Question about 2011 Suzuki Boulevard M109R Limited Edition

Open Question

Suzuki m109 exhaust valve clicking

When I go to start bike turn on just before it starts a click noise

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 5 Answers

SOURCE: suzuki 1500 backfires when decellerating. any

I had the same problem and i cleaned out the P.A.I.R valve and now the problen is solved. Also tighten up the reeds in it

Posted on Jun 17, 2009

  • 1 Answer

SOURCE: HIT THE START BUTTON AND HEAR A CLICK AND NOTHING HAPPENS

dont know if you got the answer from someone who knows what the hell they are talking about cause obviously these idiots never owned a 96 s-rad. the problem is that your engine is loading up with fuel and basically vapor locking the engine witch you could also call severely flooding it. you have a carb problem as do i and if a real mechanic comes on and reads our problem please let us know how to solve... thank you

Posted on Jan 05, 2010

  • 32 Answers

SOURCE: How do i set the exhaust valves? rm 125

buy a manual

Posted on Mar 27, 2010

  • 149 Answers

SOURCE: '06 Suzuki Eiger ATV will not start. When pushing the

Try shorting out the 2 10mm nuts on the starter relay (has the lead from the battery and starter going to it) if the the engine turns over chech the relay or safety switches. It will flash so make sure the is no open fuel. If nothing happens try tapping the starter motor l(lightly) then try it. If this works the brushes in the starter are worn out..Dont keep on doing it as you will burn the comutator in the starter..Brushes are cheap.

Posted on Jul 03, 2010

  • 1 Answer

SOURCE: suzuki 1400 intruder wont start.. just clicking noise.

2001 Intruder electric starter does nothing. All other electrical is fine... The lights are on, horn works, all lights; but starter doesn't respond.

Posted on May 11, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where i can find elecrical wiring diagram


When you try to start the bike, does anything happen? Noises? Clicks? Or is it silent and nothing happens? If you hear a click or it try's to start but doesn't turn over. If nothing at all happens when you hit the start switch then you most likely have an electrical issue, versus if you hear the starter click or try to start to bike, then that would mean a mechanical issue.

May 14, 2014 | 2008 Peugeot Geopolis 400

1 Answer

Why wont my 2001 fxdwg wont turn over with good battery ?


When you try to start the bike, does anything happen? Noises? Clicks? Or is it silent and nothing happens? If you hear a click or it try's to start but doesn't turn over. If nothing at all happens when you hit the start switch then you most likely have an electrical issue, versus if you hear the starter click or try to start to bike, then that would mean a mechanical issue.

May 14, 2014 | 2003 Harley Davidson FXDWG Dyna Wide Glide

1 Answer

Bike not starting


IS THE STARTER TURNING OVER FAST ENOUGH, DOES YOUR BATTERY HAVE A GOOD CHARGE, DO YOU GOOD FUEL

Jun 05, 2013 | Suzuki GZ 125 Marauder Motorcycles

1 Answer

Bike won't start, new Harley battery, and starter bike 2006 FLHX Street Glide, all I get is a clicking noise from solenoid under seat


I'm not too familiar with the later model bikes but if I were getting a clicking noise under the seat and the bike was not starting, I'd investigate the source of the noise. It's possible that it is a starter relay that engages the solenoid that is an integral part of the starter. Look at the starter from the right hand side of your bike. You'll see a single small wire that connects to the end of the starter just above the end plate of the solenoid. Disconnect this wire and connect a test light or volt meter to the wire. Turn on your ignition switch and press the start button. You should hear the click under the seat and see voltage at the end of that wire. If not, replace the relay, a plastic cube about an inch in dimension.

Good Luck
Steve

Jul 02, 2011 | Harley Davidson Storm 50 Motorcycles

1 Answer

I turn ignition on lights and dash light up ,then press start button and only get a clicking noise ,the bike will not turn over.


Your batter is weak or defective. Try charging the battery with a small (1-2 Amp) battery charger overnight, or using jumper cables connect another 12 V battery and try starting the bike.

Oct 23, 2010 | BMW R 1200 GS Adventure Motorcycles

1 Answer

My 2002 kawasaki ninja 250 is having trouble starting. (electric start) At first it was just giving me this clicking sound kinda like when your car wont turn over and start. So I replaced the battery for...


The oil light is on because the engine isn't running to build any oil pressure. Sounds like the new battery may need to be charged fully. After the battery is fully charged, and the 'clicking' noise is back (or not) check the battery connections for corrosion--especially at the positive terminal. If ok, you should get one solid click when trying to start. If ok, but still not starting, jump the two heavy terminals of the solenoid (click source) with a heavy wire which should bump the starter motor. If nothing, then the starter motor needs service--usually the brushes inside fail to make contact with the armature due to brush wear, or weak springs. Most dealers will likely only sell you a new starter--no internal parts. Hope this helps!

Oct 04, 2010 | kawasaki Ninja 250R Motorcycles

1 Answer

My bike just makes a clicking sound when the start button is push


if it just clicks, firstly hook up jumper cables to battery, if it still just clicks, it will need starter motor brushes.

Feb 11, 2009 | 1995 Yamaha XJ 600 Diversion S-N

2 Answers

Bike wont start


What is it doing exactly, any clicking, buzzing, any noise at all, or nothing, no sounds at all? Especially in the starter area.

Aug 13, 2008 | Harley Davidson Harley-Davidson Motorcycle...

Not finding what you are looking for?
2011 Suzuki Boulevard M109R Limited Edition Logo

Related Topics:

116 people viewed this question

Ask a Question

Usually answered in minutes!

Top Suzuki Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

Ed Nelson
Ed Nelson

Level 2 Expert

149 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...