Question about kawasaki Motorcycles

Open Question

Exmark lazer z kawasaki motor surges and drags

The mower constantly surges and drags while trying to mow

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 413 Answers

SOURCE: engine on riding lawn mower surging

Dirty air cleaner.

Clogged fuel filter.

Replace or clean both...

Posted on May 29, 2009

  • 396 Answers

SOURCE: engine speed surges

Surging engines in lawn mowers are usually related to a lean fuel/air mixture. With today's environmental concerns, the carburetors on these engines are set with a very lean mixture (to reduce air pollution). Furthermore, they usually put limiter caps on the carburetors where you cannot easily adjust the mix to get the engine to run better.

If there are adjustment screws on the carburetor, try turning the high speed adjustment screw a bit counter-clockwise (if the limiter cap will allow it). This will enrich the fuel/air mix a bit and might help the engine run a bit better.

Posted on Oct 11, 2009

Testimonial: "Thanks, I think I can figure out which is the High speed jet, it's the other one besides the one that restricts the throttle from going below a level."

mickey813
  • 472 Answers

SOURCE: kawasaki 21 hp motor periodically misfires

SOUNDS LIKE THE COIL IS BFAKING DOWN

Posted on Oct 30, 2009

SOURCE: 09 JD X 340 27hp Kawasaki eng\ surges

Hi
That is a fuel problem caused by stale gas you will need to remove and clean the carb with carb cleaner.
Sam

Posted on Jan 08, 2010

Testimonial: "thanks"

  • 673 Answers

SOURCE: 44" Exmark lazer z pto/blade problem

My problem is that I don't know what your problem is exactly.

Posted on May 06, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Removal of hydraulic axle exmark lazer z zero turn


I can help you, but I don't know what you're asking. I have an extensive knowledge of Exmark mowers.

May 28, 2016 | Garden

1 Answer

Exmark lazer HP 19 Kawasaki 50" deck new PTO and new relays blades engage for 30 minutes then shut off engine on. After cooling will engage for 10 minutes then shut off


Engine valves need adjusting.
symptoms: starts ok, runs until engine reaches max temp loses power then stops. can't restart when hot. once restarted runs for a while stops again.

There is very little clerance in these valves and temperature alters the lenth by a few thou and the valve don't close fully losing compression, once cold the valves shrink back enough to create enough compression to start again.

Aug 13, 2015 | kawasaki Garden

1 Answer

Why does 23 hp. Kawasaki exmark mower fuel foul 1 spark plug after you mow a hour


have you tried a different spark plug? if not that then check the ignition coil supplying spark to the plug thats fouling

Jun 25, 2014 | kawasaki Fh680vgs24 23hp 23 Hp Lawn Mower...

1 Answer

Can't get exmark mower with Kawasaki motor to start


Have had this problem with the Kawasaki engines and found the starter to be bad. The old starter was turning it over but was not fast enough to start. Have also found weak battery that did the same. The first one I ran into was a FH680 Kawasaki and spent about 2 hours trying to figure it out and it came down to the starter not turning it fast enough. Put a new starter on and started at just the bump of the switch. Let me know if this helps you out

Apr 26, 2014 | Garden

1 Answer

Exmark 44


When you say 'going forwaed', is that while mowing or does it do it without the blades engaged or 'not mowing'?

Jun 13, 2013 | Kohler Engines NEW 25HP KOHLER ENGINE...

1 Answer

I have a exmark 23 hp 680 volt kawasawkinengine and it clicks but will not start


if electric start could be the starter solenoid or flat battery try jump start maybe first

Apr 10, 2013 | kawasaki Fh680vgs24 23hp 23 Hp Lawn Mower...

1 Answer

44" Exmark lazer z pto/blade problem


My problem is that I don't know what your problem is exactly.

May 06, 2012 | Oregon Scientific Electric PTO Clutch for...

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

47 people viewed this question

Ask a Question

Usually answered in minutes!

Top kawasaki Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

yadayada
yadayada

Level 3 Expert

75197 Answers

Gino Cussen
Gino Cussen

Level 2 Expert

216 Answers

Are you a kawasaki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...