Question about Honda Motorcycles

1 Answer

Honda cb650 blowing fourth fuse@ - Honda Motorcycles

Posted by Anonymous on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    One Above All:

    The expert with highest point at the last day of the past 12 weeks.

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

  • Honda Master
  • 47,160 Answers

Hi, Anonymous before diagnosing your blown fuse issue, check the bottom of your seat, if its metal and comes in close proximity to the positive battery post you need to take the necessary steps to ensure there is no contact (electrical tape, thick rubber insulation, hammer a dent in the seat bottom etc.) You are going to need a wiring diagram from your service manual, a test light, an ohmmeter and plenty of extra fuses.
If you turn on your ignition switch and immediately blow a fuse you have a hard/dead short and is usually easy to find. With a test light connected to the hot side of the blown fuse holder start stabbing the wire/s that leads away from the fuse holder and towards the ignition switch, you test light will illuminate validating the short. When the test light fails to illuminate you have passed the short and need to back up until the test light illuminates, then look in the immediate area for the short.
If you driving down the road for 30 minutes or 15 miles and blow a fuse you have soft/flying short and may take some time and patience to find.
If the main fuse/circuit breaker constantly blows/trips while riding you probably have a faulty battery terminal connection. Check battery terminals for damage or corrosion, check battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter if necessary. Any other fuses that constantly keep blowing while riding are usually caused by a loose or corroded ground wire in the circuit, which means you have to check, inspect, test each and everyone with an ohm meter set on a low ohm scale 100 ohms or less . Simply touch one lead to the ground source and the other lead to the battery negative terminal, a reading of zero indicates a clean solid ground. Any number reading or infinity indicates a poor ground and needs to be repaired. Poor or weak grounds require excessive additional amperage to complete the circuit which in turn blows the small amperage fuse.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
Blown Fuse
CB 650 Fuse blows when installing new solenoid
Honda 1998 CB600Fw Shop Manual
http://www.partsfish.com/page/oem-parts-for-honda
Honda cb650 Owner Manual

Posted on Oct 20, 2017

Ad

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

Ad
dmsr63
  • 2050 Answers

SOURCE: 81 honda cb650 custom. when my brakes get

Sound like your brake caliper for the front (I'm assuming that it's the front) is hanging up. They get corrosion and the caliper piston sticks. Have it rebuilt, or do it yourself. I take it off, and use compressed air at the hose connection to "blow" out the piston, with a piece of wood where the pads go to protect the piston from the blasting out. Be careful when doing this because it comes out like a shot!!! If it wont move, I have made a grease fitting fastener that threads in, and pumped grease into it to remove the piston, messy but safer. Clean up the piston and caliper real good and re-asemble. Use brake fluid to lube up the seal.

Posted on Jul 31, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to set cam chain tension on 1981 Honda CB650 C


Hi, Anonymous for this scenario you will need your service, parts fiche, and owners manual if you can't find the best tool you ever bought for your Honda, despair not, for a mere $20 you can download another one. For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
81 CB650 Cam chain adjustment problems
81 cb650 cam chain tensioner issue
HONDA CB 650F CBR 650FA BIKE 2014 WORKSHOP SERVICE MANUAL Download Manuals... $20
http://www.partsfish.com/page/oem-parts-for-honda
Honda CB650F Owner Manual

Jan 03, 2014 | Clymer Honda Cb650 Fours 19791982

1 Answer

1982 Honda CB650 Nighthawk cylinder head torque specs


Hi, Anonymous for this scenario you will need your service, parts fiche, and owners manual if you can't find the best tool you ever bought for your Honda, despair not, for a mere zero $0 you can download another one. For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
1982 Honda CB650 Nighthawk cylinder head torque specs Google Search
https://www.pnwriders.com/threads/83-nighthawk-550-650-torque-spec-on-cyl-head-cover.107047
https://www.scribd.com/doc/48739487/additif-1981
http://www.partsfish.com/page/oem-parts-for-honda
Honda CB650F Owner Manual

Aug 02, 2012 | Clymer Honda Cb650 Fours 19791982

1 Answer

1982 Honda Nighthawk 650 keeps blowing the main 30amp fuse


Hi, Searay185spo before diagnosing your blown fuse issue, check the bottom of your seat, if its metal and comes in close proximity to the positive battery post you need to take the necessary steps to ensure there is no contact (electrical tape, thick rubber insulation, hammer a dent in the seat bottom etc.) You are going to need a wiring diagram from your service manual, a test light, an ohmmeter and plenty of extra fuses.
If you turn on your ignition switch and immediately blow a fuse you have a hard/dead short and is usually easy to find. With a test light connected to the hot side of the blown fuse holder start stabbing the wire/s that leads away from the fuse holder and towards the ignition switch, you test light will illuminate validating the short. When the test light fails to illuminate you have passed the short and need to back up until the test light illuminates, then look in the immediate area for the short.
If you driving down the road for 30 minutes or 15 miles and blow a fuse you have soft/flying short and may take some time and patience to find.
If the main fuse/circuit breaker constantly blows/trips while riding you probably have a faulty battery terminal connection. Check battery terminals for damage or corrosion, check battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter if necessary. Any other fuses that constantly keep blowing while riding are usually caused by a loose or corroded ground wire in the circuit, which means you have to check, inspect, test each and everyone with an ohm meter set on a low ohm scale 100 ohms or less . Simply touch one lead to the ground source and the other lead to the battery negative terminal, a reading of zero indicates a clean solid ground. Any number reading or infinity indicates a poor ground and needs to be repaired. Poor or weak grounds require excessive additional amperage to complete the circuit which in turn blows the small amperage fuse.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
1982 Nighthawk CB650SC SOHC Electrical Problems Sugar Land TX
Keep blowing main fuse any ideas
Honda CB650 Manual
https://www.partsfish.com/page/oem-parts-for-honda
Honda CB650 Custom Owner Manual

May 11, 2012 | Honda Motorcycles

1 Answer

1983 Honda CB 650 Nighthawk firing order


Hi, Anonymous for this scenario you will need your service manual, parts fiche, and owners manual if you can't find the best tool you ever bought for your Honda, despair not, for a mere zero $0 you can download another one.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
1983 Honda CB650 Nighthawk firing order Google Search
http://hondacb650.com/viewtopic.php?t=2461
https://app.box.com/v/motorcyclemanuals/file/1090804675
https://www.partsfish.com/page/oem-parts-for-honda
Honda CB650 Custom Owner Manual

Apr 25, 2012 | Honda Motorcycles

1 Answer

Starter wining honda cb650.Replaced with new starter and still doing same thing.If bike is rocked back an forth in gear sometimes it will catch and start.


On the flywheel is a one-way clutch. It matches to a large starter gear that turns the motor over if the smooth surface on the large starter gear has become chattered/no longer smooth the you will need to replace it and the three rollers in the starter clutch to make the starter grab and turn over the motor. On the diagram you are looking at part numbers 28 and 15. http://www.bikebandit.com/houseofmotorcycles/1981-honda-cb650/o/m1975#sch31728

Aug 15, 2011 | 1981 Honda CBX

1 Answer

1982 Honda CB650 service manual


Hi, Jorgeisfesti the vast majority of service, parts fiche, and owners manuals on the internet are "FREE" to download and all service manuals contain wiring diagrams in the back pages. The rest usually charge a modest fee of $15 and there is a handful of obscure, rare, obsolete, and very old models that are no longer or never were available and some were never printed in English. The Indian and Philippine markets are usually in E-book format only, for these rare occasions I shall look on eBay and find the cheapest one available. Most of the manuals will cover your exact make, model, and year otherwise one will be provided that comes as close as possible to your bike and will have most of the same info that an exact manual would have. If there is no $ sign after the manual link it is free to download.
To download your manual for viewing or printing please click on the blue links below. Good luck and have a wonderful day
http://manuals.sohc4.net/cb650 free service manual
https://www.partsfish.com/page/oem-parts-for-honda
Honda CB650 Custom Owner Manual
Honda CB650SC Nighthawk
Honda CB650 Wikipedia

Jul 21, 2011 | Honda Motorcycles

1 Answer

I have a 1980 honda cb650 need to no torque specs on head bolts


6 mm bolt 2.0-2.4 kgf-m
8 mm bolt 2.6-3.0 kgf m

Mar 21, 2010 | 2005 Honda CB 750

1 Answer

81 honda cb650 custom. when my brakes get


Sound like your brake caliper for the front (I'm assuming that it's the front) is hanging up. They get corrosion and the caliper piston sticks. Have it rebuilt, or do it yourself. I take it off, and use compressed air at the hose connection to "blow" out the piston, with a piece of wood where the pads go to protect the piston from the blasting out. Be careful when doing this because it comes out like a shot!!! If it wont move, I have made a grease fitting fastener that threads in, and pumped grease into it to remove the piston, messy but safer. Clean up the piston and caliper real good and re-asemble. Use brake fluid to lube up the seal.

Jul 31, 2009 | 1996 kawasaki GPZ 500 S - GPX 500 R

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

39 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4724 Answers

yadayada
yadayada

Level 3 Expert

78238 Answers

bazzz7071
bazzz7071

Level 2 Expert

342 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...