Question about 2001 Yamaha V Star 1100 Classic

1 Answer

Magtag Electric Dryer

Went to check my cloths and they were still wet. Dryer was off and HOT!! now it won't turn on and the light that comes on inside is also out. I check the link trap and outside vents and they are fine. Thanks for any help!! Sonia I have a Maytag dryer model mde508dayw. We dried several loads one morning and it was working fine. The same afternoon went to turn the dryer on and it will not come on. Ther is power to the dryer because the light comes on. Could be a switch where do i start

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 99 Answers

Did you check the breaker closely. Dryers work on 220 volts, usually 30 amps and that means TWO 110 breakers attached together must be good and putting out 110 volts each. One may be burnt or disabeled and the other working. Also check at the  dryer receptacle and make sure you have 220 or more volts.

Posted on Mar 13, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I trouble shoot an engine that won't start?


Hi, Frank and the usual suspects are:
1. Ignition Switch not in the "ON" position.
2. Engine Run Switch in the "OFF" position.
3. Discharged battery, check battery terminals for damage or corrosion, check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter if necessary.
4. Bank angle sensor tripped and ignition/light key switch not cycled to the "OFF" position and then back to the "ON" position.
5. Faulty starter button/switch.
6. Faulty jiffy stand or clutch pull in switch/sensor.
7. Security alarm needs a reset.
8. Starter control circuit, relay, or solenoid faulty.
9. Electric starter shaft pinion gear is not engaging or over-running starter clutch slipping. Good luck and have nice a day.
Steps to Take When Your Motorcycle Won Start Dennis Kirk Powersports Blog
What to do When Your Motorcycle Won Start
Troubleshooting No Start Honda Motorcycle
Motorcycle Won Turn On Solved

Mar 06, 2016 | Motorcycles

1 Answer

My bike wont turn over.. can anyone help??


Hi, Ashley and the usual suspects are:
1. Ignition Switch not in the "ON" position.
2. Engine Run Switch in the "OFF" position.
3. Discharged battery, check battery terminals for damage or corrosion, check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter if necessary.
4. Bank angle sensor tripped and ignition/light key switch not cycled to the "OFF" position and then back to the "ON" position.
5. Security alarm needs a reset.
6. Starter control circuit, relay, or solenoid faulty.
7. Faulty starter button.
8. Electric starter shaft pinion gear is not engaging or over-running starter clutch slipping.
For more information about your issue, please visit the websites below. Good luck and have nice a day.
Please Help My 02 vstar 1100 classic won start
Re My Yahama Star 1100 wont start Road Star Forum Yamaha Road Star
http://www.sloneservices.com/SilverBack/Other-Stuff/V-StarShopManual99-07.pdf
http://www.starmotorcycles.com/assets/service/manuals/2000/LIT-11626-13-36_96.pdf

Dec 30, 2015 | Yamaha Motorcycles

1 Answer

My odometer was flashing when I stopped when I continue down road it went blank cut bike off try to start back it killed battery couldn't even charge it


Hi, Wesley and the usual suspects are:
1. Ignition Switch not in the "ON" position.
2. Engine Run Switch in the "OFF" position.
3. Discharged battery, check battery terminals for damage or corrosion, check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter if necessary.
4. Bank angle sensor tripped and ignition/light key switch not cycled to the "OFF" position and then back to the "ON" position.
5. Faulty starter button/switch.
6. Faulty jiffy stand or clutch pull in switch/sensor.
7. Security alarm needs a reset.
8. Starter control circuit, relay, or solenoid faulty.
9. Electric starter shaft pinion gear is not engaging or over-running starter clutch slipping.
For more information about your issue and valuable free downloads that you will need please visit the websites below. Good luck and have nice a day.
What to do When Your Motorcycle Won Start
Steps to Take When Your Motorcycle Won Start Dennis Kirk Powersports Blog
TROUBLE SHOOTING
What Do Check When My Motorcycle Won Start Honda Shadow Forums Shadow...

Jul 05, 2015 | Road Motorcycles

1 Answer

Yamaha vino125 will kick start but electric start doesn't work. when you turn key on lights do not come on. battery is good


Hi, Anonymous and the usual suspects are:
1. Ignition Switch not in the "ON" position.
2. Engine Run Switch in the "OFF" position.
3. Discharged battery, needs to be 12.5 volts or better and be able to pass a load test if necessary.
4. Check the battery terminals for damage or corrosion check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter if necessary.
5. Tip over sensor needs a reset.
6. Faulty ignition switch.
7. Faulty starter button.
8. Faulty kickstand or clutch pull in switch/sensor.
9. Starter control circuit, relay, or solenoid faulty.
10. Main fuse or circuit breaker may be blown or faulty.
11. Check for engine trouble codes.
For more information about your issue and valuable "FREE" downloads that you will need please click on the links below. Good luck and have nice a day.
2006 08 Yamaha Vino 125cc Won start Seat Latch Scooter Doc Forum
Scooter won start
Yamaha XC125 Service Manual
OEM parts for Yamaha
Yamaha Cygnus XC125 Owner Manual

Sep 23, 2013 | 2005 Yamaha Vino 125

1 Answer

When I try to start my spyder sts-se5 I turn the switch and nothing happening, its as if their is no power, no light or nothing. Can you help?


Hi, Sarah and the usual suspects are:
1. Ignition Switch not in the "ON" position.
2. Engine Run Switch in the "OFF" position.
3. Discharged battery, check battery terminals for damage or corrosion, check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter if necessary.
4. Bank angle sensor tripped and ignition/light key switch not cycled to the "OFF" position and then back to the "ON" position.
5. Faulty starter button/switch.
6. Faulty jiffy stand or clutch pull in switch/sensor.
7. Security alarm needs a reset.
8. Starter control circuit, relay, or solenoid faulty.
9. Electric starter shaft pinion gear is not engaging or over-running starter clutch slipping.
For more information about your issue and downloads that you will need please visit the websites below. Good luck and have nice a day.
Spyder won start Can Am Spyder Forums The factor Community
Thread Won Start won turn over
2014 CanAm Spyder RT Series Repair Maintenance Parts Master Collection...
Can Am OEM Parts
http://www.spyderlovers.com/RT/NEW2010RT.pdf

Sep 15, 2013 | CanAm Motorcycles

1 Answer

Fzr 1000


Hi, Andre you may have a faulty starter button and the usual suspects are:
1. Ignition Switch not in the "ON" position.
2. Engine Run Switch in the "OFF" position.
3. Discharged battery, check battery terminals for damage or corrosion, check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter if necessary.
4. Bank angle sensor tripped and ignition/light key switch not cycled to the "OFF" position and then back to the "ON" position.
5. Faulty starter button/switch.
6. Faulty jiffy stand or clutch pull in switch/sensor.
7. Security alarm needs a reset.
8. Starter control circuit, relay, or solenoid faulty.
9. Electric starter shaft pinion gear is not engaging or over-running starter clutch slipping.
For more information about your issue and valuable "FREE" downloads that you will need please visit the websites below. Good luck and have nice a day.
FZR Won Start The FZR Forum
troubleshoot motorcycle not starting
https://www.tradebit.com/filedetail.php/243740163-1989-1995-yamaha-fzr-1000-genesis-exup-fzr1000
OEM parts for Yamaha
http://mybikemanuals.com/yamaha/yamaha-fz-owners-manuals

Sep 07, 2012 | 1989 Yamaha FZR 1000

1 Answer

Won't start


Hi, Cliff and the usual suspects are:
1. Ignition Switch not in the "ON" position.
2. Engine Run Switch in the "OFF" position.
3. Discharged battery, check battery terminals for damage or corrosion, check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter if necessary.
4. Bank angle sensor tripped and ignition/light key switch not cycled to the "OFF" position and then back to the "ON" position.
5. Security alarm needs a reset.
6. Starter control circuit, relay, or solenoid faulty.
7. Faulty starter button.
8. Electric starter shaft pinion gear is not engaging or over-running starter clutch slipping.
For more information about your issue, please visit the websites below. Good luck and have nice a day.
AJP motorcycle manuals

May 09, 2012 | AJP Motorcycles

1 Answer

I ahve a 2002 BMW F650GS - a couple of months ago it cut out for no reason. Then a few weeks later when I used the heated handgrips it 'died' again. I turned it off compeltely then restarted and it went...


Hi, Barbaraten13 and the usual suspects are:
1. Ignition Switch not in the "ON" position.
2. Engine Run Switch in the "OFF" position.
3. Discharged battery, check battery terminals for damage or corrosion, check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter if necessary.
4. Bank angle sensor tripped and ignition/light key switch not cycled to the "OFF" position and then back to the "ON" position.
5. Security alarm needs a reset.
6. Starter control circuit, relay, or solenoid faulty.
7. Faulty starter button.
8. Electric starter shaft pinion gear is not engaging or over-running starter clutch slipping.
For more information about your issue, please visit the websites below. Good luck and have nice a day.
Thread 2001 F650GS won start please help
F650 Community
2001 2005 BMW F650CS Service Manual Moto Data Project
BMW Motorcycle Parts Fiche OEM BMW Motorcycle Parts online 1970 present BMW
Free Rider Manual Download BMW F650GS Twin

May 04, 2011 | 2001 BMW F 650 GS

1 Answer

It is running rough like it's only running on one cyclinder or boggeed down 2007 suzuki m 109


Easiest way to check it is firing on all cylinders is the check the exhaust down-pipes they should all be HOT! (Takecare when testing if you do not have an infared thermometer, a wet cloth dabbed on the downpipe should due the trick. It should dry very quickly if working and stay wet longer if not working). If everything if fine with the downpipes, next thing to check is that all carbs are getting fuel. Check this out first, then come back to me if all is ok.

Apr 01, 2010 | 2007 Suzuki Boulevard

1 Answer

After riding my turns signals ,head n tail lights


Sounds like the battery is shorted. Heat is one of the worst enemies of any battery. On a Softail it's almost in an oven. The day was hot so the engine oil was hot as well. Since the battery sits inside the "horseshoe" oil tank, it is surrounded by hot oil trying to get rid of the heat.

Take your battery to the nearest auto parts house and have it tested. Usually this is a free service.

Oct 09, 2009 | 2000 Harley Davidson FLSTC Heritage...

Not finding what you are looking for?
2001 Yamaha V Star 1100 Classic Logo

147 people viewed this question

Ask a Question

Usually answered in minutes!

Top Yamaha Experts

D. E. Hev

Level 3 Expert

1132 Answers

puggy666

Level 1 Expert

47 Answers

dhnguyen

Level 2 Expert

231 Answers

Are you a Yamaha Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...