Question about Suzuki VS 800 Intruder Motorcycles

1 Answer

1993 intruder 800 will not idle down, carbs have been cleaned and parts replaced

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    MVP:

    An expert that got 5 achievements.

    Greenhorn:

    A rookie expert who has answered 20 questions on their first day.

    Cheetah:

    An expert who has answered 20 or more questions within one hour.

  • Contributor
  • 41 Answers

Air leak

Posted on Jul 04, 2013

  • Richard Ahrens Oct 08, 2013

    OR-THROTTLE CABLE IMPROPERLY ROUTED-SEE IF IDLE CHANGES WHEN IN NEUTRAL&YOU TURN THE WHEEL BACK&FORTH

×

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

SOURCE: 1993 Suzuki Intruder 800

Sounds like clutch slipping.. you may have to replace the clutch plates.

Posted on Jun 17, 2009

  • 4339 Answers

SOURCE: I have gas dripping from the outside of my carb .

REmove and rebuild the carb, something is wrong and you risk fire or explosion.

Posted on Apr 05, 2011

SOURCE: 2003 WR250 F - eng. won't idle down and carb starts to overflow

Hi Jwelden,
Have you checked the float level in the float chamber?
I guess you may have to reset the float pin adjustment, its allowing more gas to pass through thn required and thus the overflow!
Not bad too, when you are working on the float assembly take the opportunity to blow out the fuel line from petcock to the carburator via the seat for the float pin,any foreign particals there would stop the float pin to seal up and thus overflow.
Fit in an inline fuel filter , this will help keep out the dirt or whatever.
Hope this helps.

Knight (Yamaha Seca XJ750A 1981)


Posted on Feb 13, 2009

  • 3567 Answers

SOURCE: how to change jets in carb

Just unscrew the old jet and screw the new one in. The diagram below is the carb you have.

A “very helpful” rating on this answer? Thanks!


49afd8b.gif

Posted on Jul 03, 2009

slave2aslave
  • 302 Answers

SOURCE: Have 96 suzuki intruder 800. Has been sitting for

I would try checking the rubber between the carb and motor for air leaks,and/or spray carb cleaner through while running with the air box open.
Hope this helps.

Posted on Oct 06, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2001 Suzuki VS 800 Intruder hesitates 50-55 MPH


Hi, Robert and the usual suspects are:
1. Installation of a different camshaft.
2. Different exhaust system or "STRAIGHT PIPES"
3. Faulty advance curve.
4. Multiple carburetors not in sync.
5. Improperly installed jet kit or wrong kit.
6. Carburetor internal malfunction.
7. Fuel mixture too rich.
8. Fuel mixture too lean.
9. Extremely dirty air filter.
For more information about your issue and valuable "FREE" downloads that you will need please click on the blue links below. Good luck and have a wonderful day.
low rpm hesitation sputtering
Backfiring hesitating in 03 Intruder 800
Suzuki VS700 Service Manual
OEM parts for Suzuki
Suzuki VL800 Owner Manual

Jul 12, 2017 | 2001 Suzuki VS 800 Intruder

1 Answer

How do i find starter solenoid on 04 intruder 800?


Hi, Paul the answer to this question is way above my pay grade for this situation, I would call or visit my local dealer or reputable shop's service/parts department and inquire about any possible quick fix, answers, or parts inquiry.
For more information about your issue and valuable "FREE" downloads that you will need please click on the blue links below. Good luck and have a wonderful day.
Amazon com Starter Solenoid Relay Suzuki VS 800 GL VS800GL Intruder 1993...
Motorcycle Starter Motors Relays for Suzuki Intruder 800 eBay
Suzuki VS700 Service Manual and 800
OEM parts for Suzuki
Suzuki VL800 Owner Manual

May 15, 2017 | 2004 Suzuki Intruder 800

1 Answer

Front cylinder drops out when taking off


Most likely a carb synchronaztion or improper throttle cable arrangement problem. This is a very complex procedure and should be performed by someone with experience in this task.I am assuming that the bike has not sat up for a long period of time, as you say it idles fine which would indicate no clogged slow jets in carbs.

Oct 16, 2014 | 1993 Suzuki VS 800 Intruder

1 Answer

Won't Idle at stop signs.


could be as simple as idle speed adjustment. screw located on r/h side near rear carb. almost directly behind ignition switch but on opposite side of bike. If bike has had a history of sitting up however it may need a proper carb/ fuel system cleaning and synchronization to perform correctly.

May 23, 2013 | 1993 Suzuki VS 1400 Intruder

1 Answer

My bike is bogging down, drowning plugg in fuel, white smoke & strong smell of fuil from rear cylinder, what could be the problem?


Sounds like the float is sticking in the carb on the rear cylinder,washing the cylinder with fuel,and possibly going into the crankcase oil. The carbs will need to be removed,cleaned,set-up,and synchronized.Be sure to change your oil as well. The gas has most likely mixed with the engine oil,and will cause you to spin a bearing or worse.
Good Luck!

Oct 04, 2012 | 1993 Suzuki VS 800 Intruder

1 Answer

My 1993 Suzuki Intruder VS800 is leaking gas. We have changed carb floats and cables. What is next?


Hi,,check your float level,,as you have changed the floats the level will need adjusting,,

Aug 03, 2011 | 1993 Suzuki VS 800 Intruder

1 Answer

Have 96 suzuki intruder 800. Has been sitting for three years, the carbs were lacquered pretty bad, especially the back carb. cleaned them both. bike runs, but the back carb/cylinder acting rough.what...


I would try checking the rubber between the carb and motor for air leaks,and/or spray carb cleaner through while running with the air box open.
Hope this helps.

Oct 06, 2009 | 1995 Suzuki VS 800 Intruder

1 Answer

Suzuki vs800 intruder dies after about a mile!


Sounds like water in the gas. ALWAYS have a fire extinguisher on hand when working on carburetors.
For each carb > Drain the carburetor. There should be a screw on the lower side or bottom of the carb float bowl. Remove the screw then replace it after the fuel drains. Turn the gas back on and wait a minute for the carb to fill with gas. If the bike doesn't start and run properly then shut off the gas and remove the carburetor from the engine.

Remove the float bowl and clean the entire carb with a spray carb cleaner from the auto parts store. Wear protective goggles to avoid getting spray in your eyes. Spray into all the little airways and fittings in the carb.
Put the carb back together, clean the air filter and install the carb. Let the float bowl fill then start the engine. This process should get you back on the road.

Please rate this solution. Thanks!

Jun 11, 2009 | 1995 Suzuki VS 800 Intruder

2 Answers

Only idles with choke out


you have a dirty carburetor/carburetors. a good old fashioned carb cleaning will fix it up. here is a temporary fix that will get you going again. screw your idle mixture needles in ( counting the turns ) THEN SCREW THEM BACK OUT THE SAME NUMBER OF TURNS.

Mar 16, 2009 | 2002 Suzuki VS 800 Intruder

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

182 people viewed this question

Ask a Question

Usually answered in minutes!

Top Suzuki Experts

yadayada
yadayada

Level 3 Expert

76070 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4521 Answers

Richard
Richard

Level 2 Expert

83 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...