Question about 2007 BMW R 1200 RT

2 Answers

I have a rattling sound from my burgman 400 k8. When i start the engine its nice and quite and when i ride below 4000rpm the engine is quite. But as the engine warms up and i get above 5000 there is a knocking or rattling sound coming from the engine. When i drop below 5000rpm the sound eases of. The engine sounds ok at stands till.I have taking it back to the dealier and he says that that the k8 engine is noiser then earlier models. I used to have a k5 burgman which did not sound like this. The bike has a 2 year warranty on and i have only done 1500 miles on it. The oil is ok.

Posted by on

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 3,567 Answers

Change out the gas to a higher octane and do not use gas with ethanol. This sounds like engine knock > translated; pre-ignition of the fuel in the cylinder. This is not a good thing to have. It is hard on the crank and even harder on the piston. If the problem does not go away after a tank or two ask the dealer to check the engine timing. Also check gearbox oil level. Low oil creates heat and heat promotes detonation aka pre-ignition.

Posted on Mar 12, 2009

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 6 Answers

I would try a fuel additive to clean the fuel system just in case as well as swapping for a higher octane fuel, plus I would buy a non supermarket brand... BP Shell etc. At 1500 miles I guess it’s not fully bedded in depending on riding style so there could be an issue with the newness of parts and the main agent should look into it if it’s a failing part, also being so new the engine will drink oil to some degree as it beds in, (BMW Boxer engines are also known for this).

Posted on Mar 03, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Burgman 400 2008. At light throttle openings say 1500 rpm. the revs rise and fall by 500 rpm continuously. This fault occurred after replacing the throttle sensor. Jill


Hi, Jill sounds like your new sensor (TPS) is slightly out of adjustment for this scenario you will need your service/owners manual if you can't find the first and best tool you ever bought for your Suzuki, despair not, for a mere zero $ you can download another one. For more information about your issue and valuable "FREE" downloads that you will need please click on the blue links below. Good luck and have a wonderful day.
http://burgmanusa.com/forums/14-burgman-400-pre-2007/26989-surging-slow-speed.html
http://burgmanusa.com/forums/15-burgman-650/38185-tps-adjustment.html
Suzuki AN400 Service Manual
OEM parts for Suzuki
Suzuki Burgman 400 2008

Mar 11, 2017 | 2008 Suzuki Burgman 400

1 Answer

I have 2012 Suzuki Burgman 650 scooter, how do I reset the clock and from kilos to miles


Hi, Jim for this scenario you will need your service/owners manual if you can't find the first and best tool you ever bought for your Suzuki, despair not, for a mere zero $ you can download another one. For more information about your issue and valuable "FREE" downloads that you will need please click on the links below. Good luck and have a nice day.
http://burgmanusa.com/forums/15-burgman-650/8849-mph-km-h-miles-kms.html
07 Suzuki Burgman 400 Set Time Clock
Suzuki AN650 Service Manual
OEM parts for Suzuki

Jan 06, 2017 | 2012 Suzuki Burgman 650 Executive

1 Answer

Intermittent problem to start all lights are on but bike won't start


Hi, Mary and the usual suspects are:
1. Ignition Switch not in the "ON" position.
2. Engine Run Switch in the "OFF" position.
3. Discharged battery, needs to be 12.5 volts or better and be able to pass a load test if necessary, check battery terminals for damage or corrosion, check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter if necessary.
4. Bank angle sensor tripped and ignition/light key switch not cycled to the "OFF" position and then back to the "ON" position.
5. Faulty starter button/switch.
6. Faulty jiffy stand or clutch pull in switch/sensor.
7. Security alarm needs a reset.
8. Starter control circuit, relay, or solenoid faulty.
9. Main fuse or circuit breaker may be blown or faulty.
10. Electric starter shaft pinion gear is not engaging or over-running starter clutch slipping.
For more information about your issue and valuable "FREE" downloads that you will need please click on the links below. Good luck and have nice a day.
http://burgmanusa.com/forums/15-burgman-650/46583-2003-650-won-t-start.html
http://burgmanriders.com/forums/showthread.php/6957-2003-burgman-400-won-t-start
07 Suzuki Burgman 400 Starter Switch Problem
http://www.motorscooterguide.net/Manuals/Suzuki_AN650_Service_Manual.pdf

Apr 07, 2016 | 2006 Suzuki Burgman 650

1 Answer

How to install a fuel pump for a 2008 Suzuki burgman 400


Hi, Louis sorry you can't find the first and best tool you ever bought for your Suzuki despair, not for a mere $10 you can download another one. For more information about your issue and valuable "FREE" downloads that you will need please visit the websites below. Good luck and have a nice day.
http://burgmanusa.com/forums/14-burgman-400-pre-2007/27300-burgman-400-fuel-pump-problem.html
http://www.airgad.gr/Suzuki-Burgman-AN400-Service-Manual-Eng.pdf
OEM parts for Suzuki
Suzuki Burgman 400 2007

Mar 21, 2016 | 2008 Suzuki Burgman 400

1 Answer

Locatio fuse box burgman an 400


For the K8

The fuse box is under the cover just below the instrument panel on the left hand side. So you need to yank that off first its retained by 4 clip n fit rubber buttons. do side by side.

Oct 04, 2009 | 2003 Suzuki AN 400 Burgman

1 Answer

How to replace brake light bulb on burgman 400


On the earlier models there are two self tapping screws with x heads on the underside lip of the rear section you undo these and the rear panel lifts up and out on 2 plastic hooks built into the panel. (it feels like its not going to come off at times) you can then get to the bulbs I would replace both at the same time as the other one will go in a short time as the odds are they were fitted at the same time in the first place.

Sep 24, 2009 | 2003 Suzuki AN 400 Burgman

Not finding what you are looking for?
2007 BMW R 1200 RT Logo

475 people viewed this question

Ask a Question

Usually answered in minutes!

Top BMW Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

yadayada
yadayada

Level 3 Expert

74311 Answers

phil cuzins
phil cuzins

Level 2 Expert

79 Answers

Are you a BMW Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...