Cars & Trucks Logo

Related Topics:

Anonymous Posted on Apr 25, 2013

229 need a picture of engine parts for a 1983 monte carlo

1 Answer

Jonah Oneal

Level 3:

An expert who has achieved level 3 by getting 1000 points

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

  • Chevrolet Master 14,092 Answers
  • Posted on Apr 25, 2013
Jonah Oneal
Chevrolet Master
Level 3:

An expert who has achieved level 3 by getting 1000 points

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Joined: Mar 17, 2009
Answers
14092
Questions
0
Helped
7235271
Points
44533

You can go online look for online engine diagrams to 229 V6 engine or look for online service manual or go to auto zone buy a haynes repair manual.

5 Related Answers

Healeyman

mike kirschbaum

  • 1198 Answers
  • Posted on May 03, 2009

SOURCE: i need a diagram for my 1980 chevy monte carlo

'80 Monte Carlo, a good ride. A Chilton's book is a good investment. It will show you wiring and vacuum hoses and how to do the brakes, etc.

Ad
ourhowse

Dar

  • 2007 Answers
  • Posted on Jun 10, 2009

SOURCE: belt diagram for a 2006 chevy monte carlo

There should be a decal on the bottom side of your hood, or somewhere in the engine compartment. If there isn't just put it on the crankshaft (bottom pulley) and go ribs to ribs, and flats to flats, and work your way around.

litoshop

Josue Almodovar

  • 298 Answers
  • Posted on Jul 28, 2009

SOURCE: 2002 chevy monte carlo won't start

this vehicle is equipped with a factory anti theft system if when you try to start the engine and the anti theft light is on then the starter won't start even if your check engine light is not on you would have to scan the body module to pin point the problem to see if it's the anti theft system or the starter, go to a auto parts store like auto zone or pep boys or western auto these store offer free scanning to there customers. if this information has been helpful please let use know good luck

Anonymous

  • 226 Answers
  • Posted on Feb 04, 2010

SOURCE: My 03 monte carlo is very sluggish. The engine

P0404 Exhaust Gas Recirculation Circuit Range/Performance
P0502 Vehicle Speed Sensor Low Input
P0440 Evaporative Emission Control System Malfunction
hope that helps /a little beyond my expertise but theres your codes your looking for ;)

Anonymous

  • 3533 Answers
  • Posted on Mar 27, 2010

SOURCE: Need a vacuum line diagram for a 1975 Monte Carlo

give these websites a try www.alldatadiy.com and www.autozone.com you can also stop by your local GM-dealership in the parts department and see if they can print you off the pictures & diagram you need if you are looking for another one give these guys a call they only sells GM-parts its Schram auto & truck parts 1-800-292-1032 and they website is www.schramauto.com and i alway look around for a good salvage yard near me give this website a try to find one close to you its www.junkyarddog.com wish you the best of luck Michigan Man.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Where is the egr valve located on my 2003 Monte Carlo

Without knowing the engine size. I will Guess: find a picture of the part first, then locate it on the INTAKE MANIFOLD. there are 3 valves there , so get a picture of the right one first.
0helpful
2answers

We have a 1996 3.1 monte carlo ls we need to replace the crankshaft senor but we cant find it on the motor is there a picture of where one could be

The crankshaft position sensor is a two pin sensor made up of plastic like material. It is located on the back side of the engine block about half way between the oil pan and the top of the block. It can only be accessed by crawling under the car. 33899bbd-15f1-451a-9a7a-a94f8be62e27.png
0helpful
1answer

1983 chevrolet monte carlo

make sure spark plugs and wires been replaced.replace distributor cap and rotor.replace fuel filter in the carburetor in let nut to fuel line.also check carburetor automatic choke plate make it closed during start up and open as engine warm up.but the choke need to closed when you first start engine up in the morning. i had same car years back you had to pump accelerator pedal twice then start engine. had be careful easy flood out carb engines.
3helpful
2answers

I have a 83 monte carlo and I pull my lights on knob and all my lights come on;tail, tag, park, markers, but not my headlights....my turn signal lever( to turn on my brights) if I pull it the normal...

Don't waste your time looking for a headlamp relay. You will not find one. 1983 Monte Carlo does not use a headlamp relay. Your problem is most likely a defective headlamp dimmer switch. It is located about halfway down the upper left side of the steering column. It is secured by the same screws that mount the ignition switch. It is activated by a metal rod that pushes down on it when you pull back on your turn signal lever. It looks like the picture below.

12_24_2011_3_54_53_pm.jpg
0helpful
1answer

1973 Chevy Monte Carlo Wiring Diagram

GO TO YOUR LOCAL AUTO ZONE OR ADVANCE AUTO PARTS. BUY A HAYENS BOOK FOR 73 MONTE. AND IT WILL HAVE YOUR WIRING DIAGRAM. IT WILL THAT AND A LOT MORE. I BUY ONE WITH EVERY CAR OR TRUCK I GET. AND IT WON'T EVEN COST YOU TWENTY DOLLARS. JAKE.B
0helpful
1answer

Need diagram for 1985 monte carlo 3.8L 229 v6

Need to know what type of diagram. Engine, interior, lighting, radio etc. ??????????? [email protected]
2helpful
2answers

Need a vacuum line diagram for a 1975 Monte Carlo

should be a sticker under the hood if not go to auto zone they own all data.if you can find someone who is compotent.and can use the all data.they can print you one for free.if the car still has the feed back carb,make sure the purge valves are good.or plug the bent tube going to carb with a valve cap in hose
1helpful
2answers

What is the firing order for a 1982 chevy 229 V-6 engine

Book said 1-2-3-4-5-6 (1-3-5 rt bank 2-4-6 lt bank)
0helpful
1answer

Need to remove window knob from 1979 monte carlo.

Getting to be an old vehicle now days. The mount that the window knob mounts on is usually a star type gear that the handle is pushed onto. There should be a very small hole in the round part of the handle that an allen set can slide into. Then loosened the hanle should pull off the star gear. Once the handle is removed the inside door panel should easily pull out over the gear.
1helpful
2answers
Not finding what you are looking for?

270 views

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

john h

Level 3 Expert

29494 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...