot of fuel.Replace any and all fuel filters, check fuel lines for any kinks. Drain tank (petcock on pri ) then remove and clean petcock , replace. Run a bottle of techroline thru your next couple tanks of gas....Good Luck to you my friend...Tim
Posted on May 10, 2009
Hi and welcome to FixYa,
Initially, check, clean, bypass or replace the sidestand switch (blue/yellow wire & ground).
Good luck and thank you for asking FixYa.
Posted on Feb 09, 2010
Tips for a great answer:
Oct 24, 2017 | 1998 Yamaha FZS 600 Fazer
May 01, 2014 | 2003 Yamaha FZS 600 Fazer
Dec 14, 2013 | 1999 Yamaha FZS 600 Fazer
Apr 19, 2017 | 2001 Yamaha FZS 600 S Fazer
Apr 29, 2012 | 1991 Yamaha FZR 600
Apr 09, 2012 | 1999 Yamaha FZS 600 Fazer
Feb 09, 2010 | 1999 Yamaha FZS 600 Fazer
Aug 25, 2009 | 2005 Yamaha FZ6 Fazer
Mar 28, 2009 | 2005 Yamaha FZ6 Fazer
Nov 30, 2008 | 1999 Yamaha FZS 600 Fazer
65 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: