Question about Motorcycles

1 Answer

My 2007 hyosung 650 will not start. Does nothing. No clicking no thinking happens when I push start. Headlight comes on so battery is good I think. This started after I charged battery while connected to the bike. This was the first time I charged while connected. Did I fry something?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 528 Answers

Check your battery connections first, but I suspect it is more of a starter relay issue. The relay is typically mounted close to the battery and the positive wire goes from the battery directly to the relay ( some manufacturers call the relay a stator, or magnetic, switch.) This component can easily burn from trying to start the bike with a weak battery, so charging it hooked up likely didn't cook it - however, I strongly suggest you disconnect the negative cable next time you charge - just to make sure!!

Posted on Apr 27, 2013

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: hi i have a hyosung gt650r only push starts.....

my gt250r wouldnt start all light turn on

Posted on Sep 11, 2009

  • 1584 Answers

SOURCE: 2007 drz400 push start button and nothing

You got it, faulty starter solenoid or wiring from switch to solenoid.

Silly question but is the kill switch on??

Posted on Dec 03, 2009

Adrian762
  • 425 Answers

SOURCE: engine will not turn over, clicking sound

Three things cause your problem:

1. Dirty terminals

2. Battery flat or not holding charge (Cactus)

3. Starter motor has had it and all it can do is click the solenoid in and out.

Solution: Take it to an auto-electrician and he will diagnose your problem in a few seconds and rarely charges for this service. OR, you could attempt to jump start it from another bike, if it is the battery, it will turn over.

Posted on Feb 07, 2010

elshaddai159
  • 1016 Answers

SOURCE: Hyosung GV 650 wont start. Battery is fully charged and starter don't even click when trying to start?

Hi,
This will be either the starter solenoid is faulty or the starter motor needs replacing.Have the solenoid checked before removing the starter motor.

Posted on Mar 22, 2012

  • 13 Answers

SOURCE: Hi I have 650 r ls i was charging battery whilst

main fuse on the bike probably burnt overcharging because not on a timed charger or automatic cut out system which means it kept charging until battery went dry and shorted ou the cells inside which burnt u r main fuse hope it helps danny

Posted on Oct 18, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Hyosung motorcycle 650 I think...fule lines to and from


Hi, Kevin for this scenario you will need your service/owners manual if you can't find the first and best tool you ever bought for your Hyosung, despair not, for a mere $0 you can download another one. For more information about your issue and valuable "FREE" downloads that you will need please click on the links below. Good luck and have a nice day.
Hyosung GT 650 fuel line routing Google Search
http://korider.com/index.php?topic=24865.0
http://dna.cdi.cz/hyosung/gt650-service-4-fuel.pdf
http://www.hyosung.hu/download/pdf/data/service-manual/GT650%20EFI%20GV650EFI%20Service%20Manual.pdf

Nov 04, 2016 | Hyosung GT 650 Motorcycles

1 Answer

2007 Hyosung Avitar GV 650 the headlight keeps getting bright then it dims


Hi, Oliver if your headlight is not working, only one beam works, keeps burning out, blinking, dim or surges from bright to dim to bright the first thing you need to check is the headlight bulb for damaged filaments then check your light circuit fuse, then check your head light bulb socket ground wire for a clean tight connection, that being said the usual suspects are:
1. Faulty ground or power supply wire to headlight bulb socket.
2. Worn down solder contacts or loose fit of the bulb base in the socket due to vibration.
3. Worn, chaffed, or broken wires in the light circuit.
4. Corroded, broken, or loose pins/sockets in wire connectors.
5. Faulty hi/lo beam switch.
6. Faulty ignition switch.
7. Fuse is good but no continuity on both sides.
8. Faulty headlight relay.
9. Faulty wiring between battery positive and headlight bulb socket.
10. Weak charging alternator/generator/lightling coil.
11. Faulty voltage regulator/rectifier ground or overcharging.
For more information about your issue and valuable "FREE" downloads that you will need please click on the blue links below. Good luck and have a wonderful day.
Why does my headlight go dim get bright
Headlights bright then dim ELD or
HYOSUNG Aquil GV650 Service Manual
HYOSUNG AQUILA GV650 PARTS CATALOGUE Manuals
HYOSUNG GV 650 EFI Owner Manual

Jun 13, 2017 | 2007 Hyosung Avitar GV650

1 Answer

2004 hyosung 250 comet wont start


Sounds like there is too much of a load on that circuit. You need to do a battery/charging/draw test first and foremost. You can normally have these tests performed for free at your local auto parts store. It could be a bad starter pulling too many amps for that circuit,or it could just be that the valves need adjusting. But get the battery/charging/draw test done first,and that should point you in the right direction.If the tests come back in spec,..then i would start looking for a bad ground,or a pinched wire.Especially around and on the handlebar controls.

Aug 30, 2012 | Hyosung Comet 250 Motorcycles

1 Answer

2007 Hyosung GT650 - does it use roller bearings on the crankshaft or white metal bearings? Mine just "ran" bearings after a fast run on the highway - at least, that is my assumption. Serious...


Hi, Gavin_grimet the big end rod bearing are caged rollers the crankshaft assembly is supported in the crankcase by ball bearings. Let me put this gently, you hear a knock knock and nervously say "who's there?" a deep raspy voice responds it's me "*****" For more information about your question and valuable "FREE" downloads that you will need please click on the blue links below. Good luck and have a wonderful day.
HYOSUNG GT 650 Service Manual
http://www.alpha-sports.com/hyosung_parts.htm
HYOSUNG GT650 Owner Manual
Hyosung GT650 ***** GT650 Comet 2007 Hyosung GT650 Wikipedia

May 31, 2017 | 2005 Hyosung GT 650

1 Answer

Hi my hyosung 250 is not starting with a sound in the back seat ... i think its the starter but dont know where to locate it


if it is clicking its the same problem sane wit my hyosung aqullea 650 the regulator is gone to the starter it will click if you go to honda and ask for a cbr 400 regulator it works ask for ingnition regulator is located just under the tank

Oct 11, 2010 | 2005 Hyosung GT 250

1 Answer

No starting


Bad hot wire, bad cround or bad starter. Use jumper cables to jump from battery directly to the starter. If it doesn't turn over the starter has a problem. If it does, than you have eather a bad ground or hot lead going to the starter. Use a DC volt meter or a test light to see if its got power coming from the starter button. Do all that and you'll know the answer.

Oct 09, 2009 | 2005 Hyosung GT 650 S

2 Answers

Hi i have a hyosung gt650r only push starts.....


the battery is charging ok if not the bike wouldnt run-ur starter motor needs inspection-maybe the rotor or brushes r froze-1st chec wiring that gos to the starter-could be loose or bad-with a manual u can disasemble n test the motor-ni dong ma zai jian

Aug 17, 2009 | 2005 Hyosung GT 250

1 Answer

Have a 2007 650R


sounds lie the battery has a low state of charge, not providing enough cold cranking amps to turn the starter motor under load.

Feb 19, 2009 | 2005 Hyosung GT 650 R

1 Answer

Front low head lamp


try replacing start relay. It cuts power during start up to dedicate battery to starter and coil.

Feb 07, 2009 | 2005 Hyosung GT 650 R

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

181 people viewed this question

Ask a Question

Usually answered in minutes!

Top Motorcycles Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

yadayada
yadayada

Level 3 Expert

75822 Answers

kakima

Level 3 Expert

102366 Answers

Are you a Motorcycle Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...