Question about 2002 Suzuki VL 1500 Intruder LC

Open Question

Where is the petcock on a 2002 suzuki intruder 1500

Posted by Anonymous on

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 2336 Answers

SOURCE: fuse box

The main fuse is under the panel on the right side behind the forks and the rest of the fuses are in the crank case under the cover...where you fill the oil.

Posted on Nov 10, 2008

  • 3567 Answers

SOURCE: Crankcase capacity on 2002 Suzuki VS 800

Use 10w40 motor oil in the gear box. Don't use any synthetic lubricants, oil marked "EC", or oil with "special" additives. Stick with the major brands; Pennzoil, Quaker State, Mobil or Shell. If in a hot area like Texas or New Mexico go with 20w50.
231dcdf.gif
I don't have a service manual on your particular bike so just check oil quantity with the dealer when you go to buy the new oil filter. Don't forget to lube the cables and chain when doing the oil change.

Posted on Jul 24, 2009

  • 2 Answers

SOURCE: 2002 VL 1500 Intruder LC: What is the proper tire pressure for Suzuki vl 150...

Tire pressure is 29 lbs for the front and 36 lbs for the rear

Posted on Jun 29, 2010

Mr BrokRench
  • 1623 Answers

SOURCE: 2003 Suzuki VL 1500 Intruder LC REAR DISC RATTLE,HOW DO I REPLACE IT?

Hello Dale, this is an easy job on your bike. Use a flat head screw driver and remove the brake pad cover...it will pop off.
Remove the hairpin type clips off of the ends of the brake pad pins.... Use pliers & pull the brake pad pins out from the front of the rear brake caliper....Clean the rear brake caliper's piston with brake cleaner. Use a rag and wipe it clean...Reinsert the old brake pads into the caliper. Place a pry bar between the brake pads, then push the inner piston into the caliper body, this will allow room to install new pads.... Remove the old brake pads...Coat the brake pad pins and the new brake pads metal back plates with high-temperature grease.

Slip the new brake pads into the rear brake caliper, then push the brake pad pins halfway into the caliper. Slip the spring clips into place between the brake pads and the brake pad pins. Push the brake pad pins completely through the rear brake caliper. Push the hairpin clips back into the brake pad pin tips. Snap the brake pad cover onto the top of the rear brake caliper....

Pump the rear brake pedal until the pedal feels firm, indicating that the brake pads have closed around the brake rotor...No bleeding will be needed because the system was never opened - That's all there is to it...i hope this information is helpful & good luck with your bike.


11_23_2011_12_23_40_am.jpg

Posted on Nov 23, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What does the red and black wire go to coming off the voltage regulator on a suzuki intruder 1500


Hi, Dennis what you need is a wiring diagram that you can find in the back of your service manual if you can not find the first and best tool you ever bought for your Suzuki, despair not, for a mere zero $0 you can download another one.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
2002 Suzuki VL 1500 Intruder LC wiring diagram Google Search
Suzuki Motorcycle Wiring Diagrams
Suzuki VL1500 Service Manual
OEM parts for Suzuki
http://mybikemanuals.com/suzuki

Aug 25, 2017 | 2002 Suzuki VL 1500 Intruder LC

1 Answer

Are there any other fuzes on a2002 1500 suzuki intruder then the 30amp main if so where are they


Hi, Joseph tail light issues are relatively easy to diagnose and repair always check the tail light fuse first and make sure you have power on both sides of the fuse holder and the usual suspects are:
1. Tail light bulb element is broken.
2. Tail light bulb soldered contacts are extremely worn down.
3. Tail light bulb socket corroded.
4. Tail light bulb socket has no power and or ground.
5. Tail light wiring harness damaged from the rear tire.
6. Tail light rear fender wiring harness connector faulty due to corroded, broken, or loose pins/sockets.
For more information about your issue and valuable "FREE" downloads that you need please click on the links below. Good luck and have a nice day.
2002 1500 suzuki intruder fuse panel location Google Search
Fuse Box location
Fuses In Suzuki Intruder 1500 Lc
http://service.tanga-moteurs.ro/data/Suzuki_VL1500_Intruder_98_00_Service_Manual_BY_DEN.pdf

Apr 14, 2016 | 2002 Suzuki VL 1500 Intruder LC

1 Answer

1997 1400 Intruder. Why doesn't it crank or start?


Hi, Jesse the following applies to carbureted also fuel injected models and the usual suspects are:
1. Severely discharged or a damaged battery, should have 12.5 volts or better and be able to pass a load test if necessary.
2. Failed alternator/generator and or voltage regulator.
3. Loose or corroded battery terminals and or cables especially the "NEGATIVE" cable, look for loose, corroded, or broken connectors inside the cable harness at "BOTH" ends.
4. Failed main circuit breaker or ignition switch, check for loose connections and continuity.
5. Failed system and or ignition relay, check for continuity.
6. Failed ignition coil, ignition/electronic module.
7. Failed CKP, CPS, CMP, MAP, TPS, or BAS sensor, corroded, loose or broken wire connector pins/sockets.
8. Throttle cables and or idle speed improperly adjusted hot idle speed should be 950 RPM to 1000 RPM.
9. Air/fuel mixture ***** improperly adjusted.
10. Water or dirt in the fuel system, carburetor or filter.
11. Restricted, blocked or kinked fuel line.
12. Fuel tank empty.
13. Gas cap is not venting properly or fuel tank venting system blocked.
14. A failed fuel pump, pressure regulator and or fuel injectors.
15. Vacuum line from intake manifold to petcock broken, cracked, or not attached, carburetor vent line plugged.
16. Needle and seat stuck closed in the float bowl.
For more information about your issue and valuable "FREE" downloads that you need please click on the links below. Good luck and have a nice day.
motorcycle com
Suzuki Intruder 1500 Not Turning Over This might be why
2002 Suzuki Intruder 1500 won start
for the 1500 manual click on the tiny "download" word bottom left of the page it's free
VL 1500 INTRUDER 1998 00
https://www.tradebit.com/filedetail.php/9360741-1987-2003-suzuki-vs1400-intruder-service-manual-plus $10

Apr 02, 2016 | Suzuki Motorcycles

2 Answers

2002 Suzuki VL1500 Intruder lc fuel tank can i get a larger tank or an extra tank.


Never hear of an after market tank for the intruder, the tank is located under the seat and holds only 3 gallons. You can get aprox 120-130 miles on a tank full.

Jun 14, 2010 | 2002 Suzuki VL 1500 Intruder LC

1 Answer

My 2002 intruder is not charging the battery


check the fuse,if the fuse is good,check the terminals,make sure theres no loose connections.if its still not charging,check the diode,if its still not charging,your stator or your charging coil is busted.

May 29, 2010 | 2002 Suzuki VL 1500 Intruder LC

1 Answer

Suzuki intruder vs800gl Light problems


Have you check all the bulbs condition? Check your fuses and the blinker coil.

Mar 24, 2010 | 2002 Suzuki VL 1500 Intruder LC

Not finding what you are looking for?
2002 Suzuki VL 1500 Intruder LC Logo

Related Topics:

49 people viewed this question

Ask a Question

Usually answered in minutes!

Top Suzuki Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

Ed Nelson
Ed Nelson

Level 2 Expert

149 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...