Question about 2003 Suzuki AN 400 Burgman

Open Question

How do i disassemble the seat damper? - 2003 Suzuki AN 400 Burgman

Posted by on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Hidden xtrail nu04yma I have code p 0089 fuel pressure regulator 1 showing what does it signify


Replace the damper.
This regulator is mounted on the underside of your fuel rail between your fuel injectors, to access this unit remove the bolts that secure your fuel rails to your engine and lift slowly.

There is a large circlip that secures the fuel damper to the underside of your fuel rail, undo this clip now and gently remove your damper.
Once you have the damper removed, install the new unit and make sure it's firmly seated before reinstalling your circlip.

Aug 20, 2017 | Cars & Trucks

1 Answer

How To Install Struts


1- remove the strut and spring assembly
2- compress the spring with special tool
3-remuve the damper shaft nut and change the new strut
4- install the damper and the nut remove the tool
disassembling a strut is dangerous be careful

May 02, 2013 | 2008 Toyota Prius

1 Answer

Is it necessary to completely dissassemble the fork system to change dampers in the uppers?


To change the damper tube in the upper forks take a complete disassembly to get to them.

Good Luck
Steve

Sep 09, 2010 | Harley Davidson FLTR-FLTRI Road Glide...

1 Answer

Burgman 400 - disassemble the driver's backrest


Place the butrest as much backwards as you can, i.e. as if for long legs riders.. if there is a bit of slack push it just a touch forwards until it clicks.. tiny bit. Now look for two tiny screws, philip ones, on each side of the little under seat light, its hard to see them you may have to disengage the damper.. which is probably on a springclip and tiny washer (dont drop it or loose it) the little screws are actually screwed into the metal of the extending poles so be carefull use the right size screwdriver..once you removed it the butrest should slide out.. they are tiny screws.. you can leave them out so you can clean your saddle all over.. its easier to remove it that way.

Jan 04, 2010 | 2003 Suzuki AN 400 Burgman

1 Answer

My LG refrigerator, Model #LFX25960SB is freezing everything, even though the temp setting is at 45 degrees. What is wrong?


Have you tried defrosting the whole refrigerator first? Ice buildup is a big cause for problems like this

Many would suggest if the temperature is too low and you can't make it warmer by adjusting the thermostat, you probably have a defective thermostat. Many times the problem is related to the air damper. This damper controls the amount of cold air that is sent to the refrigerator section. The parts of the damper are plastic and can break with age. The damper can also get blocked with ice or other objects, which will prevent it from closing properly. Check to make sure the control that operates the damper is set correctly and that the knob is not broken causing the damper not to operate. Sorry to say there is no button to press to correct the problem. The repair needed will require some disassemble of the refrigerator. If you are not comfortable doing this I would suggest a call to your local appliance repair store is in order. If you find that the damper is not broken or stuck open, then I would first try replacing the thermostat.

Let me know how this works out for you.


Benjamin

Dec 31, 2009 | LG Refrigerators

1 Answer

Sharp r-1874 - 59 sec


We have the service manual, and have uploaded it to our site here. It is only a supplemental type, so it does not show disassembly, but it has helpful info and part numbers

We have a handy disassembly video at http://www.microwavedisplay.com

This is a problem in one of the damper-related components, most likely the switch, but it may also be the motor or the damper door.

The damper is a door inside that opens or closes depending on cooking mode. If the controller senses that the door is not in the right position, it will shut down the cook cycle.

Sharp models stop after 59 seconds.

See the attached sample photo for a typical damper assembly.

The best place to order Sharp parts is Tritronics.

We're happy to help you and we'd appreciate your thoughtful rating of our answer.

39c888e.jpg

Jul 22, 2008 | Sharp R-1874 Convection/Microwave Oven

1 Answer

Sharp R1870


This is a problem in one of the damper-related components, most likely the switch, but it may also be the motor or the damper door.

The damper closes and opens depending on cooking mode. See the attached sample photo.

The damper is a door located on the right side of the innards. The damper closes and opens depending on cooking mode. See the attached sample photo.

If you or a friend decide to work on it, we have *critical* safety, disassembly, and troubleshooting info at our site, and our link is at our listing here on FixYa: http://tinyurl.com/yzjozk

You can find an exploded view by entering your FULL model number here: http://www3.sears.com (the 3 is correct)

You can order Sharp parts from that Sears link or from Tritronics at http://www.wehaveparts.com

We're happy to help and we appreciate your thoughtful rating of our answer.


b8a401a.jpg

Dec 27, 2007 | Sharp R-1871 Convection Microwave Oven

1 Answer

Timer


This is a problem in one of the damper-related components, most likely the switch, but it may also be the motor or the damper door.

The damper is a door located on the right side of the innards. The damper closes and opens depending on cooking mode. See the attached sample photo.

If you or a friend decide to work on it, we have *critical* safety, disassembly, and troubleshooting info at our site, which is linked at our listing here on FixYa: http://tinyurl.com/yzjozk

You can order Sharp parts from Tritronics at http://www.wehaveparts.com

For other brands, you can usually find helpful exploded view diagrams and order parts by entering your full model number here: http://tinyurl.com/gv383
a116a2f.jpg

Nov 27, 2007 | Microwave Ovens

1 Answer

Shuts off after 59 seconds


That would be a problem in the damper aseembly, either a bad switch or motor, or the damper door is jammed or blocked.

Consult the attached diagram for general reference.

The damper switch is the same as the primary interlock (door) switch.

If you or a friend decide to look into it, we have critical safety information, switches diagnosis and replacement, and disassembly information at our site, linked here on Fixya: http://tinyurl.com/yzjozk

a6579a0.jpg

Oct 24, 2007 | Sharp R-1874 Convection/Microwave Oven

Not finding what you are looking for?
2003 Suzuki AN 400 Burgman Logo

Related Topics:

45 people viewed this question

Ask a Question

Usually answered in minutes!

Top Suzuki Experts

yadayada
yadayada

Level 3 Expert

78919 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4818 Answers

Richard
Richard

Level 2 Expert

83 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...